Megapixel single-photon avalanche diode (SPAD) arrays have been developed recently, opening up the possibility of deploying SPADs as generalpurpose passive cameras for photography and computer vision. However, most previous work on SPADs has been limited to monochrome imaging. We propose a computational photography technique that reconstructs high-quality color images from mosaicked binary frames captured by a SPAD array, even for high-dyanamic-range (HDR) scenes with complex and rapid motion. Inspired by conventional burst photography approaches, we design algorithms that jointly denoise and demosaick single-photon image sequences. Based on the observation that motion effectively increases the color sample rate, we design a blue-noise pseudorandom RGBW color filter array for SPADs, which is tailored for imaging dark, dynamic scenes. Results on simulated data, as well as real data captured with a fabricated color SPAD hardware prototype shows that the proposed method can reconstruct high-quality images with minimal color artifacts even for challenging low-light, HDR and fast-moving scenes. We hope that this paper, by adding color to computational single-photon imaging, spurs rapid adoption of SPADs for real-world passive imaging applications.
Diffractive achromats (DAs) promise ultra-thin and light-weight form factors for full-color computational imaging systems. However, designing DAs with the optimal optical transfer function (OTF) distribution suitable for image reconstruction algorithms has been a difficult challenge. Emerging end-to-end optimization paradigms of diffractive optics and processing algorithms have achieved impressive results, but these approaches require immense computational resources and solve non-convex inverse problems with millions of parameters. Here, we propose a learned rotational symmetric DA design using a concentric ring decomposition that reduces the computational complexity and memory requirements by one order of magnitude compared with conventional end-to-end optimization procedures, which simplifies the optimization significantly. With this approach, we realize the joint learning of a DA with an aperture size of 8 mm and an image recovery neural network, i.e., Res-Unet, in an end-to-end manner across the full visible spectrum (429–699 nm). The peak signal-to-noise ratio of the recovered images of our learned DA is 1.3 dB higher than that of DAs designed by conventional sequential approaches. This is because the learned DA exhibits higher amplitudes of the OTF at high frequencies over the full spectrum. We fabricate the learned DA using imprinting lithography. Experiments show that it resolves both fine details and color fidelity of diverse real-world scenes under natural illumination. The proposed design paradigm paves the way for incorporating DAs for thinner, lighter, and more compact full-spectrum imaging systems.
more » « less- NSF-PAR ID:
- 10178778
- Publisher / Repository:
- Optical Society of America
- Date Published:
- Journal Name:
- Optica
- Volume:
- 7
- Issue:
- 8
- ISSN:
- 2334-2536
- Format(s):
- Medium: X Size: Article No. 913
- Size(s):
- Article No. 913
- Sponsoring Org:
- National Science Foundation
More Like this
-
more » « less
-
Tasks across diverse application domains can be posed as large-scale optimization problems, these include graphics, vision, machine learning, imaging, health, scheduling, planning, and energy system forecasting. Independently of the application domain, proximal algorithms have emerged as a formal optimization method that successfully solves a wide array of existing problems, often exploiting problem-specific structures in the optimization. Although model-based formal optimization provides a principled approach to problem modeling with convergence guarantees, at first glance, this seems to be at odds with black-box deep learning methods. A recent line of work shows that, when combined with learning-based ingredients, model-based optimization methods are effective, interpretable, and allow for generalization to a wide spectrum of applications with little or no extra training data. However, experimenting with such hybrid approaches for different tasks by hand requires domain expertise in both proximal optimization and deep learning, which is often error-prone and time-consuming. Moreover, naively unrolling these iterative methods produces lengthy compute graphs, which when differentiated via autograd techniques results in exploding memory consumption, making batch-based training challenging. In this work, we introduce ∇-Prox, a domain-specific modeling language and compiler for large-scale optimization problems using differentiable proximal algorithms. ∇-Prox allows users to specify optimization objective functions of unknowns concisely at a high level, and intelligently compiles the problem into compute and memory-efficient differentiable solvers. One of the core features of ∇-Prox is its full differentiability, which supports hybrid model- and learning-based solvers integrating proximal optimization with neural network pipelines. Example applications of this methodology include learning-based priors and/or sample-dependent inner-loop optimization schedulers, learned with deep equilibrium learning or deep reinforcement learning. With a few lines of code, we show ∇-Prox can generate performant solvers for a range of image optimization problems, including end-to-end computational optics, image deraining, and compressive magnetic resonance imaging. We also demonstrate ∇-Prox can be used in a completely orthogonal application domain of energy system planning, an essential task in the energy crisis and the clean energy transition, where it outperforms state-of-the-art CVXPY and commercial Gurobi solvers.more » « less
-
more » « less
The need for high-speed imaging in applications such as biomedicine, surveillance, and consumer electronics has called for new developments of imaging systems. While the industrial effort continuously pushes the advance of silicon focal plane array image sensors, imaging through a single-pixel detector has gained significant interest thanks to the development of computational algorithms. Here, we present a new imaging modality, deep compressed imaging via optimized-pattern scanning, which can significantly increase the acquisition speed for a single-detector-based imaging system. We project and scan an illumination pattern across the object and collect the sampling signal with a single-pixel detector. We develop an innovative end-to-end optimized auto-encoder, using a deep neural network and compressed sensing algorithm, to optimize the illumination pattern, which allows us to reconstruct faithfully the image from a small number of measurements, with a high frame rate. Compared with the conventional switching-mask-based single-pixel camera and point-scanning imaging systems, our method achieves a much higher imaging speed, while retaining a similar imaging quality. We experimentally validated this imaging modality in the settings of both continuous-wave illumination and pulsed light illumination and showed high-quality image reconstructions with a high compressed sampling rate. This new compressed sensing modality could be widely applied in different imaging systems, enabling new applications that require high imaging speeds.
-
more » « less
Rapid advancements in autonomous systems and the Internet of Things have necessitated the development of compact and low-power image sensors to bridge the gap between the digital and physical world. To that end, sub-wavelength diffractive optics, commonly known as meta-optics, have garnered significant interest from the optics and photonics community due to their ability to achieve multiple functionalities within a small form factor. Despite years of research, however, the performance of meta-optics has often remained inferior compared to that of traditional refractive optics. In parallel, computational imaging techniques have emerged as a promising path to miniaturize optical systems, albeit often at the expense of higher power and latency. The lack of desired performance from either meta-optical or computational solutions has motivated researchers to look into a jointly optimized meta-optical–digital solution. While the meta-optical front end can preprocess the scene to reduce the computational load on the digital back end, the computational back end can in turn relax requirements on the meta-optics. In this Perspective, we provide an overview of this up-and-coming field, termed here as “software-defined meta-optics.” We highlight recent contributions that have advanced the current state of the art and point out directions toward which future research efforts should be directed to leverage the full potential of subwavelength photonic platforms in imaging and sensing applications. Synergistic technology transfer and commercialization of meta-optic technologies will pave the way for highly efficient, compact, and low-power imaging systems of the future.
-
There is an increasing need for passive 3D scanning in many applications that have stringent energy constraints. In this paper, we present an approach for single frame, single viewpoint, passive 3D imaging using a phase mask at the aperture plane of a camera. Our approach relies on an end-to-end optimization framework to jointly learn the optimal phase mask and the reconstruction algorithm that allows an accurate estimation of range image from captured data. Using our optimization framework, we design a new phase mask that performs significantly better than existing approaches. We build a prototype by inserting a phase mask fabricated using photolithography into the aperture plane of a conventional camera and show compelling performance in 3D imaging.more » « less
