skip to main content


Title: A modified Michelson interferometer to measure sub-milliradian changes in angle
Modern short-range gravity experiments that seek to test the Newtonian inverse-square law or weak equivalence principle of general relativity typically involve measuring the minute variations in the twist angle of a torsion pendulum. Motivated by various theoretical arguments, recent efforts largely focus on measurements with test mass separations in the sub-millimeter regime. To measure the twist, many experiments employ an optical autocollimator with a noise performance of ∼300 nrad[Formula: see text] in the 0.1–10 mHz band, enabling a measurement uncertainty of a few nanoradians in a typical integration time. We investigated an alternative method for measuring a small twist angle through the construction of a modified Michelson interferometer. The main modification is the introduction of two additional arms that allow for improved angular alignment. A series of detectors and LabView software routines were developed to determine the orientation of a mirror attached to a sinusoidally driven rotation stage that oscillated with an amplitude of 0.35 mrad and a period of 200 s. In these measurements, the resolution of the interferometer is 8.1  μrad per fringe, while its dynamic range spanned 0.962 mrad. We compare the performance of this interferometric optical system to existing autocollimator-based methods, discussing its implementation, possible advantages, and future potential, as well as disadvantages and limitations.  more » « less
Award ID(s):
1065697 1306783 1606988 1908502
NSF-PAR ID:
10345915
Author(s) / Creator(s):
; ; ; ;
Date Published:
Journal Name:
AIP Advances
Volume:
12
Issue:
8
ISSN:
2158-3226
Page Range / eLocation ID:
085002
Format(s):
Medium: X
Sponsoring Org:
National Science Foundation
More Like this
  1. Absolute density measurements of low-ionization-degree or low-density plasmas ionized by lasers are very important for understanding strong-field physics, atmospheric propagation of intense laser pulses, Lidar etc. A cross-polarized common-path temporal interferometer using balanced detection was developed for measuring plasma density with a sensitivity of ∼0.6 mrad, equivalent to a plasma density-length product of ∼2.6 × 1013cm−2if using an 800 nm probe laser. By using this interferometer, we have investigated strong-field ionization yield versus intensity for various noble gases (Ar, Kr, and Xe) using 800 nm, 55 fs laser pulses with both linear (LP) and circular (CP) polarization. The experimental results were compared to the theoretical models of Ammosov-Delone-Krainov (ADK) and Perelomov-Popov-Terent’ev (PPT). We find that the measured phase change induced by plasma formation can be explained by the ADK theory in the adiabatic tunneling ionization regime, while PPT model can be applied to all different regimes. We have also measured the photoionization and fractional photodissociation of molecular (MO) hydrogen. By comparing our experimental results with PPT and MO-PPT models, we have determined the likely ionization pathways when using three different pump laser wavelengths of 800 nm, 400 nm, and 267 nm.

     
    more » « less
  2. This paper describes an integrated, accurate, and inexpensive semiconductor laser -based optical frequency domain reflectometry (OFDR) system design. The system utilizes the fiber under test for both sensing and frequency sweep linearization functions, allowing the system to mitigate and compensate for phase errors without the need for an auxiliary interferometer, as is the case for traditional OFDR systems. Benefiting from the unique and embedded design, this system reaches the minimal OFDR system with only one optical interferometer and its corresponding optic-electric components without sacrificing accuracy. In addition, conventional design requires an external auxiliary interferometer, which may experience different noises from the main measuring interferometer, deteriorating the overall performance. Experimental results demonstrate the enhanced performance of the compact design as compared with the former methods, as well as the reduced complexity and improved cost-effectiveness.

     
    more » « less
  3. Fluorescence-detected Fourier transform (FT) spectroscopy is a technique in which the relative paths of an optical interferometer are controlled to excite a material sample, and the ensuing fluorescence is detected as a function of the interferometer path delay and relative phase. A common approach to enhance the signal-to-noise ratio in these experiments is to apply a continuous phase sweep to the relative optical path, and to detect the resulting modulated fluorescence using a phase-sensitive lock-in amplifier. In many important situations, the fluorescence signal is too weak to be measured using a lock-in amplifier, so that photon counting techniques are preferred. Here we introduce an approach to low-signal fluorescence-detected FT spectroscopy, in which individual photon counts are assigned to a modulated interferometer phase (‘phase-tagged photon counting,’ or PTPC), and the resulting data are processed to construct optical spectra. We studied the fluorescence signals of a molecular sample excited resonantly by a pulsed coherent laser over a range of photon flux and visibility levels. We compare the performance of PTPC to standard lock-in detection methods and establish the range of signal parameters over which meaningful measurements can be carried out. We find that PTPC generally outperforms the lock-in detection method, with the dominant source of measurement uncertainty being associated with the statistics of the finite number of samples of the photon detection rate.

     
    more » « less
  4. Abstract It is highly desirable for future measurements of Newton’s gravitational constant G to use test/source masses that allow nondestructive, quantitative internal density gradient measurements. High density optically transparent materials are ideally suited for this purpose since their density gradient can be measured with laser interferometry, and they allow in-situ optical metrology methods for the critical distance measurements often needed in a G apparatus. We present an upper bound on possible internal density gradients in lead tungstate (PbWO 4 ) crystals determined using a laser interferometer. We placed an upper bound on the fractional atomic density gradient in two PbWO 4 test crystals of 1 ρ d ρ d x < 2.1 × 1 0 − 8 cm −1 . This value is more than two orders of magnitude smaller than what is required for G measurements. They are also consistent with but more sensitive than a recently reported measurements of the same samples, using neutron interferometry. These results indicate that PbWO 4 crystals are well suited to be used as test masses in G experiments. Future measurements of internal density gradients of test masses used for measurements of G can now be conducted non-destructively for a wide range of possible test masses. 
    more » « less
  5. Abstract A linearly polarized Laguerre–Gaussian (LP-LG) laser beam with a twist index $l = -1$ has field structure that fundamentally differs from the field structure of a conventional linearly polarized Gaussian beam. Close to the axis of the LP-LG beam, the longitudinal electric and magnetic fields dominate over the transverse components. This structure offers an attractive opportunity to accelerate electrons in vacuum. It is shown, using three-dimensional particle-in-cell simulations, that this scenario can be realized by reflecting an LP-LG laser off a plasma with a sharp density gradient. The simulations indicate that a 600 TW LP-LG laser beam effectively injects electrons into the beam during the reflection. The electrons that are injected close to the laser axis experience a prolonged longitudinal acceleration by the longitudinal laser electric field. The electrons form distinct monoenergetic bunches with a small divergence angle. The energy in the most energetic bunch is 0.29 GeV. The bunch charge is 6 pC and its duration is approximately $270$ as. The divergence angle is just ${0.57}^{\circ }$ (10 mrad). By using a linearly polarized rather than a circularly polarized Laguerre–Gaussian beam, our scheme makes it easier to demonstrate the electron acceleration experimentally at a high-power laser facility. 
    more » « less