Floodplains provide important ecological, hydrological, and geomorphic functions within river corridors. During overbank flows, complex hydrodynamic conditions occur as water exits and re‐enters the channel and interacts with hydraulically rough floodplain vegetation. However, the extent to which floodplain vegetation influences channel‐altering hydrodynamic forces and thus bedform topography and sediment transport is poorly understood. We address this knowledge gap and present the results of flume experiments where we measured bedform topography under varied floodplain vegetation conditions at two overbank flow relative depths. The experiments were conducted in a 1‐m wide meandering compound channel inset in a 15.4 long, 4.9‐m wide basin. The channel bed was a mobile sand‐and‐gravel mixture with a median sediment size of 3.3 mm, and sediment transport occurred only within the channel. We tested bare and vegetated floodplain conditions with 2.7‐cm diameter rigid emergent vegetation elements at spacings of 3.0 and 12.1 units m−2. We performed a moving‐window analysis of topographic surface metrics including skewness, coefficient of variation, and standard deviation, as well as topographic patch analysis of area and contagion to measure changes in bedform heterogeneity as flow depth and vegetation density were varied. Our results show that both greater density vegetation and larger flows can increase bedform topographic heterogeneity. These findings suggest that floodplain vegetation and natural hydrologic regimes that include overbank flows can enhance stream habitat complexity. Designing for the effects of established vegetation conditions and prioritizing floodplain vegetation planting may be useful for river managers striving to achieve successful biomic river restoration.
Meandering river floodplains often contain intermittently flooded complex channel networks. Many questions remain as to the pervasiveness, function, and evolution of these floodplain channels. In this present work, we analyzed size‐specific sediment transport potential and assessed whether the channelized floodplain of the meandering East Fork White River near Seymour, Indiana is on a net erosional or depositional trajectory. We applied a two‐dimensional hydrodynamic model and used simulated model results to estimate the largest sediment size that can be moved in suspension and as bedload at various flows for grain size classes between 4 µm and 64 mm. We developed a probabilistic method that integrates the largest sediment size that can be moved at various flows to compute an effective grain size, which we compared to measured field data. Results show that the river is capable of supplying sand to the floodplain and these floodplain channels can transport sand in suspension and gravel as bedload. This suggests that sediment supplied from the river could be transported as bedload in floodplain channels. These floodplain channels are supply limited under the current hydrologic regime and the grain size distribution of the bed surface is set by the flow conditions; thus, these floodplain channels are net erosional. Finally, our proposed method of probabilistically integrating the largest sediment size that can be moved at various flows can be used to predict the upper end of the grain size distribution in suspension and in bed material, which is applicable to floodplains as well as coastal areas.
more » « less- Award ID(s):
- 1911321
- NSF-PAR ID:
- 10442529
- Publisher / Repository:
- DOI PREFIX: 10.1029
- Date Published:
- Journal Name:
- Water Resources Research
- Volume:
- 57
- Issue:
- 5
- ISSN:
- 0043-1397
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
more » « less
Abstract -
more » « less
Fine-grained sediment (grain size under 2,000 μm) builds floodplains and deltas, and shapes the coastlines where much of humanity lives. However, a universal, physically based predictor of sediment flux for fine-grained rivers remains to be developed. Herein, a comprehensive sediment load database for fine-grained channels, ranging from small experimental flumes to megarivers, is used to find a predictive algorithm. Two distinct transport regimes emerge, separated by a discontinuous transition for median bed grain size within the very fine sand range (81 to 154 μm), whereby sediment flux decreases by up to 100-fold for coarser sand-bedded rivers compared to river with silt and very fine sand beds. Evidence suggests that the discontinuous change in sediment load originates from a transition of transport mode between mixed suspended bed load transport and suspension-dominated transport. Events that alter bed sediment size near the transition may significantly affect fluviocoastal morphology by drastically changing sediment flux, as shown by data from the Yellow River, China, which, over time, transitioned back and forth 3 times between states of high and low transport efficiency in response to anthropic activities.
-
more » « less
Abstract We present a simple modeling framework for the codetermination of bankfull discharge and corresponding bankfull channel geometry (width, depth, and longitudinal channel slope) of an alluvial meandering river. We specifically consider a sand‐bed river whose floodplain is capped by a mud‐rich layer. We inquire as to how the wide spectrum of flows to which the river is subjected leads to the establishment of specific values for bankfull discharge and associated bankfull geometry. Here we provide a physically based predictor of bankfull discharge that goes beyond the simple assumption of the 1.5‐year flood discharge. We do this using physics‐based submodels for channel and floodplain processes. We show that bankfull discharge and bankfull geometry are established as a result of (i) floodplain vertical accretion due to overbank deposition, (ii) migration of the inner bank and outer cut bank, (iii) net removal of floodplain sediment and reduction in average floodplain height due to lateral channel shift, and (iv) in‐channel downstream bed material transport. The flow duration curve is employed to quantify the effect of these processes, as well as to account for flow variability. Our model captures the spatiotemporal evolution of bankfull discharge, depth, width, and down‐channel slope toward equilibrium for specified flow duration curve and watershed characteristics. Our new framework can be used for assessing long‐term river response to change in sediment supply or flow duration curve. A model implementation is presented for the case of the Trinity River, TX, USA, to demonstrate the use of the model and its behavior.
-
more » « less
Abstract Turbidity current and coastal storm deposits are commonly characterized by a basal sandy massive (structureless) unit overlying an erosional surface and underlying a parallel or cross‐laminated unit. Similar sequences have been recently identified in fluvial settings as well. Notwithstanding field, laboratory and numerical studies, the mechanisms for emplacement of these massive basal units are still under debate. It is well accepted that the sequence considered here can be deposited by waning‐energy flows, and that the parallel‐laminated units are deposited under transport conditions corresponding to upper plane bed at the dune–antidune transition. Thus, transport conditions that are more intense than those at the dune–antidune transition should deposit massive units. This study presents experimental, open‐channel flow results showing that sandy massive units can be the result of gradual deposition from a thick bedload layer of colliding grains called sheet flow layer. When this layer forms with relatively coarse sand, the non‐dimensional bed shear stress associated with skin friction, the Shields number, is larger than a threshold value approximately equal to 0·4. For values of the Shields number smaller than 0·4 the sheet flow layer disappeared, sediment was transported by a standard bedload layer one or two grain diameters thick, and the bed configuration was characterized by downstream migrating antidunes and washed out dunes. Parallel laminae were found in deposits emplaced with standard bedload transport demonstrating that the same dilute flow can gradually deposit the basal and the parallel‐laminated unit in presence of traction at the depositional boundary. Further, the experiments suggested that two different types of upper plane bed conditions can be defined, one associated with standard bedload transport at the dune–antidune transition, and the other associated with bedload transport in sheet flow mode at the transition between upstream and downstream migrating antidunes.
-
more » « less
Abstract Entrainment and suspension of sediment particles with the size distribution similar to a range of natural sands were simulated with a focus on the vertical size sorting and transport dynamics in response to different wave conditions. The simulations were performed using a two‐phase Eulerian‐Lagrangian model by combining the LIGGGHTS discrete element method solver for sediment and SedFoam solver for the fluid phase. The model was first validated for a range of sand grain sizes from 0.21 to 0.97 mm having well‐sorted and mixed (bimodal) size distributions using laboratory oscillatory flow data. Three sediment bed configurations were studied under a wide range of velocity‐skewed waves with different wave intensity and skewness. It was found that the bimodal distribution having only 30% of coarse fraction and 70% of medium fraction responds similar to a well‐sorted coarse sand configuration. Sediment fluxes of the bimodal distribution were slightly higher than those of well‐sorted coarse sand because of the pronounced inverse grading in the bimodal distribution. Furthermore, for the bimodal distribution the medium fraction acted as a relatively smooth foundation underneath the coarse fraction which facilitated the mobilization of the coarser particles. Under high energy wave conditions, the smoothing feature was exacerbated and further caused the formation of plug flow where a thick layer of intense sediment flux was observed. Model results also showed that under high skewness waves, phase‐lag effect occurred in well‐sorted medium sand which caused lower net onshore sediment transport rates but the effect was significantly reduced for mixed sediments.
