skip to main content


Title: Anterior Cruciate Ligament Graft Tunnel Placement and Graft Angle Are Primary Determinants of Internal Knee Mechanics After Reconstructive Surgery
Background:

Graft placement is a modifiable and often discussed surgical factor in anterior cruciate ligament (ACL) reconstruction (ACLR). However, the sensitivity of functional knee mechanics to variability in graft placement is not well understood.

Purpose:

To (1) investigate the relationship of ACL graft tunnel location and graft angle with tibiofemoral kinematics in patients with ACLR, (2) compare experimentally measured relationships with those observed with a computational model to assess the predictive capabilities of the model, and (3) use the computational model to determine the effect of varying ACL graft tunnel placement on tibiofemoral joint mechanics during walking.

Study Design:

Controlled laboratory study.

Methods:

Eighteen participants who had undergone ACLR were tested. Bilateral ACL footprint location and graft angle were assessed using magnetic resonance imaging (MRI). Bilateral knee laxity was assessed at the completion of rehabilitation. Dynamic MRI was used to measure tibiofemoral kinematics and cartilage contact during active knee flexion-extension. Additionally, a total of 500 virtual ACLR models were created from a nominal computational knee model by varying ACL footprint locations, graft stiffness, and initial tension. Laxity tests, active knee extension, and walking were simulated with each virtual ACLR model. Linear regressions were performed between internal knee mechanics and ACL graft tunnel locations and angles for the patients with ACLR and the virtual ACLR models.

Results:

Static and dynamic MRI revealed that a more vertical graft in the sagittal plane was significantly related ( P < .05) to a greater laxity compliance index ( R2= 0.40) and greater anterior tibial translation and internal tibial rotation during active knee extension ( R2= 0.22 and 0.23, respectively). Similarly, knee extension simulations with the virtual ACLR models revealed that a more vertical graft led to greater laxity compliance index, anterior translation, and internal rotation ( R2= 0.56, 0.26, and 0.13). These effects extended to simulations of walking, with a more vertical ACL graft inducing greater anterior tibial translation, ACL loading, and posterior migration of contact on the tibial plateaus.

Conclusion:

This study provides clinical evidence from patients who underwent ACLR and from complementary modeling that functional postoperative knee mechanics are sensitive to graft tunnel locations and graft angle. Of the factors studied, the sagittal angle of the ACL was particularly influential on knee mechanics.

Clinical Relevance:

Early-onset osteoarthritis from altered cartilage loading after ACLR is common. This study shows that postoperative cartilage loading is sensitive to graft angle. Therefore, variability in graft tunnel placement resulting in small deviations from the anatomic ACL angle might contribute to the elevated risk of osteoarthritis after ACLR.

 
more » « less
NSF-PAR ID:
10201404
Author(s) / Creator(s):
 ;  ;  ;  ;  ;  ;  
Publisher / Repository:
SAGE Publications
Date Published:
Journal Name:
The American Journal of Sports Medicine
Volume:
48
Issue:
14
ISSN:
0363-5465
Page Range / eLocation ID:
p. 3503-3514
Format(s):
Medium: X
Sponsoring Org:
National Science Foundation
More Like this
  1. Background:

    Thigh muscle weakness after anterior cruciate ligament reconstruction (ACLR) can persist after returning to activity. While resistance training can improve muscle function, “nonfunctional” training methods are not optimal for inducing transfer of benefits to activities such as walking. Here, we tested the feasibility of a novel functional resistance training (FRT) approach to restore strength and function in an individual with ACLR.

    Hypothesis:

    FRT would improve knee strength and function after ACLR.

    Study Design:

    Case report.

    Level of Evidence:

    Level 5.

    Methods:

    A 15-year-old male patient volunteered for an 8-week intervention where he performed 30 minutes of treadmill walking, 3 times per week, while wearing a custom-designed knee brace that provided resistance to the thigh muscles of his ACLR leg. Thigh strength, gait mechanics, and corticospinal and spinal excitability were assessed before and immediately after the 8-week intervention. Voluntary muscle activation was evaluated immediately after the intervention.

    Results:

    Knee extensor and flexor strength increased in the ACLR leg from pre- to posttraining (130 to 225 N·m [+74%] and 44 to 88 N·m [+99%], respectively) and increases in between-limb extensor and flexor strength symmetry (45% to 92% [+74%] and 47% to 72% [+65%], respectively) were also noted. After the intervention, voluntary muscle activation in the ACLR leg was 72%, compared with the non-ACLR leg at 75%. Knee angle and moment during late stance phase decreased (ie, improved) in the ACLR leg and appeared more similar to the non-ACLR leg after FRT training (18° to 14° [−23.4] and 0.07 to −0.02 N·m·kg−1·m−1[−122.8%], respectively). Corticospinal and spinal excitability in the ACLR leg decreased (3511 to 2511 [−28.5%] and 0.42 to 0.24 [−43.7%], respectively) from pre- to posttraining.

    Conclusion:

    A full 8 weeks of FRT that targeted both quadriceps and hamstring muscles lead to improvements in strength and gait, suggesting that FRT may constitute a promising and practical alternative to traditional methods of resistance training.

    Clinical Relevance:

    FRT may serve as a viable approach to improve knee strength and function after ACL reconstruction.

     
    more » « less
  2. Background:

    Quadriceps weakness is common after anterior cruciate ligament (ACL) reconstruction and can alter gait mechanics. Functional resistance training (FRT) is a novel approach to retraining strength after injury, but it is unclear how it alters gait mechanics. Therefore, we tested how 3 different types of FRT devices: a knee brace resisting extension (unidirectional brace), a knee brace resisting extension and flexion (bidirectional brace), and an elastic band pulling backwards on the ankle (elastic band)–acutely alter gait kinetics in this population.

    Hypothesis:

    The type of FRT device will affect ground-reaction forces (GRFs) during and after the training. Specifically, the uni- and bidirectional braces will increase GRFs when compared with the elastic band.

    Study Design:

    Crossover study.

    Level of Evidence:

    Level 2.

    Methods:

    A total of 15 individuals with ACL reconstruction received FRT with each device over 3 separate randomized sessions. During training, participants walked on a treadmill while performing a tracking task with visual feedback. Sessions contained 5 training trials (180 seconds each) with rest between. Vertical and anterior-posterior GRFs were assessed on the ACL-reconstructed leg before, during, and after training. Changes in GRFs were compared across devices using 1-dimensional statistical parametric mapping.

    Results:

    Resistance applied via bidirectional brace acutely increased gait kinetics during terminal stance/pre-swing (ie, push-off), while resistance applied via elastic band acutely increased gait kinetics during initial contact/loading (ie, braking). Both braces behaved similarly, but the unidirectional brace was less effective for increasing push-off GRFs.

    Conclusion:

    FRT after ACL reconstruction can acutely alter gait kinetics during training. Devices can be applied to selectively alter gait kinetics. However, the long-term effects of FRT after ACL reconstruction with these devices are still unknown.

    Clinical Relevance:

    FRT may be applied to alter gait kinetics of the involved limb after ACL reconstruction, depending on the device used.

     
    more » « less
  3. Abstract

    Following anterior cruciate ligament (ACL) reconstruction surgery, a staged repair response occurs where cells from outside the tendon graft participate in tunnel integration. The mechanisms that regulate this process, including the specific cellular origin, are poorly understood. Embryonic cells expressing growth and differentiation factor 5 (GDF5) give rise to several mesenchymal tissues in the joint and epiphyses. We hypothesized that cells from a GDF5 origin, even in the adult tissue, would give rise to cells that contribute to the stages of repair. ACLs were reconstructed inGdf5‐Cre;R26R‐tdTomato lineage tracing mice to monitor the contribution ofGdf5‐Cre;tdTom+cells to the tunnel integration process. Anterior−posterior drawer tests demonstrated 58% restoration in anterior−posterior stability.Gdf5‐Cre;tdTom+cells within the epiphyseal bone marrow adjacent to tunnels expanded in response to the injury by 135‐fold compared with intact controls to initiate tendon‐to‐bone attachments. They continued to mature the attachments yielding zonal insertion sites at 4 weeks with collagen fibers spanning across unmineralized and mineralized fibrocartilage and anchored to the adjacent bone. The zonal attachments possessed tidemarks with concentrated alkaline phosphatase activity similar to native entheses. This study established that mesenchymal cells from a GDF5 origin can contribute to zonal tendon‐to‐bone attachments within bone tunnels following ACL reconstruction.

     
    more » « less
  4. Objective

    Severe subglottic stenosis develops as a response to intubation in 1% of the >200,000 neonatal intensive care unit infants per year and may require laryngotracheal reconstruction (LTR) with autologous hyaline cartilage. Although effective, LTR is limited by comorbidities, severity of stenosis, and graft integration. In children, there is a significant incidence of restenosis requiring revision surgery. Tissue engineering has been proposed to develop alterative grafting options to improve outcomes and eliminate donor‐site morbidity. Our objective is to engineer a decellularized, channel‐laden xenogeneic cartilage graft, that we deployed in a proof‐of‐concept, neonatal porcine LTR model.

    Methods

    Meniscal porcine cartilage was freeze–thawed and washed with pepsin/elastase to decellularize and create microchannels. A 6 × 10‐mm decellularized cartilage graft was then implanted in 4 infant pigs in an anterior cricoid split. Airway patency and host response were monitored endoscopically until sacrifice at 12 weeks, when the construct phenotype, cricoid expansion, mechanics, and histomorphometry were evaluated.

    Results

    The selective digestion of meniscal components yielded decellularized cartilage with cell‐size channels. After LTR with decellularized meniscus, neonatal pigs were monitored via periodic endoscopy observing re‐epithelization, integration, and neocartilage formation. At 12 weeks, the graft appeared integrated and exhibited airway expansion of 4 mm in micro‐CT and endoscopy. Micro‐CT revealed a larger lumen compared with age‐matched controls. Finally, histology showed significant neocartilage formation.

    Conclusion

    Our neonatal porcine LTR model with a decellularized cartilage graft is a novel approach to tissue engineered pediatric LTR. This pilot study sets the stage for “off‐the‐shelf” graft procurement and future optimization of MEND for LTR.

    Level of Evidence

    NALaryngoscope, 134:807–814, 2024

     
    more » « less
  5. Osteoarthritis of the knee is increasingly prevalent as our population ages, representing an increasing financial burden, and severely impacting quality of life. The invasiveness of in vivo procedures and the high cost of cadaveric studies has left computational tools uniquely suited to study knee biomechanics. Developments in deep learning have great potential for efficiently generating large-scale datasets to enable researchers to perform population-sized investigations, but the time and effort associated with producing robust hexahedral meshes has been a limiting factor in expanding finite element studies to encompass a population. Here we developed a fully automated pipeline capable of taking magnetic resonance knee images and producing a working finite element simulation. We trained an encoder-decoder convolutional neural network to perform semantic image segmentation on the Imorphics dataset provided through the Osteoarthritis Initiative. The Imorphics dataset contained 176 image sequences with varying levels of cartilage degradation. Starting from an open-source swept-extrusion meshing algorithm, we further developed this algorithm until it could produce high quality meshes for every sequence and we applied a template-mapping procedure to automatically place soft-tissue attachment points. The meshing algorithm produced simulation-ready meshes for all 176 sequences, regardless of the use of provided (manually reconstructed) or predicted (automatically generated) segmentation labels. The average time to mesh all bones and cartilage tissues was less than 2 min per knee on an AMD Ryzen 5600X processor, using a parallel pool of three workers for bone meshing, followed by a pool of four workers meshing the four cartilage tissues. Of the 176 sequences with provided segmentation labels, 86% of the resulting meshes completed a simulated flexion-extension activity. We used a reserved testing dataset of 28 sequences unseen during network training to produce simulations derived from predicted labels. We compared tibiofemoral contact mechanics between manual and automated reconstructions for the 24 pairs of successful finite element simulations from this set, resulting in mean root-mean-squared differences under 20% of their respective min-max norms. In combination with further advancements in deep learning, this framework represents a feasible pipeline to produce population sized finite element studies of the natural knee from subject-specific models. 
    more » « less