Using Ag nanowires (NWs) is a promising approach to make flexible and transparent conducting electrodes for organic photovoltaics (OPVs). However, the roughness of the NWs can decrease device performance. Herein, a Ag NW electrode embedded in a UV‐curable epoxy that uses a simple mechanical lift‐off process resulting in highly planar electrodes is demonstrated. A bimodal blend of Ag NWs with varying aspect ratios is used to optimize the transparency and conductivity of the electrode. In addition, a ZnO layer is coated on the Ag NWs prior to the embedding process to ensure low contact resistance in the OPV cells. The resulting resin‐embedded ZnO‐encapsulated silver nanowire (REZEN) electrode is found to have excellent mechanical stability. REZEN electrode‐based OPV cells exhibit comparable performance with reference devices, achieving maximum power conversion efficiency (PCE) of 13.5% and 13.6% respectively. The REZEN‐based OPV cells are also mechanically robust, retaining 97% of their PCE after 5000 cycles at
Here, an unobtrusive, adhesive‐integrated electrode array for continuous monitoring of stomach electric activity is introduced. This patient‐friendly, disposable peel‐and‐stick adhesive device represents an important advancement over existing arrays that require placement of each electrode individually and are thus also labor intensive and are in general more rigid and cumbersome. In comparison to other silver–silver chloride electrodes, this skin conformal array does not require gel and thus can withstand low impedance over the duration of long recordings. Interfacing these electrodes with miniaturized electronic recording and wireless telemetry systems has the potential to enable scalable population health opportunities to perform objective gastrointestinal assessment and optimization of treatment regimens.
more » « less- Award ID(s):
- 1932619
- NSF-PAR ID:
- 10453599
- Publisher / Repository:
- Wiley Blackwell (John Wiley & Sons)
- Date Published:
- Journal Name:
- Advanced Materials Technologies
- Volume:
- 6
- Issue:
- 5
- ISSN:
- 2365-709X
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
more » « less
R = 1.2 mm and 94% PCE after 1000 cycles atR = 0.55 mm. This flexibility is among the highest reported for freestanding devices. Thus, the REZEN electrode is a promising and simple strategy to achieve mechanically robust ITO‐free flexible OPV cells. -
more » « less
Abstract Electrochemical reduction of carbon dioxide (CO2) typically suffers from low selectivity and poor reaction rates that necessitate high overpotentials, which impede its possible application for CO2capture, sequestration, or carbon‐based fuel production. New strategies to address these issues include the utilization of photoexcited charge carriers to overcome activation barriers for reactions that produce desirable products. This study demonstrates surface‐plasmon‐enhanced photoelectrochemical reduction of CO2and nitrate (NO3−) on silver nanostructured electrodes. The observed photocurrent likely originates from a resonant charge transfer between the photogenerated plasmonic hot electrons and the lowest unoccupied molecular orbital (MO) acceptor energy levels of adsorbed CO2, NO3−, or their reductive intermediates. The observed differences in the resonant effects at the Ag electrode with respect to electrode potential and photon energy for CO2versus NO3−reduction suggest that plasmonic hot‐carriers interact selectively with specific MO acceptor energy levels of adsorbed surface species such as CO2, NO3−, or their reductive intermediates. This unique plasmon‐assisted charge generation and transfer mechanism can be used to increase yield, efficiency, and selectivity of various photoelectrochemical processes.
-
Dense silver (Ag) cathodes with defined triple phase boundary (TPB between the interface of electrolyte, electrode, and gas) lengths (LTPB) and electrode areas (AELT) were fabricated by photolithography and E-beam evaporation over a proton conducting BaZr0.4Ce0.4Y0.1Yb0.1O3−δ (BZCYYb4411) electrolyte. A bi-layer lift-off resist method appears to be more versatile than a single layer lift-off resist method for successful patterned cathode fabrication. The electrochemical behaviors of the patterned Ag cathodes over the BZCYYb4411 electrolyte were tested by electrochemical impedance spectroscopy (EIS) at different temperatures in atmospheres with different concentrations of O2 and H2O. The results were processed using Distribution of Relaxation Times (DRT) and reaction order analyses and also fitted to equivalent circuits. The directions for future work on patterned electrodes with different LTPB and AELT and theoretical calculations to gain further insights into the kinetics and mechanism of the cathode oxygen reduction reaction (ORR) over proton conducting electrolytes are pointed out.more » « less
-
more » « less
Semitransparent organic photovoltaics (ST‐OPVs) provide a potentially facile route for some applications in building integrated photovoltaics. One of the challenges in developing large‐scale, printable ST‐OPVs is to address the need for high‐performance and fully solution‐processed top electrodes, allowing the replacement of the evaporated thin metallic films (Ag, Au, and Al). Silver nanowire (AgNW) is considered a promising candidate for the substitution due to its excellent transparency, conductivity, and solution processability. Herein, a novel bimodal AgNW (AgNW‐BM) electrode is reported, comprising AgNWs of two different aspect ratios. It is shown that the AgNW‐BM film achieves lower sheet resistance and higher visible transmittance than each monodisperse AgNW film, respectively. Furthermore, ST‐OPVs based on PTB7‐Th:IEICO‐4F with AgNW‐BM top electrodes are fabricated, which can obtain a maximum power conversion efficiency (PCE) of 7.49% with an average visible transmittance (AVT) of 33%. The ST‐devices also demonstrate an enhanced reproducibility and excellent color‐rendering index of 90. In addition, the bimodal top electrode is successfully implemented in the PM6:Y6 system with a higher PCE of 9.79% and with an AVT of 23%, demonstrating the universality for various semiconductor systems. Our work provides a simple strategy to realize fully solution‐processed, highly efficient ST‐OPVs.
-
The nitrogen cycle plays a key role biological, energy, environment, and industrial processes. Breaking natural nitrogen cycle is leading to accumulation of reactive nitrogen chemicals in water and atmosphere, therefore, better management of N-cycle has emerged as an urgent research need in energy and environmental science. Removing excessive nitrate (NO3−) from wastewater has increasingly become an important research topic in light of the growing concerns over the related environmental problems and health issues. In particular, catalytic/electrocatalytic approaches are attractive for NO3− removal, because NO3− from wastewater can be converted to N2 and released back to the atmosphere using renewable H2 or electricity, closing the loop of the global N cycle. However, achieving high product selectivity towards the desirable N2 has proven challenging in the direct NO3−-to-N2 reaction. In this presentation, we will report our finding on unique and ultra-high electrochemical NO3−-to-NO2−activity on an oxide-derived silver electrode (OD-Ag). Up to 98% selectivity and 95% faradaic efficiency of NO2− were observed and maintained under a wide potential window. Benefiting from overcoming the rate-determining barrier of NO3−-to-NO2−during nitrate reduction, further reduction of accumulated NO2− to NH4+ can be well regulated by the cathodic potential on OD-Ag to achieve a faradaic efficiency of 89%. These indicated the potential controllable pathway to the key nitrate reduction products (NO2−or NH4+) on OD-Ag. DFT computations provided insights into the unique NO2−selectivity on Ag electrodes compared with Cu, showing the critical role of a proton-assisted mechanism. Based on the ultra-high NO3−-to-NO2−activity on OD-Ag, we designed a novel electrocatalytic-catalytic combined process for denitrifying real-world NO3−-containing agricultural wastewater, leading to 95+% of NO3− conversion to N2 with minimal NOx gases. Importantly, NO2− derived from nitrate may serve as a crucial reactive platform for distributed production of various nitrogen products, such as NO, NH2OH, NH3, and urea.more » « less
