Seismic moment and rupture length can be combined to infer stress drop, a key parameter for assessing earthquakes. In natural earthquakes, stress drops are largely depth‐independent, which is surprising given the expected dependence of frictional stress on normal stresses and hence overburden. We have developed a transparent experimental fault that allows direct observation of thousands of slip events, with ruptures that are fully contained within the fault. Surprisingly, the observed stress drops are largely independent of both the magnitude of normal stress and its heterogeneity, capturing the independence seen in nature. However, we observe larger, normal stress‐dependent stress drops when the fault area is reduced, which allows slip events to frequently reach the edge of the interface. We conclude that confined ruptures have normal stress independent stress drops, and thus the depth‐independent stress drops of tectonic earthquakes may be a consequence of their confined nature.
- PAR ID:
- 10033859
- Publisher / Repository:
- DOI PREFIX: 10.1029
- Date Published:
- Journal Name:
- Journal of Geophysical Research: Solid Earth
- Volume:
- 122
- Issue:
- 5
- ISSN:
- 2169-9313
- Page Range / eLocation ID:
- 3813 to 3834
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
more » « less
Abstract -
Megathrust earthquakes release and transfer stress that has accumulated over hundreds of years, leading to large aftershocks that can be highly destructive. Understanding the spatiotemporal pattern of megathrust aftershocks is key to mitigating the seismic hazard. However, conflicting observations show aftershocks concentrated either along the rupture surface itself, along its periphery or well beyond it, and they can persist for a few years to decades. Here we present aftershock data following the four largest megathrust earthquakes since 1960, focusing on the change in seismicity rate following the best-recorded 2011 Tohoku earthquake, which shows an initially high aftershock rate on the rupture surface that quickly shuts down, while a zone up to ten times larger forms a ring of enhanced seismicity around it. We find that the aftershock pattern of Tohoku and the three other megathrusts can be explained by rate and state Coulomb stress transfer. We suggest that the shutdown in seismicity in the rupture zone may persist for centuries, leaving seismicity gaps that can be used to identify prehistoric megathrust events. In contrast, the seismicity of the surrounding area decays over 4-6 decades, increasing the seismic hazard after a megathrust earthquake.more » « less
-
more » « less
Abstract We compare source parameter estimates for earthquakes in the 2011 Prague Mw 5.7, Oklahoma, sequence to investigate random uncertainty and systematic bias, and resolve reliable relative variations in stress drop. Source parameters provide insight into the earthquake rupture processes but large variations between studies occur. The Prague earthquake sequence is a prime example of this, with different studies reaching contrasting interpretations of the effects of injection on source parameters. We examine the Prague earthquake sequence using a single coherent catalog for all the events detected by the Oklahoma Geological Survey (OGS) and McMahon et al. (2017). We use three principal approaches to estimate stress drop in order to understand the biases of each: a spectral decomposition method based on stacking, individual event spectral modeling, and a spectral ratio method based on highly correlated events. We also compare our results with previous studies for the Prague sequences aftershocks, as well as past results for the Mw 4.8 foreshock and Mw 4.8 aftershock and Mw 5.7 mainshock. The absolute values of stress drop vary significantly between methods, but the relative patterns remain consistent, except when low quality or low bandwidth data are included. The consistent relative patterns reveal that the stress drops of aftershocks are dependent on the fault orientation and the proximity of the events to the mainshocks slip. These results indicate that fault structure as well as past events play an important role in stress drop patterns.
-
more » « less
Abstract The interaction of aseismic and seismic slip before and after an earthquake is fundamental for both earthquake nucleation and postseismic stress relaxation. However, it can be difficult to determine where and when aseismic slip occurs within the seismogenic zone because geodetic techniques are limited to detecting moderate to large slip amplitudes or long duration small slip amplitudes. Here, we use repeating earthquakes (earthquakes that re‐rupture the same fault patch) as a proxy for aseismic slip during the 2011 Prague, Oklahoma earthquake sequence. We find that aseismic slip in the Prague earthquake sequence occurs both within the granitic basement and the overlying sedimentary rocks. The repeating earthquakes show that patches of aseismic slip are mostly located at fault intersections. These fault intersections hosted possible mainshock slip, abundant aftershocks, and afterslip. We estimate that ∼40% of the aftershocks are driven by afterslip. We interpret that aseismic slip occurs at fault intersections where stress heterogeneity creates patches of lower stress that are stable within a nonsteady state, rate‐state framework.
