Freshly emitted soot is hydrophobic, but condensation of secondary aerosols and coagulation with other particles modify its hygroscopic optical properties. This conversion is referred to as “aerosol aging.” Many climate models represent this aging process with a fixed aging time scale, whereas in reality, it is a dynamic process that depends on environmental conditions. Here, we implement a dynamic aging parameterization scheme in the regional climate model RegCM4 in place of the fixed aging timescale of 1.15 days (∼27.6 h) and examine its impact on the aerosol life cycle over the Indian subcontinent. The conversion from hydrophobic to hydrophilic aerosol is usually lower than 27.6 h over the entire landmass and lower than 10 h over the polluted Indo‐Gangetic Basin (IGB), with seasonal variability. Due to the implementation of the dynamic aging scheme, the column burden and surface mass concentration of carbonaceous aerosols increase during the drier season (December–February) when washout is negligible. The burden is reduced during the wet season (June–September) due to a more efficient washout except over the IGB, where a reduction in precipitation as a result of radiative feedbacks increases the aerosol concentrations. Over the polluted IGB, surface dimming increases due to the dynamic aging scheme, with the top of the atmosphere forcing remaining mostly unchanged. As a result, atmospheric heating increases by at least 1.2 W/m2. Our results suggest that climate models should incorporate dynamic aging for a more realistic representation of aerosol simulations, especially in highly polluted regions.
Extensive Soot Compaction by Cloud Processing from Laboratory and Field Observations
Soot particles form during combustion of carbonaceous materials and impact climate and air quality. When freshly emitted, they are typically fractal-like aggregates. After atmospheric aging, they can act as cloud condensation nuclei, and water condensation or evaporation restructure them to more compact aggregates, affecting their optical, aerodynamic, and surface properties. Here we survey the morphology of ambient soot particles from various locations and different environmental and aging conditions. We used electron microscopy and show extensive soot compaction after cloud processing. We further performed laboratory experiments to simulate atmospheric cloud processing under controlled conditions. We find that soot particles sampled after evaporating the cloud droplets, are significantly more compact than freshly emitted and interstitial soot, confirming that cloud processing, not just exposure to high humidity, compacts soot. Our findings have implications for how the radiative, surface, and aerodynamic properties, and the fate of soot particles are represented in numerical models.
more » « less- PAR ID:
- 10153660
- Author(s) / Creator(s):
- ; ; ; ; ; ; ; ; ; ; ; ; ; ; ; ; ; ; ; more »
- Publisher / Repository:
- Nature Publishing Group
- Date Published:
- Journal Name:
- Scientific Reports
- Volume:
- 9
- Issue:
- 1
- ISSN:
- 2045-2322
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
more » « less
Abstract -
Abstract We recently demonstrated that the heterogeneous hydroxyl radical (·OH) oxidation is an important aging process for isoprene epoxydiol-derived secondary organic aerosol (IEPOX-SOA) that alters its chemical composition, and thus, aerosol physicochemical properties. Notably, dimeric species in IEPOX-SOA were found to heterogeneously react with ·OH at a much faster rate than monomers, suggesting that the initial oligomeric content of freshly-generated IEPOX-SOA particles may affect its subsequent atmospheric oxidation. Aerosol acidity could in principle influence this aging process by enhancing the formation of sulfated and non-sulfated oligomers in freshly-generated IEPOX-SOA. Many multifunctional organosulfate (OS) products derived from heterogeneous ·OH oxidation of sulfur-containing IEPOX-SOA have been observed in cloud water residues and ice nucleating particles and could affect the ability of aged IEPOX-SOA particles to act as cloud condensation nuclei. Hence, this study systematically investigated the effect of aerosol acidity on the kinetics and products resulting from heterogeneous ·OH oxidation of IEPOX-SOA particles. Gas-phase IEPOX was reacted with inorganic sulfate particles of varying pH (0.5 to 2.0) in an indoor smog chamber operated under dark, steady-state conditions to form freshly-generated IEPOX-SOA particles. These particles were then aged at a relative humidity of 60% in an oxidation flow reactor (OFR) for 0-15 days of equivalent atmospheric ·OH exposure. Aged IEPOX-SOA particles were sampled by an online aerosol chemical speciation monitor (ACSM) to measure real-time aerosol mass and chemical changes of the SOA particles, and were also collected onto Teflon filters and into PILS vials for molecular-level chemical analyses by hydrophilic liquid interaction chromatography method interfaced to electrospray ionization high-resolution quadrupole time-of-flight mass spectrometry (HILIC/ESI-HR-QTOFMS), ion chromatography, and total OS mass amounts.more » « less
-
We recently demonstrated that the heterogeneous hydroxyl radical (OH) oxidation is an important aging process for isoprene epoxydiol-derived secondary organic aerosol (IEPOX-SOA) that alters its chemical composition, and thus, aerosol physicochemical properties. Notably, dimeric species in IEPOX-SOA were found to heterogeneously react with OH at a much faster rate than monomers, suggesting that the initial oligomeric content of freshly-generated IEPOX-SOA particles may affect its subsequent atmospheric oxidation. Aerosol acidity could in principle influence this aging process by enhancing the formation of sulfated and non-sulfated oligomers in freshly-generated IEPOX-SOA. Many multifunctional organosulfate (OS) products derived from heterogeneous OH oxidation of sulfur-containing IEPOX-SOA have been observed in cloud water residues and ice nucleating particles and could affect the ability of aged IEPOX-SOA particles to act as cloud condensation nuclei. Hence, this study systematically investigated the effect of aerosol acidity on the kinetics and products resulting from heterogeneous OH oxidation of IEPOX-SOA particles. We reacted gas-phase IEPOX with inorganic sulfate particles of varying pH (0.5 to 2.5) in an indoor smog chamber operated under dark, steady-state conditions to form freshly-generated IEPOX-SOA particles. These particles were aged at a relative humidity of 65% in an oxidation flow reactor (OFR) for 0-21 days of equivalent atmospheric OH exposure. Through molecular-level chemical analyses by hydrophilic interaction liquid chromatography method interfaced to electrospray ionization high-resolution quadrupole time-of-flight mass spectrometry (HILIC/ESI-HR-QTOFMS), we observed that highly acidic aerosol has higher oligomer ratio and exhibit much slower mass decay with OH oxidation (pH=0.5, lifetime = 56 days) as compared to less acidic aerosols (pH=2.5, lifetime=17 days). Based on atomic force microscopy (AFM) analysis, aerosol acidity could also affect the morphology and viscosity of IEPOX-SOA during OH oxidation process.more » « less
-
We recently demonstrated that the heterogeneous hydroxyl radical (OH) oxidation is an important aging process for isoprene epoxydiol-derived secondary organic aerosol (IEPOX-SOA) that alters its chemical composition, and thus, aerosol physicochemical properties. Notably, dimeric species in IEPOX-SOA were found to heterogeneously react with OH at a much faster rate than monomers, suggesting that the initial oligomeric content of freshly-generated IEPOX-SOA particles may affect its subsequent atmospheric oxidation. Aerosol acidity could in principle influence this aging process by enhancing the formation of sulfated and non-sulfated oligomers in freshly-generated IEPOX-SOA. Many multifunctional organosulfate (OS) products derived from heterogeneous OH oxidation of sulfur-containing IEPOX-SOA have been observed in cloud water residues and ice nucleating particles and could affect the ability of aged IEPOX-SOA particles to act as cloud condensation nuclei. Hence, this study systematically investigated the effect of aerosol acidity on the kinetics and products resulting from heterogeneous OH oxidation of IEPOX-SOA particles. We reacted gas-phase IEPOX with inorganic sulfate particles of varying pH (0.5 to 2.5) in an indoor smog chamber operated under dark, steady-state conditions to form freshly-generated IEPOX-SOA particles. These particles were aged at a relative humidity of 65% in an oxidation flow reactor (OFR) for 0-21 days of equivalent atmospheric OH exposure. Through molecular-level chemical analyses by hydrophilic interaction liquid chromatography method interfaced to electrospray ionization high-resolution quadrupole time- of-flight mass spectrometry (HILIC/ESI-HR-QTOFMS), we observed that highly acidic aerosol has higher oligomer ratio and exhibit much slower mass decay with OH oxidation (pH=0.5, lifetime = 56 days) as compared to less acidic aerosols (pH=2.5, lifetime=17 days). Based on atomic force microscopy (AFM) analysis, aerosol acidity could also affect the morphology and viscosity of IEPOX-SOA during OH oxidation process.more » « less
-
Isoprene is one of the most common biogenic volatile organic compounds (BVOC) in the atmosphere, produced by many plants. Isoprene undergoes oxidation to form gaseous isoprene epoxydiols (IEPOX) under low-NOx conditions, which can lead to the formation of secondary organic aerosol (SOA) particles. SOA-containing particles affect climate by scattering and absorbing solar radiation or acting as cloud condensation nuclei (CCN). High concentrations of SOA are also associated with adverse health impacts in people. While in the atmosphere, IEPOX SOA particles continue to undergo reactions with atmospheric oxidants, including hydroxyl radical (OH). To isolate and probe this process, we studied atmospheric chemical processes in an aerosol chamber to better understand the evolution of heterogeneous OH oxidation of IEPOX-derived SOA particles. Since very little is understood about the structural and spectroscopic properties because of the complexity of their many sources and atmospheric processing, individual particle measurements are necessary to provide better understanding of the composition of IEPOX SOA. We injected particles composed of mixtures of ammonium sulfate and sulfuric acid across a range of acidities(PH = 0.5 – 2.5) and gas-phase IEPOX into the chamber to generate SOA. The SOA particles were then sent to an oxidation flow reactor, and exposed to different OH concentrations representative of aging of a number of days. We kept relative humidity (RH) constant at ~65%, the temperature was ~23 °C, and levels of oxidation were controlled by adjusting lamp intensity. After oxidized SOA was impacted on quartz substrates, we used single-particle Raman microspectroscopy to identify their functional group compositions. From the Raman vibrational spectra of submicron particles (~500-1000 nm aerodynamic diameter), we observed a distinct difference in core-shell morphology and composition: an organic outer layer and an aqueous-inorganic core. The core also has significantly more CH-stretch than the shell. Small changes were also observed with increasing oxidation, which are important to consider when predicting SOA particle evolution in the atmosphere.more » « less
