More Like this

1. Widely separated optical Kerr parametric oscillation in AlN microrings

   https://doi.org/10.1364/OL.384317  

   Tang, Yulong ; Gong, Zheng ; Liu, Xianwen ; Tang, Hong X. ( February 2020 , Optics Letters)

   Here, we report${\mathrm{\chi <\#comment/>}}^{(3)}$-based optical parametric oscillation (OPO) with widely separated signal–idler frequencies from crystalline aluminum nitride microrings pumped at$2\text{µ<\#comment/>}\mathrm{m}$. By tailoring the width of the microring, OPO reaching toward the telecom and mid-infrared bands with a frequency separation of 64.2 THz is achieved. While dispersion engineering through changing the microring width is capable of shifting the OPO sideband by$><\#comment/>9\mathrm{T}\mathrm{H}\mathrm{z}$, the OPO frequency can also be agilely tuned in the ranges of 1 and 0.1 THz, respectively, by shifting the pump wavelength and controlling the chip’s temperature. At high pump powers, the OPO sidebands further evolve into localized frequency comb lines. Such large-frequency-shift OPO with flexible wavelength tunability will lead to enhanced chip-scale light sources.

    

   more » « less
2. Demonstration of using two aperture pairs combined with multiple-mode receivers and MIMO signal processing for enhanced tolerance to turbulence and misalignment in a 10  Gbit/s QPSK FSO link

   https://doi.org/10.1364/OL.391120  

   Song, Haoqian ; Li, Long ; Pang, Kai ; Zhang, Runzhou ; Zou, Kaiheng ; Zhao, Zhe ; Du, Jing ; Song, Hao ; Liu, Cong ; Cao, Yinwen ; et al ( May 2020 , Optics Letters)

   We utilize aperture diversity combined with multiple-mode receivers and multiple-input-multiple-output (MIMO) digital signal processing (DSP) to demonstrate enhanced tolerance to atmospheric turbulence and spatial misalignment in a 10 Gbit/s quadrature-phase-shift-keyed (QPSK) free-space optical (FSO) link. Turbulence and misalignment could cause power coupling from the fundamental Gaussian mode into higher-order modes. Therefore, we detect power from multiple modes and use MIMO DSP to enhance the recovery of the original data. In our approach, (a) each of multiple transmitter apertures transmits a single fundamental Gaussian beam carrying the same data stream, (b) each of multiple receiver apertures detects the signals that are coupled from the fundamental Gaussian beams to multiple orbital angular momentum (OAM) modes, and (c) MIMO DSP is used to recover the data over multiple modes and receivers. Our simulation shows that the outage probability could be reduced from$><\#comment/>0.1$to$<<\#comment/>0.01$. Moreover, we experimentally demonstrate the scheme by transmitting two fundamental Gaussian beams carrying the same data stream and recovering the signals on OAM modes 0 and$+1$at each receiver aperture. We measure an up to$\sim <\#comment/>10\mathrm{d}\mathrm{B}$power-penalty reduction for a bit error rate (BER) at the 7% forward error correction limit for a 10 Gbit/s QPSK signal.

    

   more » « less
3. “Hiding” a low-intensity 50  Gbit/s QPSK free-space OAM beam using an orthogonal coaxial high-intensity 50  Gbit/s QPSK beam

   https://doi.org/10.1364/AO.396386  

   Song, Haoqian ; Almaiman, Ahmed ; Song, Hao ; Zhao, Zhe ; Zhang, Runzhou ; Pang, Kai ; Liu, Cong ; Li, Long ; Manukyan, Karapet ; Zach, Shlomo ; et al ( August 2020 , Applied Optics)

   In this paper, we experimentally demonstrate an approach that “hides” a low-intensity 50 Gbit/s quadrature-phase-keying (QPSK) free-space optical beam when it coaxially propagates on the same wavelength with an orthogonal high-intensity 50 Gbit/s QPSK optical beam. Our approach is to coaxially transmit the strong and weak beams carrying different orthogonal spatial modes within a modal basis set, e.g., orbital angular momentum (OAM) modes. Although the weak beam has much lower power than that of the strong beam, and the beams are in the same frequency band and on the same polarization, the two beams can still be effectively demultiplexed with little inherent crosstalk at the intended receiver due to their spatial orthogonality. However, an eavesdropper may not readily identify the weak beam when simply analyzing the spatial intensity profile. The correlation coefficient between the intensity profiles of the strong beam and the combined strong and weak beams is measured to characterize the potential for “hiding” a weak beam when measuring intensity profiles. Such a correlation coefficient is demonstrated to be higher than 0.997 when the power difference between the strong fundamental Gaussian beam and the weak OAM beam is$\sim <\#comment/>8,\sim <\#comment/>10$, and$\sim <\#comment/>10\mathrm{d}\mathrm{B}$for the weak OAM$-<\#comment/>1,-<\#comment/>2$, and$-<\#comment/>3$beams, respectively. Moreover, a 50 Gbit/s QPSK data link having its$Q$factor above the 7% forward error correction limit is realized when the power of the weak OAM$-<\#comment/>3$beam is 30 dB lower than that of the strong fundamental Gaussian beam.

    

   more » « less
4. Utilizing adaptive optics to mitigate intra-modal-group power coupling of graded-index few-mode fiber in a 200-Gbit/s mode-division-multiplexed link

   https://doi.org/10.1364/OL.394307  

   Zhang, Runzhou ; Song, Hao ; Song, Haoqian ; Zhao, Zhe ; Milione, Giovanni ; Pang, Kai ; Du, Jing ; Li, Long ; Zou, Kaiheng ; Zhou, Huibin ; et al ( June 2020 , Optics Letters)

   We experimentally demonstrate the utilization of adaptive optics (AO) to mitigate intra-group power coupling among linearly polarized (LP) modes in a graded-index few-mode fiber (GI FMF). Generally, in this fiber, the coupling between degenerate modes inside a modal group tends to be stronger than between modes belonging to different groups. In our approach, the coupling inside the${\mathrm{L}\mathrm{P}}_{11}$group can be represented by a combination of orbital-angular-momentum (OAM) modes, such that reducing power coupling in OAM set tends to indicate the capability to reduce the coupling inside the${\mathrm{L}\mathrm{P}}_{11}$group. We employ two output OAM modes$l=+1$and$l=-<\#comment/>1$as resultant linear combinations of degenerate${\mathrm{L}\mathrm{P}}_{11\mathrm{a}}$and${\mathrm{L}\mathrm{P}}_{11\mathrm{b}}$modes inside the${\mathrm{L}\mathrm{P}}_{11}$group of a$\sim <\#comment/>0.6\text{-}\mathrm{k}\mathrm{m}$GI FMF. The power coupling is mitigated by shaping the amplitude and phase of the distorted OAM modes. Each OAM mode carries an independent 20-, 40-, or 100-Gbit/s quadrature-phase-shift-keying data stream. We measure the transmission matrix (TM) in the OAM basis within${\mathrm{L}\mathrm{P}}_{11}$group, which is a subset of the full LP TM of the FMF-based system. An inverse TM is subsequently implemented before the receiver by a spatial light modulator to mitigate the intra-modal-group power coupling. With AO mitigation, the experimental results for$l=+1$and$l=-<\#comment/>1$modes show, respectively, that (i) intra-modal-group crosstalk is reduced by$><\#comment/>5.8\mathrm{d}\mathrm{B}$and$><\#comment/>5.6\mathrm{d}\mathrm{B}$and (ii) near-error-free bit-error-rate performance is achieved with a penalty of$\sim <\#comment/>0.6\mathrm{d}\mathrm{B}$and$\sim <\#comment/>3.8\mathrm{d}\mathrm{B}$, respectively.

    

   more » « less
5. Direct chip-scale optical frequency divider via regenerative harmonic injection locking

   https://doi.org/10.1364/OL.413335  

   Bustos-Ramirez, Ricardo ; Trask, Lawrence R. ; Bhardwaj, Ashish ; Hoefler, Gloria E. ; Kish, Fred A. ; Delfyett, Peter J. ( February 2021 , Optics Letters)

   A novel optical frequency division technique, called regenerative harmonic injection locking, is used to transfer the timing stability of an optical frequency comb with a repetition rate in the millimeter wave range ($\sim <\#comment/>300\mathrm{G}\mathrm{H}\mathrm{z}$) to a chip-scale mode-locked laser with a$\sim <\#comment/>10\mathrm{G}\mathrm{H}\mathrm{z}$repetition rate. By doing so, the 300 GHz optical frequency comb is optically divided by a factor of$30\times <\#comment/>$to 10 GHz. The stability of the mode-locked laser after regenerative harmonic injection locking is$\sim <\#comment/>{10}^{-<\#comment/>12}$at 1 s with a$1/\mathrm{\tau <\#comment/>}$trend. To facilitate optical frequency division, a coupled opto-electronic oscillator is implemented to assist the injection locking process. This technique is exceptionally power efficient, as it uses less than$100\text{µ<\#comment/>}\mathrm{W}$of optical power to achieve stable locking.

    

   more » « less