skip to main content

Explore Research Products in the NSF-PAR

Title: High-contrast and reversible polymer thermal regulator by structural phase transition
In comparison with the advancement of switchable, nonlinear, and active components in electronics, solid-state thermal components for actively controlling heat flow have been extremely rare. We demonstrate a high-contrast and reversible polymer thermal regulator based on the structural phase transition in crystalline polyethylene nanofibers. This structural phase transition represents a dramatic change in morphology from a highly ordered all-trans conformation to a combined trans and gauche conformation with rotational disorder, leading to an abrupt change in phonon transport along the molecular chains. For five nanofiber samples measured here, we observe an average thermal switching ratio of ~8× and maximum switching ratio of ~10×, which occurs in a narrow temperature range of 10 K across the structural phase transition. To the best of our knowledge, the ~10× switching ratio exceeds any reported experimental values for solid-solid and solid-liquid phase transitions of materials. There is no thermal hysteresis observed upon heating/cooling cycles.  more » « less
Award ID(s):
1762560
NSF-PAR ID:
10140647
Author(s) / Creator(s):
; ; ; ; ; ; ; ; ; ; ; ;
Date Published:
Journal Name:
Science Advances
Volume:
5
Issue:
12
ISSN:
2375-2548
Page Range / eLocation ID:
eaax3777
Format(s):
Medium: X
Sponsoring Org:
National Science Foundation
More Like this
  1. ; ; ; ; ; ; ; ; ; ( , Macromolecules)
    null (Ed.)
    Stereoregularity significantly influences the crystallization, mechanical, and thermal properties of polymers. In this work, we investigate crystallization behaviors and molecular dynamics of atactic (a)-, isotactic (i)-, and syndiotactic (s)-hydrogenated poly(norbornene) (hPNB)s by using small-angle X-ray scattering and solid-state (ss) NMR. a-hPNB exhibits a much higher crystallinity (Φc) (82%) and long period (L) (80 nm) than i- and s-hPNB (50–55% and 17–21 nm). Moreover, in the s-hPNB crystalline region, chain dynamics is not thermally activated up to the melting temperature (Tm), while in the crystalline regions of i- and a-hPNB, small amplitude motions occur in a slow dynamic regime of 10–2–102 s. The molecular dynamics follows Arrhenius behavior in a-hPNB up to the crystal–crystal transition temperature (Tcc), while these dynamics are surprisingly saturated in i-hPNB under these conditions. Temperature dependence of the molecular dynamics leads to different crystal–crystal transitions between i- and a-hPNBs: i-hPNB changes the trans conformation to the gauche one due to the localized bond rotations where chain dynamics is restricted, whereas a-hPNB keeps a nearly trans conformation and conducts fast chain dynamics due to the amplified C–C bond rotations in the high-temperature phase. Such fast chain dynamics leads to unique crystallization behaviors of hPNB, specifically in the atactic configuration due to configurational disorder coupled with conformational flexibility. 
    more » « less
  2. ; ; ; ; ; ; ; ; ( , Physical Chemistry Chemical Physics)
    Bis(bithienyl)-1,2-dicyanoethene (4TCE) is a photoswitch that operates via reversible E / Z photoisomerization following absorption of visible light. cis -to- trans photoisomerization of 4TCE requires excitation below 470 nm, is relatively inefficient (quantum yield < 5%) and occurs via the lowest-lying triplet. We present excitation-wavelength dependent (565–420 nm) transient absorption (TA) studies to probe the photophysics of cis -to- trans isomerization to identify sources of switching inefficiency. TA data reveals contributions from more than one switch conformer and relaxation cascades between multiple states. Fast (∼4 ps) and slow (∼40 ps) components of spectral dynamics observed at low excitation energies (>470 nm) are readily attributed to deactivation of two conformers; this assignment is supported by computed thermal populations and absorption strengths of two molecular geometries (P A and P B ) characterized by roughly parallel dipoles for the thiophenes on opposite sides of the ethene bond. Only the P B conformer is found to contribute to triplet population and the switching of cis -4TCE: high-energy excitation (<470 nm) of P B involves direct excitation to S 2 , relaxation from which prepares an ISC-active S 1 geometry (ISC QY 0.4–0.67, k ISC ∼ 1.6–2.6 × 10 −9 s −1 ) that is the gateway to triplet population and isomerization. We ascribe low cis -to- trans isomerization yield to excitation of the nonreactive P A conformer (75–85% loss) as well as loses along the P B S 2 → S 1 → T 1 cascade (10–20% loss). In contrast, electrocyclization is inhibited by the electronic character of the excited states, as well as a non-existent thermal population of a reactive “antiparallel” ring conformation. 
    more » « less
  3. ; ; ; ; ; ; ; ; ; ; et al ( , Nature Communications)
    Abstract Materials with tunable thermal properties enable on-demand control of temperature and heat flow, which is an integral component in the development of solid-state refrigeration, energy scavenging, and thermal circuits. Although gap-based and liquid-based thermal switches that work on the basis of mechanical movements have been an effective approach to control the flow of heat in the devices, their complex mechanisms impose considerable costs in latency, expense, and power consumption. As a consequence, materials that have multiple solid-state phases with distinct thermal properties are appealing for thermal management due to their simplicity, fast switching, and compactness. Thus, an ideal thermal switch should operate near or above room temperature, have a simple trigger mechanism, and offer a quick and large on/off switching ratio. In this study, we experimentally demonstrate that manipulating phonon scattering rates can switch the thermal conductivity of antiferroelectric PbZrO 3 bidirectionally by −10% and +25% upon applying electrical and thermal excitation, respectively. Our approach takes advantage of two separate phase transformations in PbZrO 3 that alter the phonon scattering rate in different manners. In this study, we demonstrate that PbZrO 3 can serve as a fast (<1 second), repeatable, simple trigger, and reliable thermal switch with a net switching ratio of nearly 38% from ~1.20 to ~1.65 W m −1 K −1 . 
    more » « less
  4. ; ; ; ; ( , International Journal of Molecular Sciences)
    null (Ed.)
    Biopolymer composites based on silk fibroin have shown widespread potential due to their brilliant applications in tissue engineering, medicine and bioelectronics. In our present work, biocomposite nanofilms with different special topologies were obtained through blending silk fibroin with crystallizable poly(L-lactic acid) (PLLA) at various mixture rates using a stirring-reflux condensation blending method. The microstructure, phase components, and miscibility of the blended films were studied through thermal analysis in combination with Fourier-transform infrared spectroscopy and Raman analysis. X-ray diffraction and scanning electron microscope were also used for advanced structural analysis. Furthermore, their conformation transition, interaction mechanism, and thermal stability were also discussed. The results showed that the hydrogen bonds and hydrophobic interactions existed between silk fibroin (SF) and PLLA polymer chains in the blended films. The secondary structures of silk fibroin and phase components of PLLA in composites vary at different ratios of silk to PLLA. The β-sheet content increased with the increase of the silk fibroin content, while the glass transition temperature was raised mainly due to the rigid amorphous phase presence in the blended system. This results in an increase in thermal stability in blended films compared to the pure silk fibroin films. This study provided detailed insights into the influence of synthetic polymer phases (crystalline, rigid amorphous, and mobile amorphous) on protein secondary structures through blending, which has direct applications on the design and fabrication of novel protein–synthetic polymer composites for the biomedical and green chemistry fields. 
    more » « less
  5. ; ; ; ; ; ; ; ; ; ; et al ( , Advanced Materials)
    Abstract

    Oxides that exhibit an insulator–metal transition can be used to fabricate energy‐efficient relaxation oscillators for use in hardware‐based neural networks but there are very few oxides with transition temperatures above room temperature. Here the structural, electrical, and thermal properties of V3O5thin films and their application as the functional oxide in metal/oxide/metal relaxation oscillators are reported. The V3O5devices show electroforming‐free volatile threshold switching and negative differential resistance (NDR) with stable (<3% variation) cycle‐to‐cycle operation. The physical mechanisms underpinning these characteristics are investigated using a combination of electrical measurements, in situ thermal imaging, and device modeling. This shows that conduction is confined to a narrow filamentary path due to self‐confinement of the current distribution and that the NDR response is initiated at temperatures well below the insulator–metal transition temperature where it is dominated by the temperature‐dependent conductivity of the insulating phase. Finally, the dynamics of individual and coupled V3O5‐based relaxation oscillators is reported, showing that capacitively coupled devices exhibit rich non‐linear dynamics, including frequency and phase synchronization. These results establish V3O5as a new functional material for volatile threshold switching and advance the development of robust solid‐state neurons for neuromorphic computing.

     
    more » « less
  • Citation Formats
  • MLA
  • APA
  • Chicago
  • BibTeX
  • Save / Share this Record
  • Send to Email