Abstract. Natural rock arches are rare and beautiful geologic landforms with important cultural value. As such, their management requires periodic assessment of structural integrity to understand environmental and anthropogenic influences on arch stability. Measurements of passive seismic vibrations represent a rapid and non-invasive technique to describe the dynamic properties of natural arches, including resonant frequencies, modal damping ratios, and mode shapes, which can be monitored over time for structural health assessment. However, commonly applied spectral analysis tools are often limited in their ability to resolve characteristics of closely spaced or complex higher-order modes. Therefore, we investigate two techniques well-established in the field of civil engineering through application to a set of natural arches previously characterized using polarization analysis and spectral peak-picking techniques. Results from enhanced frequency domain decomposition and parametric covariance-driven stochastic subspace identification modal analyses showed generally good agreement with spectral peak-picking and frequency-dependent polarizationanalyses. However, we show that these advanced techniques offer the capability to resolve closely spaced modes including their corresponding modal damping ratios. In addition, due to preservation of phase information, enhanced frequency domain decomposition allows for direct and convenient three-dimensional visualization of mode shapes. These techniques provide detailed characterization of dynamic parameters, which can be monitored to detect structural changes indicating damage and failure, and in addition have the potential to improve numerical models used for arch stability assessment. Results of our study encourage broad adoption and application of these advanced modal analysis techniques for dynamic analysis of a wide range of geological features.
more »
« less
Sparse Ambient Resonance Measurements Reveal Dynamic Properties of Freestanding Rock Arches
The dynamic properties of freestanding rock landforms are a function of fundamental material and mechanical parameters, facilitating noninvasive vibration‐based structural assessment. Characterization of resonant frequencies, mode shapes, and damping ratios, however, can be challenging at culturally sensitive geologic features, such as rock arches, where physical access is limited. Using sparse ambient vibration measurements, we describe three resonant modes between 1 and 40 Hz for 17 natural arches in Utah spanning a range of lengths from 3–88 m. Modal polarization data are evaluated to combine field observations with 3‐D numerical models. We find outcrop‐scale elastic moduli vary from 0.8 to 8.0 GPa, correlated with diagenetic processes and identify low damping at all sites. Correlation of dense‐array measurements from one arch validates predictions of simple bending modes and fixed boundary conditions. Our results establish use of sparse ambient resonance measurements for structural assessment and monitoring of arches and similar freestanding geologic features worldwide.
more » « less- Award ID(s):
- 1831283
- NSF-PAR ID:
- 10455428
- Publisher / Repository:
- DOI PREFIX: 10.1029
- Date Published:
- Journal Name:
- Geophysical Research Letters
- Volume:
- 47
- Issue:
- 9
- ISSN:
- 0094-8276
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
more » « less
Abstract Continuous ambient seismic monitoring is becoming common for structural health assessment of geologic features. However, the ability to detect or predict permanent mechanical change associated with damage requires detailed understanding of reversible drifts in resonance attributes associated with changing meteorological conditions. Here, we analyze the response of 17 sandstone rock arches to changing meteorological conditions during extended vibration‐based monitoring, with a focus on 1 arch in Utah which was continuously monitored for 15 months. Our results show that variations in resonance are correlated with temperature on daily and yearly time scales, but that the temperature sensitivity of frequency changes are variable at different sites and resonance modes, generally ranging from 0.5% to 6% per 10°C. Numerical modeling suggests the primary mechanism governing these frequency drifts is stress stiffening, where confined thermal dilation induces bulk stress changes in the low‐stress, nonlinear elastic regime via fracture closure. Secondary mechanisms affecting resonance attributes are driven by moisture, including formation of shallow pore ice, which can generate sharp frequency changes of up to 17% per −10°C, and moisture‐induced softening. Daily lag times of several hours between temperature and frequency extrema provide constraints on the rock volumes affected by these mechanisms, indicating modal attributes are sensitive to thermally driven changes occurring in the outermost centimeters of the structure. Through improved understanding of the reversible variations of rock mass resonance, our results aid future assessment of irreversible frequency changes associated with damage, and thus structural health monitoring of fragile geologic features.
-
Abstract We acquired a unique ambient vibration dataset from Castleton Tower, a 120 m high bedrock monolith located near Moab, Utah, to resolve dynamic and material properties of the landform. We identified the first two resonant modes at 0.8 and 1.0 Hz, which consist of mutually perpendicular, linearly polarized horizontal ground motion at the top of the tower. Damping ratios for these modes were low at ∼1%. We successfully reproduced field data in 3D numerical eigenfrequency simulation implementing a Young’s modulus of 7 GPa, a value ∼30% lower than measured on core samples. Our analysis confirms that modal deformation at the first resonant frequencies closely resembles that of a cantilever beam. The outcome is that with basic estimates of geometry and material properties, the resonant frequencies of other freestanding rock monoliths can be estimated a priori. Such estimates are crucial to evaluate the response of rock towers to external vibration inputs.more » « less
-
Abstract The dynamic properties of freestanding rock towers are important inputs for seismic stability and vibration hazard assessments, however data describing the natural frequencies, mode shapes, and damping ratios of these landforms remain rare. We measured the ambient vibration of 14 sandstone and conglomerate rock towers and fins in Utah, United States, using broadband seismometers and nodal geophones. Fundamental frequencies vary between 0.8 and 15 Hz—inversely with tower height—and generally exhibit subhorizontal modal vectors oriented parallel to the minimum tower width. Modal damping ratios are low across all features, between 0.6% and 2.2%. We reproduced measured modal attributes in 3D numerical eigenfrequency models for 10 of the 14 landforms, showing that the fundamental mode of these features is full-height bending akin to a cantilever. Fin-like landforms commonly have a torsional second mode whereas tower-like features have a second full-height bending mode subperpendicular to the fundamental. In line with beam theory predictions, our data confirm that fundamental frequencies scale with the ratio of a tower’s width to its squared height. Compiled data from 18 other sites support our results, and taken together, provide guidance for estimating the modal properties of rock towers required for vibration risk assessment and paleoseismic shaking intensity analysis in different settings.more » « less
-
Abstract Thousands of rock arches are situated within the central Colorado Plateau—a region experiencing small- to moderate-magnitude contemporary seismicity. Recent anthropogenic activity has substantially increased the seismicity rate in some areas, raising questions about the potential for vibration damage of natural arches, many of which have high cultural value. However, predictions of the vibration response and potential for damage at a given site are limited by a lack of data describing spectral amplification of ground motion on these landforms. We analyzed 13 sandstone arches in Utah, computing site-to-reference spectral amplitude ratios from continuous ambient seismic data, and compared these to spectral ratios during earthquakes and teleseismic activity. We found peak ground velocities on arches at their dominant natural modes (in the range of 2–20 Hz) are ∼20–180 times the velocity on adjacent bedrock, due to amplification arising from slender geometry and low modal damping (0.8%–2.7%). Ambient spectral ratios are generally 1.2–2.0 times the coseismic spectral ratios. Because arches experience highly amplified ground motion, the range of earthquakes considered potentially damaging may need to be revised to include lower-magnitude events. Our results have implications for conservation management of these and other culturally valuable landforms.more » « less
