For brittle friction and rock deformation, the coefficient
The operation of fracture, diffusion, and intracrystalline‐plastic micromechanisms during semibrittle deformation of rock is directly relevant to understanding mechanical behavior across the brittle‐plastic transition in the crust. An outstanding question is whether (1) the micromechanisms of semibrittle flow can be considered to operate independently, as represented in typical crustal strength profiles across the brittle to plastic transition, or (2) the micromechanisms are coupled such that the transition is represented by a distinct rheology with dependency on effective pressure, temperature, and strain rate. We employ triaxial stress‐cycling experiments to investigate elastic‐plastic and viscoelastic behaviors during semibrittle flow in two distinctly different monomineralic, polycrystalline, synthetic salt‐rocks. During semibrittle flow at high differential stress, granular, low‐porosity, work‐hardened salt‐rocks deform predominantly by grain‐boundary sliding and wing‐crack opening accompanied by minor intragranular dislocation glide. In contrast, fully annealed, near‐zero porosity salt‐rocks flow at lower differential stress by intragranular dislocation glide accompanied by grain‐boundary sliding and opening. Grain‐boundary sliding is frictional during semibrittle flow at higher strain rates, but the associated dispersal of water from fluid inclusions along boundaries can activate fluid‐assisted diffusional sliding at lower strain rates. Changes in elastic properties with semibrittle flow largely reflect activation of sliding along closed grain boundaries. Observed microstructures, pronounced hysteresis and anelasticity during cyclic stressing after semibrittle flow, and stress relaxation behaviors indicate coupled operation of micromechanisms leading to a distinct rheology (hypothesis 2 above).
more » « less- Award ID(s):
- 1361996
- NSF-PAR ID:
- 10452730
- Publisher / Repository:
- DOI PREFIX: 10.1029
- Date Published:
- Journal Name:
- Journal of Geophysical Research: Solid Earth
- Volume:
- 126
- Issue:
- 2
- ISSN:
- 2169-9313
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
Test of the Effective Stress Law for Semibrittle Deformation Using Isostatic and Triaxial Load Pathsmore » « less
Abstract α in the general effective stress relationσ e =σ −αP p can be approximated as unity with sufficient accuracy. However, it is uncertain ifα deviates from unity for semibrittle flow when both brittle and intracrystalline‐plastic deformation is involved. We conducted triaxial and isostatic compression experiments on synthetic salt‐rocks (∼300 ppm water) at room temperature to test the effective stress relation in the semibrittle regime using silicone oil and argon gas as pore fluids. Confining and pore pressures were cycled while their difference (differential pressure) was kept constant, such that changes in the mechanical behavior would indicate deviation ofα from unity. Microstructural observations were used to determine the dependence ofα on true area of grain contact from asperity yielding. In triaxial compression experiments, semibrittle flow involves grain boundary cracking and sliding, and intragranular dislocation glide and cracking. Flow strength remains constant for changes in pore fluid pressure of more than two orders of magnitude. In isostatic compression experiments, samples show combined processes of microcracking, grain boundary sliding, dislocation glide, and fluid‐assisted grain boundary migration recrystallization. Volumetric strain depends directly on the differential pressures (i.e.,α equals one). Analysis of grain‐contact area in both experiments indicates thatα is independent of the true area of contact defined by plastic yielding at grain boundaries. The observation ofα effectively equals one may be explained by operation of pressure‐independent intracrystalline‐plastic mechanisms and transmission of pore pressure at grain boundaries through thin fluid films. -
more » « less
Abstract Large earthquakes and slow slip events typically nucleate along plate boundaries near the depth limit of the seismogenic zone, which is also recognized as the brittle‐plastic transition zone (BPT). High
V p /V s ratios are commonly observed at the BPT in subduction zones, indicating the presence of aqueous fluid in pore spaces. We conducted experiments to investigate the rheology of quartz with different fluid fractions at deformation conditions that cross the BPT. The strengths of quartz aggregates with fluid‐filled porosities of 5–25 vol% are significantly lower than predicted by wet quartzite flow laws, and decrease with increasing fluid fraction. Recovered samples deformed in the ductile regime exhibit S‐C´ mylonitic structures characterized by elongate grains, shear localization and fluid segregation. Variations in strength are explained by a combination of a constitutive law for dislocation creep that includes the geometric effects of fluid fraction, a friction law that includes the effect of fluid fraction through its role on the real area of contact, and an empirical function to describe the smooth brittle‐plastic transition. Our results indicate that the presence of fluid‐filled porosity promotes significant weakening in shear zones, and that variations in fluid fraction (together with temperature) can explain transitions in the spectrum of slip behaviors observed along plate boundaries. -
The strength of lithospheric plates is a central component of plate tectonics, governed by brittle processes in the shallow portion of the plate and ductile behavior in the deeper portion. We review experimental constraints on ductile deformation of olivine, the main mineral in the upper mantle and thus the lithosphere. Olivine deforms by four major mechanisms: low-temperature plasticity, dislocation creep, dislocation-accommodated grain-boundary sliding (GBS), and diffusion-accommodated grain-boundary sliding (diffusion creep). Deformation in most of the lithosphere is dominated by GBS, except in shear zones—in which diffusion creep dominates—and in the brittle-ductile transition—in which low-temperature plasticity may dominate. We find that observations from naturally deformed rocks are consistent with extrapolation of the experimentally constrained olivine flow laws to geological conditions but that geophysical observations predict a weaker lithosphere. The causes of this discrepancy are unresolved but likely reside in the uncertainty surrounding processes in the brittle-ductile transition, at which the lithosphere is strongest. ▪ Ductile deformation of the lithospheric mantle is constrained by experimental data for olivine. ▪ Olivine deforms by four major mechanisms: low-temperature plasticity, dislocation creep, dislocation-accommodated grain-boundary sliding, and diffusion creep. ▪ Observations of naturally deformed rocks are consistent with extrapolation of olivine flow laws from experimental conditions. ▪ Experiments predict stronger lithosphere than geophysical observations, likely due to gaps in constraints on deformation in the brittle-ductile transition.more » « less
-
Abstract Fluids are commonly invoked as the primary cause for weakening of detachment shear zones. However, fluid-related mechanisms such as pressure-solution, reaction-enhanced ductility, reaction softening and precipitation of phyllosilicates are not fully understood. Fluid-facilitated reaction and mass transport cause rheological weakening and strain localization, eventually leading to departure from failure laws derived in laboratory experiments. This study focuses on the Miocene Raft River detachment shear zone in northwestern Utah. The shear zone is localized in the Proterozoic Elba Quartzite, which unconformably overlies the Archaean basement, and consists of an alternating sequence of quartzite and muscovite-quartzite schist. In this study, we characterize fluid-related microstructures to constrain conditions that promoted brittle failure in a plastically deforming shear zone. Thin-section analyses reveal the presence of healed microcracks, transgranular fluid inclusion planes and grain boundary fluid inclusion clusters. Healed microcracks occur in three sets, one sub-perpendicular to the mylonitic foliation, and a set of two conjugate microcracks oriented at ∼40–60° to the mylonitic foliation. Healed microfractures are filled with quartz, which has a distinct fabric, suggesting that microcracks healed while the shear zone was still at conditions favourable for quartz crystal plasticity. Transgranular fluid inclusion planes also occur in three sets, similar in orientation to the healed microfractures. Fluid inclusions commonly decorate grain and subgrain boundaries as inter- and intragranular clusters. Our results document ductile overprint of brittle microstructures, suggesting that, during exhumation, the Raft River detachment shear zone crossed the brittle–ductile transition repeatedly, providing pathways for fluids to permeate through this shear zone.more » « less
-
more » « less
Abstract Seismic anisotropy produced by aligned olivine in oceanic lithosphere offers a window into mid‐ocean ridge (MOR) dynamics. Yet, interpreting anisotropy in the context of grain‐scale deformation processes and strain observed in laboratory experiments and natural olivine samples has proven challenging due to incomplete seismological constraints and length scale differences spanning orders of magnitude. To bridge this observational gap, we estimate an in situ elastic tensor for oceanic lithosphere using co‐located compressional‐ and shear‐wavespeed anisotropy observations at the NoMelt experiment located on ∼70 Ma seafloor. The elastic model for the upper 7 km of the mantle, NoMelt_SPani7, is characterized by a fast azimuth parallel to the fossil‐spreading direction, consistent with corner‐flow deformation fabric. We compare this model with a database of 123 petrofabrics from the literature to infer olivine crystallographic orientations and shear strain accumulated within the lithosphere. Direct comparison to olivine deformation experiments indicates strain accumulation of 250%–400% in the shallow mantle. We find evidence for D‐type olivine lattice‐preferred orientation (LPO) with fast [100] parallel to the shear direction and girdled [010] and [001] crystallographic axes perpendicular to shear. D‐type LPO implies similar amounts of slip on the (010)[100] and (001)[100] easy slip systems during MOR spreading; we hypothesize that grain‐boundary sliding during dislocation creep relaxes strain compatibility, allowing D‐type LPO to develop in the shallow lithosphere. Deformation dominated by dislocation‐accommodated grain‐boundary sliding (disGBS) has implications for in situ stress and grain size during MOR spreading and implies grain‐size dependent deformation, in contrast to pure dislocation creep.
