skip to main content
US FlagAn official website of the United States government
dot gov icon
Official websites use .gov
A .gov website belongs to an official government organization in the United States.
https lock icon
Secure .gov websites use HTTPS
A lock ( lock ) or https:// means you've safely connected to the .gov website. Share sensitive information only on official, secure websites.

Explore Research Products in the PAR
It may take a few hours for recently added research products to appear in PAR search results.


Title: Distinct surface response to black carbon aerosols
Abstract. For the radiative impact of individual climate forcings,most previous studies focused on the global mean values at the top of theatmosphere (TOA), and less attention has been paid to surface processes,especially for black carbon (BC) aerosols. In this study, the surface radiativeresponses to five different forcing agents were analyzed by using idealizedmodel simulations. Our analyses reveal that for greenhouse gases, solarirradiance, and scattering aerosols, the surface temperature changes aremainly dictated by the changes of surface radiative heating, but for BC,surface energy redistribution between different components plays a morecrucial role. Globally, when a unit BC forcing is imposed at TOA, the netshortwave radiation at the surface decreases by -5.87±0.67 W m−2 (W m−2)−1 (averaged over global land without Antarctica), which ispartially offset by increased downward longwave radiation (2.32±0.38 W m−2 (W m−2)−1 from the warmer atmosphere, causing a netdecrease in the incoming downward surface radiation of -3.56±0.60 W m−2 (W m−2)−1. Despite a reduction in the downward radiationenergy, the surface air temperature still increases by 0.25±0.08 Kbecause of less efficient energy dissipation, manifested by reduced surfacesensible (-2.88±0.43 W m−2 (W m−2)−1) and latent heat flux(-1.54±0.27 W m−2 (W m−2)−1), as well as a decrease inBowen ratio (-0.20±0.07 (W m−2)−1). Such reductions of turbulentfluxes can be largely explained by enhanced air stability (0.07±0.02 K (W m−2)−1), measured as the difference of the potential temperaturebetween 925 hPa and surface, and reduced surface wind speed (-0.05±0.01 m s−1 (W m−2)−1). The enhanced stability is due to the fasteratmospheric warming relative to the surface, whereas the reduced wind speedcan be partially explained by enhanced stability and reduced Equator-to-poleatmospheric temperature gradient. These rapid adjustments under BC forcingoccur in the lower atmosphere and propagate downward to influence thesurface energy redistribution and thus surface temperature response, whichis not observed under greenhouse gases or scattering aerosols. Our studyprovides new insights into the impact of absorbing aerosols on surfaceenergy balance and surface temperature response.  more » « less
Award ID(s):
1933630
PAR ID:
10314615
Author(s) / Creator(s):
; ; ; ; ; ; ; ; ; ; ;
Date Published:
Journal Name:
Atmospheric Chemistry and Physics
Volume:
21
Issue:
18
ISSN:
1680-7324
Format(s):
Medium: X
Sponsoring Org:
National Science Foundation
More Like this
  1. ; ; ; (, Atmospheric Chemistry and Physics)
    Abstract. Mineral aerosols (i.e., dust) can affect climate and weather by absorbing and scattering shortwave and longwave radiation in the Earth's atmosphere, the direct radiative effect. Yet understanding of the direct effect is so poor that the sign of the net direct effect at top of the atmosphere (TOA) is unconstrained, and thus it is unknown if dust cools or warms Earth's climate. Here we develop methods to estimate the instantaneous shortwave direct effect via observations of aerosols and radiation made over a 3-year period in a desert region of the southwestern US, obtaining a direct effect of -14±1 and -9±6 W m−2 at the surface and TOA, respectively. We also generate region-specific dust optical properties via a novel dataset of soil mineralogy from the Airborne Visible/Infrared Imaging Spectrometer (AVIRIS), which are then used to model the dust direct radiative effect in the shortwave and longwave. Using this modeling method, we obtain an instantaneous shortwave direct effect of -21±7 and -1±7 W m−2. The discrepancy between the model and observational direct effect is due to stronger absorption in the model, which we interpret as an AVIRIS soil iron oxide content that is too large. Combining the shortwave observational direct effect with a modeled longwave TOA direct effect of 1±1 W m−2, we obtain an instantaneous TOA net effect of -8±6 W m−2, implying a cooling effect of dust. These findings provide a useful constraint on the dust direct effect in the southwestern United States. 
    more » « less
  2. ; ; ; ; ; ; ; ; ; ; et al (, Atmospheric Chemistry and Physics)
    null (Ed.)
    Abstract. The Arctic is warming 2 to 3 times faster than the global average, partly due to changes in short-lived climate forcers (SLCFs) including aerosols. In order to study the effects of atmospheric aerosols in this warming, recent past (1990–2014) and future (2015–2050) simulations have been carried out using the GISS-E2.1 Earth system model to study the aerosol burdens and their radiative and climate impacts over the Arctic (>60∘ N), using anthropogenic emissions from the Eclipse V6b and the Coupled Model Intercomparison Project Phase 6 (CMIP6) databases, while global annual mean greenhouse gas concentrations were prescribed and kept fixed in all simulations. Results showed that the simulations have underestimated observed surface aerosol levels, in particular black carbon (BC) and sulfate (SO42-), by more than 50 %, with the smallest biases calculated for the atmosphere-only simulations, where winds are nudged to reanalysis data. CMIP6 simulations performed slightly better in reproducing the observed surface aerosol concentrations and climate parameters, compared to the Eclipse simulations. In addition, simulations where atmosphere and ocean are fully coupled had slightly smaller biases in aerosol levels compared to atmosphere-only simulations without nudging. Arctic BC, organic aerosol (OA), and SO42- burdens decrease significantly in all simulations by 10 %–60 % following the reductions of 7 %–78 % in emission projections, with the Eclipse ensemble showing larger reductions in Arctic aerosol burdens compared to the CMIP6 ensemble. For the 2030–2050 period, the Eclipse ensemble simulated a radiative forcing due to aerosol–radiation interactions (RFARI) of -0.39±0.01 W m−2, which is −0.08 W m−2 larger than the 1990–2010 mean forcing (−0.32 W m−2), of which -0.24±0.01 W m−2 was attributed to the anthropogenic aerosols. The CMIP6 ensemble simulated a RFARI of −0.35 to −0.40 W m−2 for the same period, which is −0.01 to −0.06 W m−2 larger than the 1990–2010 mean forcing of −0.35 W m−2. The scenarios with little to no mitigation (worst-case scenarios) led to very small changes in the RFARI, while scenarios with medium to large emission mitigations led to increases in the negative RFARI, mainly due to the decrease in the positive BC forcing and the decrease in the negative SO42- forcing. The anthropogenic aerosols accounted for −0.24 to −0.26 W m−2 of the net RFARI in 2030–2050 period, in Eclipse and CMIP6 ensembles, respectively. Finally, all simulations showed an increase in the Arctic surface air temperatures throughout the simulation period. By 2050, surface air temperatures are projected to increase by 2.4 to 2.6 ∘C in the Eclipse ensemble and 1.9 to 2.6 ∘C in the CMIP6 ensemble, compared to the 1990–2010 mean. Overall, results show that even the scenarios with largest emission reductions leads to similar impact on the future Arctic surface air temperatures and sea-ice extent compared to scenarios with smaller emission reductions, implying reductions of greenhouse emissions are still necessary to mitigate climate change. 
    more » « less
  3. ; ; ; ; ; ; ; (, Earth and Space Science)
    Abstract Biomass burning smoke aerosols are efficient at attenuating incoming solar radiation. The Layered Atlantic Smoke Interactions with Clouds campaign was conducted from June 2016 to October 2017. The U. S. Department of Energy mobile Atmospheric Radiation Measurement site located on Ascension Island (AMF‐ASI) identified several instances of smoke plume intrusions. Increases in surface and column measurements of aerosol loading were directly related to increases in fine mode fraction, number concentrations of aerosols (Na), and cloud condensation nuclei (NCCN). During periods of weak lower tropospheric stability, smoke particles were more likely to be advected downward either by boundary layer turbulence or cloud top entrainment under non‐overcast sky conditions. Backward trajectory analysis illustrated that smoke aerosols reaching the AMF‐ASI site were fine mode, less aged, strongly absorbing, and had shorter boundary layer trajectories while longer boundary layer trajectories denoted mixtures of weakly absorbing smoke and coarse mode marine aerosols. The most polluted smoke cases of August 2016 and 2017 revealed a notable contrast in radiative forcing per unit aerosol optical depth or radiative forcing efficiency (ΔFeff) at the top of the atmosphere (TOA) and near‐surface (BOA). The weakly (strongly) absorbing 2016 cases exhibited weaker (stronger) ΔFeffat the TOA and BOA suggesting a warming (cooling) effect within the boundary layer. The 2017 cases featured the strongest ΔFeffsuggesting more of a cooling effect at the TOA and BOA due to mixing of fresh smoke with marine aerosols during transport. 
    more » « less
  4. ; ; (, Copernicus)
    Past climate states hold valuable insights into future climate change. Among those states, mid-Pliocene (3.3 - 3.0 Ma) is often studied as an important analog to near future climate change following an intermediate warming pathway. This time interval featured topography and geography like present-day, yet with retreated polar ice sheets and expanded boreal forests, potentially reflecting equilibrium earth system responses to CO2 forcing at a centennial to millennial time scale. Despite the prolific research on Pliocene climate, little is known about the amount of radiative forcing, especially from changing boundary conditions, that drives the Pliocene climate. Existing constraints mainly focused on well-mixed greenhouse gases and aerosols. Here, we applied the methodology commonly used to quantify radiative forcing of future climate and its sources to constrain radiative forcing of the mid-Pliocene climate using three generations of Community Earth System Models (CCSM4, CESM1.2, and CESM2). To calculate ERF, the difference in net top of the atmosphere radiative fluxes is computed between a pre-industrial control and a mid-Pliocene simulation. Both are carried out with prescribed pre-industrial sea surface temperature. The three mid-Pliocene simulations separately feature a 400 ppm CO2 (the level of mid-Pliocene), mid-Pliocene geography and topography, and mid-Pliocene ice and vegetation. Changing atmospheric temperature, water vapor, surface albedo, and clear vs total sky radiative fluxes are further extracted from these simulations to calculate radiative adjustments with published radiative kernels for CESM. In our preliminary results with CESM1.2, we found that ERF is 1.754 W m-2 for CO2 forcings, 1.143 W m-2 for vegetation and ice sheet forcing, and -0.339 W m-2 for geographic and topographic forcing. Further, ERF from boundary condition changes mostly arises from changing surface albedo with 1.626 W m-2 for vegetation and ice sheet changes and –0.54 W m-2 for geographic and topographic changes respectively. Radiative adjustments from water vapor responses tend to amplify the instantaneous forcing with the most profound effect induced by vegetation and ice sheet changes. These results underscore the importance of constraining radiative forcing from changes in boundary conditions, which is potentially key to understanding drivers of past climate warmth and inter-model spread in simulated past climate states. 
    more » « less
  5. ; ; ; (, Atmospheric Chemistry and Physics)
    Abstract. Mineral dust aerosols cool and warm the atmosphere byscattering and absorbing solar (shortwave: SW) and thermal (longwave: LW)radiation. However, significant uncertainties remain in dust radiativeeffects, largely due to differences in the dust size distribution andspectral optical properties simulated in Earth system models. Dust modelstypically underestimate the coarse dust load (more than 2.5 µm indiameter) and assume a spherical shape, which leads to an overestimate ofthe fine dust load (less than 2.5 µm) after the dust emissions in themodels are scaled to match observed dust aerosol optical depth at 550 nm(DAOD550). Here, we improve the simulated dust properties with data setsthat leverage measurements of size-resolved dust concentration, asphericityfactor, and refractive index in a coupled global chemical transport modelwith a radiative transfer module. After the adjustment of size-resolved dustconcentration and spectral optical properties, the global and annual averageof DAOD550 from the simulation increases from 0.023 to 0.029 and fallswithin the range of a semi-observationally based estimate (0.030 ± 0.005). The reduction of fine dust load after the adjustment leads to areduction of the SW cooling at the top of the atmosphere (TOA). To improveagreement against a semi-observationally based estimate of the radiativeeffect efficiency at TOA, we find that a less absorptive SW dust refractiveindex is required for coarser aspherical dust. Thus, only a minor differenceis estimated for the net global dust radiative effect at TOA (−0.08 vs.−0.00 W m−2 on a global scale). Conversely, our sensitivitysimulations reveal that the surface warming is substantially enhanced nearthe strong dust source regions (less cooling to −0.23 from −0.60 W m−2 on a global scale). Thus, less atmospheric radiativeheating is estimated near the major source regions (less heating to 0.15from 0.59 W m−2 on a global scale), because of enhanced LWwarming at the surface by the synergy of coarser size and aspherical shape. 
    more » « less
  • Citation Formats
  • MLA
  • APA
  • Chicago
  • BibTeX
  • Save / Share this Record
  • Send to Email