Spin-to-charge conversion and the reverse process are now critically important physical processes for a wide range of fundamental and applied studies in spintronics. Here, we experimentally demonstrate effective spin-to-charge conversion in thermally evaporated chromium thin films using the longitudinal spin Seebeck effect (LSSE). We present LSSE results measured near room temperature for Cr films with thicknesses from 2 to 11 nm, deposited at room temperature on bulk polycrystalline yttrium-iron-garnet (YIG) substrates. Comparison of the measured LSSE voltage, [Formula: see text], in Cr to a sputtered Pt film at the same nominal thickness grown on a matched YIG substrate shows that both films show comparably large spin-to-charge conversion. As previously shown for other forms of Cr, the LSSE signal for evaporated Cr/YIG shows the opposite sign compared to Pt, indicating that Cr has a negative spin Hall angle, [Formula: see text]. We also present measured charge resistivity, [Formula: see text], of the same evaporated Cr films on YIG. These values are large compared to Pt and comparable to [Formula: see text]-W at a similar thickness. Non-monotonic behavior of both [Formula: see text] and [Formula: see text] with film thickness suggests that spin-to-charge conversion in evaporated Cr, which we expect has a differentmore »
Spin thermoelectrics represents a new paradigm of thermoelectricity that has a potential to overcome the fundamental limitation posed by the Wiedmann-Franz law on the efficiency of conventional thermoelectric devices. A typical spin thermoelectric device consists of a bilayer of a magnetic insulator and a high spin-orbit coupling (SOC) metal coated over a non-magnetic substrate. Pt is the most commonly used metal in spin thermoelectric devices due to its strong SOC. In this paper, we found that an alloy of Cu and Pt can perform much better than Pt in spin thermoelectric devices. A series of CuPt alloy films with different Pt concentrations were deposited on yttrium iron garnet (YIG) films coated gadolinium gallium garnet (GGG) substrate. Through spin Seebeck measurements, it was found that the Cu0.4Pt0.6/YIG/GGG device shows almost 3 times higher spin Seebeck voltage compared to Pt/YIG/GGG under identical conditions. The improved performance was attributed to the higher resistivity as well as enhanced spin hall angle of the CuPt layer.
- Publication Date:
- NSF-PAR ID:
- 10153491
- Journal Name:
- Scientific Reports
- Volume:
- 9
- Issue:
- 1
- ISSN:
- 2045-2322
- Publisher:
- Nature Publishing Group
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Spin waves, quantized as magnons, have low energy loss and magnetic damping, which are critical for devices based on spin‐wave propagation needed for information processing devices. The organic‐based magnet [V(TCNE)x; TCNE = tetracyanoethylene; x ≈ 2] has shown an extremely low magnetic damping comparable to, for example, yttrium iron garnet (YIG). The excitation, detection, and utilization of coherent and non‐coherent spin waves on various modes in V(TCNE)x is demonstrated and show that the angular momentum carried by microwave‐excited coherent spin waves in a V(TCNE)x film can be transferred into an adjacent Pt layer via spin pumping and detected using the inverse spin Hall effect. The spin pumping efficiency can be tuned by choosing different excited spin wave modes in the V(TCNE)x film. In addition, it is shown that non‐coherent spin waves in a V(TCNE)x film, excited thermally via the spin Seebeck effect, can also be used as spin pumping source that generates an electrical signal in Pt with a sign change in accordance with the magnetization switching of the V(TCNE)x. Combining coherent and non‐coherent spin wave detection, the spin pumping efficiency can be thermally controlled, and new insight is gained for the spintronic applications of spin wave modes in organic‐basedmore »
-
Tunable non-reciprocal components with ferrites that can be integrated using a foundry suitable process are key to achieving low-power adaptive microwave circuits. The current state-of-the-art still relies on electrical tuning or resistive absorbers to facilitate unidirectional propagation. Here, we demonstrate a novel process for spin-coating thick films of ferrites without the complexities of vacuum processes or high-temperature annealing. Composites of yttrium iron garnet (YIG) nanoparticles in a matrix spin-on-glass are spin-coated on silicon substrates, and magnetic properties comparable to bulk YIG are obtained in films exceeding 30 microns. We also propose a design for tunable phase shifter based on periodically serrated coplanar waveguide with a YIG cladding. A nonreciprocal phase difference of 20 – 60 degrees is obtained over a tunable band of 550 MHz between 3.85 - 4.4 GHz from a tuning magnetic field of 8 – 40 kA/m.
-
Abstract Large area highly crystalline MoS2and WS2thin films were successfully grown on different substrates using radio-frequency magnetron sputtering technique. Structural, morphological and thermoelectric transport properties of MoS2,and WS2thin films have been investigated systematically to fabricate high-efficient thermal energy harvesting devices. X-ray diffraction data revealed that crystallites of MoS2and WS2films are highly oriented in 002 plane with uniform grain size distribution confirmed through atomic force microscopy study. Surface roughness increases with substrate temperature and it plays a big role in electron and phonon scattering. Interestingly, MoS2films also display low thermal conductivity at room temperature and strongly favors achievement of higher thermoelectric figure of merit value of up to 1.98. Raman spectroscopy data shows two distinct MoS2vibrational modes at 380 cm−1for E12gand 410 cm−1for A1g. Thermoelectric transport studies further demonstrated that MoS2films show p-type thermoelectric characteristics, while WS2is an n-type material. We demonstrated high efficient pn-junction thermoelectric generator device for waste heat recovery and cooling applications.
-
There has been a growing interest in solution-phase routes to thermoelectric materials due to the decreased costs and novel device architectures that these methods enable. Many excellent thermoelectric materials are metal chalcogenide semiconductors and the ability to create soluble metal chalcogenide semiconductor precursors using thiol–amine solvent mixtures was recently demonstrated by others. In this paper, we report the first thermoelectric property measurements on metal chalcogenide thin films made in this manner. We create Cu 2−x Se y S 1−y and Ag-doped Cu 2−x Se y S 1−y thin films and study the interrelationship between their composition and room temperature thermoelectric properties. We find that the precursor annealing temperature affects the metal : chalcogen ratio, and leads to charge carrier concentration changes that affect the Seebeck coefficient and electrical conductivity. Increasing the Se : S ratio increases electrical conductivity and decreases the Seebeck coefficient. We also find that incorporating Ag into the Cu 2−x Se y S 1−y film leads to appreciable improvements in thermoelectric performance by increasing the Seebeck coefficient and decreasing thermal conductivity. Overall, we find that the room temperature thermoelectric properties of these solution-processed materials are comparable to measurements on Cu 2−x Se alloys made via conventional thermoelectric material processing methods. Achievingmore »
