Anthracene as a Launchpad for a Phosphinidene Sulfide and for Generation of a Phosphorus–Sulfur Material Having the Composition P 2 S, a Vulcanized Red Phosphorus That Is Yellow
- Award ID(s):
- 1664799
- PAR ID:
- 10119267
- Date Published:
- Journal Name:
- Journal of the American Chemical Society
- Volume:
- 141
- Issue:
- 1
- ISSN:
- 0002-7863
- Page Range / eLocation ID:
- 431 to 440
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
Abstract Gate‐/wavelength‐dependent scanning photocurrent measurements of black phosphorous (BP)–MoS2heterojunctions have shown that the Schottky barrier at the MoS2–metal interface plays an important role in the photoresponse dynamics of the heterojunction. When the Fermi level is close to the conduction band of MoS2, photoexcited carriers can tunnel through the narrow depletion region at the MoS2–metal interface, leading to a short response time of 13 µs regardless of the incident laser wavelength. This response speed is comparable or better than that of other few‐layer BP–MoS2heterojunctions. Conversely, when the MoS2channel is in the off‐state, the resulting sizeable Schottky barrier and depletion width make it difficult for photoexcited carriers to overcome the barrier. This significantly delays the carrier transit time and thus the photoresponse speed, leading to a wavelength‐dependent response time since the photoexcited carriers induced by short wavelength photons have a higher probability to overcome the Schottky barrier at the MoS2–metal interface than long wavelength photons. These studies not only shed light on the fundamental understanding of photoresponse dynamics in BP–MoS2heterojunctions, but also open new avenues for engineering the interfaces between 2D materials and metal contacts to reduce the response time of 2D optoelectronics.more » « less
-
A novel and efficient method is demonstrated to improve the electrochemical performance of Li 4 Ti 5 O 12 and metal-oxide anodes. In contrast to other methods, inexpensive red phosphorus powder is used as a reducing reagent, and the reduction is conducted at a relatively low temperature of 400 °C. This method offers a low cost and effective way for Li 4 Ti 5 O 12 and metal-oxide anode applications.more » « less
An official website of the United States government

