skip to main content


Title: Overview of Selective Oxidation of Ethylene to Ethylene Oxide by Ag Catalysts
Ethylene oxidation by Ag catalysts has been extensively investigated over the past few decades, but many key fundamental issues about this important catalytic system are still unresolved. This overview of the selective oxidation of ethylene to ethylene oxide by Ag catalysts critically examines the experimental and theoretical literature of this complex catalytic system: (i) the surface chemistry of silver catalysts (single crystal, powder/foil, and supported Ag/α-Al2O3), (ii) the role of promoters, (iii) the reaction kinetics, (iv) the reaction mechanism, (v) density functional theory (DFT), and (vi) microkinetic modeling. Only in the past few years have the modern catalysis research tools of in situ/operando spectroscopy and DFT calculations been applied to begin establishing fundamental structure−activity/selectivity relationships. This overview of the ethylene oxidation reaction by Ag catalysts covers what is known and what issues still need to be determined to advance the rational design of this important catalytic system.  more » « less
Award ID(s):
1804104
NSF-PAR ID:
10189546
Author(s) / Creator(s):
; ; ; ;
Date Published:
Journal Name:
ACS catalysis
Volume:
9
ISSN:
2155-5435
Page Range / eLocation ID:
10727−10750
Format(s):
Medium: X
Sponsoring Org:
National Science Foundation
More Like this
  1. Ethylene oxide (EO) is one of the most crucial materials in plastic industries. The traditional catalytic process requires high temperature and pressure to produce EO. A chlorine-assisted system has been reported to produce EO, but it required noble metal catalysts, which significantly increased the cost. In this work, a MOF-derived Co 3 O 4 /nitrogen-doped carbon composite (Co 3 O 4 /NC) prepared through a two-step calcination method exhibited remarkable chlorine evolution reaction (ClER) activity as compared with a commercial RuO 2 catalyst, which can be attributed to the higher specific surface area and lower resistance of its porous structure and nitrogen-doped carbon. Furthermore, the Co 3 O 4 /NC maintained a stable potential and a high faradaic efficiency throughout the 10-hour electrolysis test. 
    more » « less
  2. Single-atom catalysts based on metal–N4 moieties and anchored on carbon supports (defined as M–N–C) are promising for oxygen reduction reaction (ORR). Among those, M–N–C catalysts with 4d and 5d transition metal (TM4d,5d) centers are much more durable and not susceptible to the undesirable Fenton reaction, especially compared with 3d transition metal based ones. However, the ORR activity of these TM4d,5d–N–C catalysts is still far from satisfactory; thus far, there are few discussions about how to accurately tune the ligand fields of single-atom TM4d,5d sites in order to improve their catalytic properties. Herein, we leverage single-atom Ru–N–C as a model system and report an S-anion coordination strategy to modulate the catalyst’s structure and ORR performance. The S anions are identified to bond with N atoms in the second coordination shell of Ru centers, which allows us to manipulate the electronic configuration of central Ru sites. The S-anion-coordinated Ru–N–C catalyst delivers not only promising ORR activity but also outstanding long-term durability, superior to those of commercial Pt/C and most of the near-term single-atom catalysts. DFT calculations reveal that the high ORR activity is attributed to the lower adsorption energy of ORR intermediates at Ru sites. Metal–air batteries using this catalyst in the cathode side also exhibit fast kinetics and excellent stability. 
    more » « less
  3. Abstract

    This article reports a facile method for the synthesis of Pd‐Ru nanocages by activating the galvanic replacement reaction between Pd nanocrystals and a Ru(III) precursor with Iions. The as‐synthesized nanocages feature a hollow interior, ultrathin wall of ≈2.5 nm in thickness, and a cubic shape. Our quantitative study suggests that the reduction rate of the Ru(III) precursor can be substantially accelerated upon the introduction of Iions and then retarded as the ratio of I/Ru3+is increased. The Pd‐Ru nanocages take an alloy structure, with the Ru atoms in the nanocages crystallized in a face‐centered cubic structure instead of the hexagonal close‐packed phase taken by bulk Ru. Using Pd nanocubes with different edge lengths, the dimensions of the nanocages in the range of 6−18 nm can readily be tuned. When tested as catalysts toward the electro‐oxidation of ethylene glycol and glycerol, respectively, the Pd‐Ru cubic nanocages prepared from 18 nm Pd cubes exhibit 5.1‐ and 6.2‐fold enhancements in terms of mass activity relative to the commercial Pd/C. After 1000 cycles of accelerated durability test, the mass activities of the nanocages are still 3.3 and 3.7 times as high as that of the pristine commercial Pd/C catalyst, respectively.

     
    more » « less
  4. Abstract

    Ethylene glycol is a widely utilized commodity chemical, the production of which accounts for over 46 million tons of CO2emission annually. Here we report a paired electrocatalytic approach for ethylene glycol production from methanol. Carbon catalysts are effective in reducing formaldehyde into ethylene glycol with a 92% Faradaic efficiency, whereas Pt catalysts at the anode enable formaldehyde production through methanol partial oxidation with a 75% Faradaic efficiency. With a membrane-electrode assembly configuration, we show the feasibility of ethylene glycol electrosynthesis from methanol in a single electrolyzer. The electrolyzer operates a full cell voltage of 3.2 V at a current density of 100 mA cm−2, with a 60% reduction in energy consumption. Further investigations, using operando flow electrolyzer mass spectroscopy, isotopic labeling, and density functional theory (DFT) calculations, indicate that the desorption of a *CH2OH intermediate is the crucial step in determining the selectively towards ethylene glycol over methanol.

     
    more » « less
  5. Aqueous phase reforming (APR) of sugar alcohol molecules derived from biomass, e.g. , C x H (2x+2) O x (aq) + x H 2 O → x CO 2 (g) + (2 x + 1)H 2 (g), creates hydrogen gas sustainably, making it an important component of future bio-refineries; however, problems with the cost, activity, and selectivity of present precious metal based catalysts impede its broader adoption. Ideally, new catalysts would be designed to optimize activity and selectivity; however, a comprehensive understanding of the APR mechanism is lacking. This is complicated by the fact that the primary biomass-derived sugar alcohols are large molecules (meaning that their reaction networks are large) and because of the presence of liquid water. Water influences catalytic phenomena in multiple ways, including altering the thermodynamics of catalytic surface species and participating in catalytic reactions. Understanding the mechanism of APR requires understanding these various effects; however, computational strategies based solely on density functional theory (DFT) are computationally prohibitive for such large and complicated reaction networks. In this work, we investigate the mechanism of APR reactions in the context of glycerol reforming. To calculate the reaction network, we combine DFT calculations, force-field molecular dynamics (MD) simulations, linear scaling relations (LSRs), transition state scaling (TSS) relationships, and data from the literature into a microkinetic model. The microkinetic model is run under vacuum and aqueous phases in order to learn about the roles of water molecules on the mechanism of glycerol APR. We identify four such roles: providing surface hydroxyl groups, which promote oxidation of surface CO formed in glycerol decomposition; promoting C–H scissions; promoting O–H scissions; and inhibiting the thermodynamics of decarbonylation of C3 intermediates. 
    more » « less