The application of Co2‐xRhxP nanoparticles as electrocatalysts for the hydrogen evolution reaction (HER) and overall water splitting in basic media is reported. The experimental design seeks to dilute rhodium with earth‐abundant cobalt as a means to lower the cost of the material and achieve catalytic synergism, as reported for related bimetallic phosphides. The HER activity of Co2‐xRhxP is found to be composition‐dependent, with the rhodium‐rich compositions being more active as compared to their cobalt‐rich counterparts, with overpotentials (η) at 10 mA/cm2geometricof 58.1–63.9 mV vs. 82.1–188.1 mV, respectively. In contrast, Co‐rich Co2‐xRhxP nanoparticles are active for the oxygen evolution reaction (OER) process in basic media, with η= 290 mV for x=0.25. A full water electrolysis cell was created using the most active compositions for OER and HER as the anode and cathode, respectively, generating an overall η= 390 mV. Notably, the cell became more active over a 50 h stability test, increasing by 2 mV/cm2geometricat a constant applied voltage of 1.62 V vs NHE. This enhanced activity correlates with nanoscale phase segregation of Rh in the anode. Thus, the lower overpotential achieved for Co1.75Rh0.25P relative to Co2P, and the augmented activity over time in the former, may be a consequence of restructuring of the anode driven by Rh phase‐segregation. The augmentation in activity at the anode more than compensates for small losses at the cathode.
The cobalt complexes HCo(CO)4and HCo(CO)3(PR3) were the original industrial catalysts used for the hydroformylation of alkenes through reaction with hydrogen and carbon monoxide to produce aldehydes. More recent and expensive rhodium-phosphine catalysts are hundreds of times more active and operate under considerably lower pressures. Cationic cobalt(II) bisphosphine hydrido-carbonyl catalysts that are far more active than traditional neutral cobalt(I) catalysts and approach rhodium catalysts in activity are reported here. These catalysts have low linear-to-branched (L:B) regioselectivity for simple linear alkenes. However, owing to their high alkene isomerization activity and increased steric effects due to the bisphosphine ligand, they have high L:B selectivities for internal alkenes with alkyl branches. These catalysts exhibit long lifetimes and substantial resistance to degradation reactions.
more » « less- NSF-PAR ID:
- 10132601
- Publisher / Repository:
- American Association for the Advancement of Science (AAAS)
- Date Published:
- Journal Name:
- Science
- Volume:
- 367
- Issue:
- 6477
- ISSN:
- 0036-8075
- Page Range / eLocation ID:
- p. 542-548
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
more » « less
Abstract -
more » « less
Abstract Bifunctional oxygen catalysts for oxygen reduction reaction (ORR) and oxygen evolution reaction (OER) with high activities and low‐cost are of prime importance and challenging in the development of fuel cells and rechargeable metal–air batteries. This study reports a porous carbon nanomaterial loaded with cobalt nanoparticles (Co@NC‐
x /y ) derived from pyrolysis of a Co/Zn bimetallic zeolitic imidazolite framework, which exhibits incredibly high activity as bifunctional oxygen catalysts. For instance, the optimal catalyst of Co@NC‐3/1 has the interconnected framework structure between porous carbon and embedded carbon nanotubes, which shows the superb ORR activity with onset potential of ≈1.15 V and half‐wave potential of ≈0.93 V. Moreover, it presents high OER activity that can be further enhanced to over commercial RuO2by P‐doped with overpotentials of 1.57 V versus reversible hydrogen electrode at 10 mA cm−2and long‐term stability for 2000 circles and a Tafel slope of 85 mV dec−1. Significantly, the nanomaterial demonstrates better catalytic performance and durability than Pt/C for ORR and commercial RuO2and IrO2for OER. These findings suggest the importance of a synergistic effect of graphitic carbon, nanotubes, exposed Co–Nx active sites, and interconnected framework structure of various carbons for bifunctional oxygen electrocatalysts. -
more » « less
Abstract The design of supported heterogeneous catalysts requires a detailed understanding of the structure and chemistry of the active surface. Although the chemical components of the active phase, support material, and process feed are typically considered to be the most important factors governing catalyst structure and performance, many common commercial supports contain trace impurities, which can have profound effects on catalyst properties. In this work, we study silica‐supported cobalt‐based catalysts, which are widely used in syngas conversion to value‐added products. Supported metallic Co is a commercial Fischer‐Tropsch catalyst, whereas Co2C has shown promise for the direct conversion of syngas to higher oxygenates. This study examines the effects of Na, a commonly detected support impurity and a frequently used promoter, on the structure and reactivity of Co and Co2C. We show that trace Na impurities significantly decrease catalyst activity of supported metallic Co, and that high Na concentrations result in Co2C formation and a loss in Fischer‐Tropsch activity. However, in Co2C catalysts, Na plays an important role in stabilizing the Co2C phase, but excess Na decreases catalyst activity. We use in situ X‐ray absorption spectroscopy to study Co2C formation and decomposition in the Na‐free catalyst under carburization and reaction conditions. The work reveals the importance of carefully controlling alkali metal content, particularly at trace levels, in catalyst design.
-
more » « less
Abstract Chloride abstraction from [(
R ,R )‐(iPrDuPhos)Co(μ‐Cl)]2with NaBArF4(BArF4=B[(3,5‐(CF3)2)C6H3]4) in the presence of dienes, such as 1,5‐cyclooctadiene (COD) or norbornadiene (NBD), yielded long sought‐after cationic bis(phosphine) cobalt complexes, [(R ,R )‐(iPrDuPhos)Co(η2,η2‐diene)][BArF4]. The COD complex proved substitutionally labile undergoing diene substitution with tetrahydrofuran, NBD, or arenes. The resulting 18‐electron, cationic cobalt(I) arene complexes, as well as the [(R ,R )‐(iPrDuPhos)Co(diene)][BArF4] derivatives, proved to be highly active and enantioselective precatalysts for asymmetric alkene hydrogenation. A cobalt–substrate complex, [(R ,R )‐(iPrDuPhos)Co(MAA)][BArF4] (MAA=methyl 2‐acetamidoacrylate) was crystallographically characterized as the opposite diastereomer to that expected for productive hydrogenation demonstrating a Curtin–Hammett kinetic regime similar to rhodium catalysis. -
more » « less
Abstract Chloride abstraction from [(
R ,R )‐(iPrDuPhos)Co(μ‐Cl)]2with NaBArF4(BArF4=B[(3,5‐(CF3)2)C6H3]4) in the presence of dienes, such as 1,5‐cyclooctadiene (COD) or norbornadiene (NBD), yielded long sought‐after cationic bis(phosphine) cobalt complexes, [(R ,R )‐(iPrDuPhos)Co(η2,η2‐diene)][BArF4]. The COD complex proved substitutionally labile undergoing diene substitution with tetrahydrofuran, NBD, or arenes. The resulting 18‐electron, cationic cobalt(I) arene complexes, as well as the [(R ,R )‐(iPrDuPhos)Co(diene)][BArF4] derivatives, proved to be highly active and enantioselective precatalysts for asymmetric alkene hydrogenation. A cobalt–substrate complex, [(R ,R )‐(iPrDuPhos)Co(MAA)][BArF4] (MAA=methyl 2‐acetamidoacrylate) was crystallographically characterized as the opposite diastereomer to that expected for productive hydrogenation demonstrating a Curtin–Hammett kinetic regime similar to rhodium catalysis.
