Four glycolated polythiophene‐based organic mixed ionic‐electronic conductors (OMIECs), PE2gTT, PE2gT, PT2gTT, and PT2gT are prepared by atom‐efficient direct arylation polymerization, avoiding the need for toxic organometallic precursors. PE2gT, PT2gTT, and PT2gT are operable in p‐type accumulation mode organic electrochemical transistors (OECTs), with PT2gT displaying the best device performance with a µ
Organic electrochemical transistors (OECTs) hold promise for developing a variety of high‐performance (bio‐)electronic devices/circuits. While OECTs based on p‐type semiconductors have achieved tremendous progress in recent years, n‐type OECTs still suffer from low performance, hampering the development of power‐efficient electronics. Here, it is demonstrated that fine‐tuning the molecular weight of the rigid, ladder‐type n‐type polymer poly(benzimidazobenzophenanthroline) (BBL) by only one order of magnitude (from 4.9 to 51 kDa) enables the development of n‐type OECTs with record‐high geometry‐normalized transconductance (
- Award ID(s):
- 2003518
- NSF-PAR ID:
- 10446547
- Publisher / Repository:
- Wiley Blackwell (John Wiley & Sons)
- Date Published:
- Journal Name:
- Advanced Materials
- Volume:
- 34
- Issue:
- 4
- ISSN:
- 0935-9648
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
more » « less
Abstract C* product figure‐of‐merit of 290 F cm−1 V−1 s−1. A record volumetric capacitance among p‐type glycolated polythiophene OMIECs of 313 F cm−3is observed forPE2gT , ascribed to the high proportionality of polar components in its materials design. The good OECT performance ofPE2gT with µC* = 84.2 F cm−1 V−1 s−1, comparable with state‐of‐the‐art poly(3,4‐ethylenedioxythiophene):poly(styrenesulfonate) (PEDOT:PSS) devices, coupled with its synthetic accessibility and favorable accumulation mode operation makesPE2gT an ideal glycolated alternative to PEDOT:PSS in bioelectronics.PE2gT with the least negative threshold voltage also displays the best OECT operational cycling stability, linked to better resistance of its oxidized state against parasitic redox side reactions . Shelf life stability of OECTs stored (without bias) is observed to be better for materials with a more negative threshold voltage and higher average molecular weight (PT2gT ), that are less susceptible to ambient auto‐oxidation and film delamination. -
more » « less
Electrolyte-gated transistors (EGTs) hold great promise for next-generation printed logic circuitry, biocompatible integrated sensors, and neuromorphic devices. However, EGT-based complementary circuits with high voltage gain and ultralow driving voltage (<0.5 V) are currently unrealized, because achieving balanced electrical output for both the p- and n-type EGT components has not been possible with current materials. Here we report high-performance EGT complementary circuits containing p-type organic electrochemical transistors (OECTs) fabricated with an ion-permeable organic semiconducting polymer (DPP-g2T) and an n-type electrical double-layer transistor (EDLT) fabricated with an ion-impermeable inorganic indium–gallium–zinc oxide (IGZO) semiconductor. Adjusting the IGZO composition enables tunable EDLT output which, for In:Ga:Zn = 10:1:1 at%, balances that of the DPP-g2T OECT. The resulting hybrid electrolyte-gated inverter (HCIN) achieves ultrahigh voltage gains (>110) under a supply voltage of only 0.7 V. Furthermore, NAND and NOR logic circuits on both rigid and flexible substrates are realized, enabling not only excellent logic response with driving voltages as low as 0.2 V but also impressive mechanical flexibility down to 1-mm bending radii. Finally, the HCIN was applied in electrooculographic (EOG) signal monitoring for recording eye movement, which is critical for the development of wearable medical sensors and also interfaces for human–computer interaction; the high voltage amplification of the present HCIN enables EOG signal amplification and monitoring in which a small ∼1.5 mV signal is amplified to ∼30 mV.
-
more » « less
Abstract Organic electrochemical transistors (OECTs) have gained considerable attention due to their potential applications in emerging biosensor platforms. The use of conjugated polyelectrolytes (CPEs) as active materials in OECTs is particularly advantageous owing to their functional, water‐processable, and biocompatible nature, as well as their tunable electronic and ionic transport properties. However, there exists a lack of systematic studies of the structure‐property relationships of these materials with respect to OECT performance. This study shows how by tuning the molecular weight of self‐doped CPE (CPE‐K) it is possible to fabricate OECTs with a
µC *value of 14.7 F cm−1V−1s−1, one order of magnitude higher than previously reported CPE‐based devices. Furthermore, OECTs with a transconductance of 120 mS are demonstrated via device engineering. While CPE‐K batches with different molecular weights show good doping behavior and high volumetric capacitance, as confirmed by spectroelectrochemistry and electrochemical impedance spectroscopy, the medium molecular weight possesses the highest carrier mobility of ≈0.1 cm2V−1s−1leading to the highest transconductance. The enhanced charge transport is due to a favorable charge percolation pathway, as revealed by the combination of X‐ray analysis and conductive atomic force microscope. These insights provide guidelines for further improving the performance of CPE‐based OECTs. -
The commercially available polyelectrolyte complex poly(3,4-ethylenedioxythiophene):poly(styrene sulfonate) (PEDOT:PSS) is ubiquitous in organic and hybrid electronics. As such, it has often been used as a benchmark material for fundamental studies and the development of new electronic devices. Yet, most studies on PEDOT:PSS have focused on its electronic conductivity in dry environments, with less consideration given to its ion transport, coupled ionic-electronic transport, and charge storage properties in aqueous environments. These properties are essential for applications in bioelectronics (sensors, actuators), charge storage devices, and electrochromic displays. Importantly, past studies on mixed ionic-electronic transport in PEDOT:PSS neglected to consider how the molecular structure of PSS affects mixed ionic-electronic transport. Herein, we therefore investigated the effect of the molecular weight and size distribution of PSS on the electronic properties and morphology of PEDOT:PSS both in dry and aqueous environments, and overall performance in organic electrochemical transistors (OECTs). Using reversible addition–fragmentation chain transfer (RAFT) polymerization with two different chain transfer agents, six PSS samples with monomodal, narrow ( Đ = 1.1) and broad ( Đ = 1.7) size distributions and varying molecular weights were synthesized and used as matrices for PEDOT. We found that using higher molecular weight of PSS ( M n = 145 kg mol −1 ) and broad dispersity led to OECTs with the highest transconductance (up to 16 mS) and [ μC *] values (∼140 F cm −1 V −1 s −1 ) in PEDOT:PSS, despite having a lower volumetric capacitance ( C * = 35 ± 4 F cm −3 ). The differences were best explained by studying the microstructure of the films by atomic force microscopy (AFM). We found that heterogeneities in the PEDOT:PSS films (interconnected and large PEDOT- and PSS-rich domains) obtained from high molecular weight and high dispersity PSS led to higher charge mobility ( μ OECT ∼ 4 cm 2 V −1 s −1 ) and hence transconductance. These studies highlight the importance of considering molecular weight and size distribution in organic mixed ionic-electronic conductor, and could pave the way to designing high performance organic electronics for biological interfaces.more » « less
-
more » « less
Abstract Organic electrochemical transistors (OECTs) are the building blocks of biosensors, neuromorphic devices, and complementary circuits. One rule in the materials design for OECTs is the inclusion of a hydrophilic component in the chemical structure to enable ion transport in the film. Here, it is shown that the ladder‐type, side‐chain free polymer poly(benzimidazobenzophenanthroline) (BBL) performs significantly better in OECTs than the donor–acceptor type copolymer bearing hydrophilic ethylene glycol side chains (P‐90). A combination of electrochemical techniques reveals that BBL exhibits a more efficient ion‐to‐electron coupling and higher OECT mobility than P‐90. In situ atomic force microscopy scans evidence that BBL, which swells negligibly in electrolytes, undergoes a drastic and permanent change in morphology upon electrochemical doping. In contrast, P‐90 substantially swells when immersed in electrolytes and shows moderate morphology changes induced by dopant ions. Ex situ grazing incidence wide‐angle X‐ray scattering suggests that the particular packing of BBL crystallites is minimally affected after doping, in contrast to P‐90. BBL's ability to show exceptional mixed transport is due to the crystallites’ connectivity, which resists water uptake. This side chain‐free route for the design of mixed conductors could bring the n‐type OECT performance closer to the bar set by their p‐type counterparts.
