A new high‐pressure silicate, (Mg,Fe,Si)2(Si,□)O4with a tetragonal spinelloid structure, was discovered within shock melt veins in the Tenham and Suizhou meteorites, two highly shocked L6 ordinary chondrites. Relative to ringwoodite, this phase exhibits an inversion of Si coupled with intrinsic vacancies and a consequent reduction of symmetry. Most notably, the spinelloid makes up about 30–40 vol% of the matrix of shock veins with the remainder composed of a vitrified (Mg,Fe)SiO3phase (in Tenham) or (Mg,Fe)SiO3‐rich clinopyroxene (in Suizhou); these phase assemblages constitute the bulk of the matrix in the shock veins. Previous assessments of the melt matrices concluded that majorite and akimotoite were the major phases. Our contrasting result requires revision of inferred conditions during shock melt cooling of the Tenham and Suizhou meteorites, revealing in particular a much higher quench rate (at least 5 × 103 K s−1) for veins of 100–500 μm diameter, thus overriding formation of the stable phase assemblage majoritic garnet plus periclase.
Experimental Constraints on Ferropericlase (Mg, Fe)O Melt Viscosity Up to 70 GPa: Experimental Constraints on Ferropericlase (Mg, Fe)O Melt Viscosity Up to 70 GPa
More Like this
-
more » « less
Abstract -
Abstract Thermoelastic properties of mantle candidate minerals are essential to our understanding of geophysical phenomena, geochemistry, and geodynamic evolutions of the silicate Earth. However, the lower-mantle mineralogy remains much debated due to the lack of single-crystal elastic moduli (Cij) and aggregate sound velocities of (Al,Fe)-bearing bridgmanite, the most abundant mineral of the planet, at the lower mantle pressure-temperature (P-T) conditions. Here we report single-crystal Cij of (Al,Fe)-bearing bridgmanite, Mg0.88Fe0.1Al0.14Si0.90O3 (Fe10-Al14-Bgm) with Fe3+/ΣFe = ~0.65, up to ~82 GPa using X-ray diffraction (XRD), Brillouin light scattering (BLS), and impulsive stimulated light scattering (ISLS) measurements in diamond-anvil cells (DACs). Two crystal platelets with orientations of (–0.50, 0.05, –0.86) and (0.65, –0.59, 0.48), that are sensitive to deriving all nine Cij, are used for compressional and shear wave velocity (νP and νS) measurements as a function of azimuthal angles over 200° at each experimental pressure. Our results show that all Cij of singe-crystal Fe10-Al14-Bgm increase monotonically with pressure with small uncertainties of 1–2% (±1σ), except C55 and C23, which have uncertainties of 3–4%. Using the third-order Eulerian finite-strain equations to model the elasticity data yields the aggregate adiabatic bulk and shear moduli and respective pressure derivatives at the reference pressure of 25 GPa: KS = 326 ± 4 GPa, µ = 211 ± 2 GPa, KS′ = 3.32 ± 0.04, and µ′ = 1.66 ± 0.02 GPa. The high-pressure aggregate νS and νP of Fe10-Al14-Bgm are 2.6–3.5% and 3.1–4.7% lower than those of MgSiO3 bridgmanite end-member, respectively. These data are used with literature reports on bridgmanite with different Fe and Al contents to quantitatively evaluate pressure and compositional effects on their elastic properties. Comparing with one-dimensional seismic profiles, our modeled velocity profiles of major lower-mantle mineral assemblages at relevant P-T suggest that the lower mantle could likely consist of about 89 vol% (Al,Fe)-bearing bridgmanite. After considering uncertainties, our best-fit model is still indistinguishable from pyrolitic or chondritic models.more » « less
