To constrain the deformation, thermal evolution, and seismic properties of the mantle lithosphere beneath the Hangay Dome, we have analyzed the microstructures, crystal preferred orientations (CPO), and hydrogen concentrations of olivine and pyroxenes of 50 mantle xenoliths carried up by Cenozoic basalts from Zala, Haer, and Shavaryn‐Tsaram from Tariat, Mongolia. Most xenoliths are medium‐ to coarse‐grained spinel‐lherzolites, but four contain garnet + spinel. Coarse granular, highly annealed microstructures predominate. The microstructures are associated with well‐developed CPO, typical of deformation under high temperature, moderate pressure, and dry conditions. The hydrogen concentrations in olivine, orthopyroxene, and clinopyroxene are low and range around 5, 75, and 147 ppm H2O wt, respectively. Together, microstructures and CPO indicate that ductile deformation was followed by static recrystallization, which has annealed the microstructures but preserved the CPO and, hence, the anisotropy of physical properties. Lack of correlation between annealing and equilibrium temperatures suggest that the annealing is due to a long quiescence episode since the last deformation episode. Here, there is not evidence that the formation of Hangay Dome is associated with recent deformation in the lithospheric mantle. Calculated seismic properties show moderate seismic anisotropy, with fast propagation of
Syntectonic microstructural evolution is a well‐known phenomenon in the mantle and lower crust associated with two main processes: grain size reduction through dynamic recrystallization and development of crystallographic preferred orientation (CPO). However, the effects of annealing via static recrystallization on grain size and CPO have been largely overlooked. We investigated mantle annealing by analyzing a suite of kimberlite‐hosted garnet peridotite xenoliths from the Wyoming Craton. We focus on five xenoliths that show microstructures reflecting different degrees of recrystallization, with annealed grains characterized by distinctive faceted boundaries crosscutting surrounding, nonfaceted matrix grains. These textures are indicative of discontinuous static recrystallization (DiSRX). Electron backscatter diffraction analysis further demonstrates a ∼10°–20° misorientation between DiSRXed grains and the matrix grains, resulting in an overall weaker CPO. These characteristics are remarkably similar to microstructures observed in samples that were annealed after deformation in the laboratory. Measurements of the thermal conditions and water contents associated with the last equilibration of the xenoliths suggests that high homologous temperatures (
- Award ID(s):
- 1719208
- NSF-PAR ID:
- 10453233
- Publisher / Repository:
- DOI PREFIX: 10.1029
- Date Published:
- Journal Name:
- Geochemistry, Geophysics, Geosystems
- Volume:
- 22
- Issue:
- 3
- ISSN:
- 1525-2027
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
more » « less
Abstract P waves and polarization ofS waves parallel to the flow direction and low birefringence forS waves propagating obliquely to the flow plane. The results are consistent with weakP wave anomalies but not with the strong lowS wave velocity anomalies predicted by some tomographic models or with the high conductivity inferred from magnetotelluric data for the lithospheric mantle beneath the Hangay Dome. -
more » « less
Abstract Mantle xenoliths from the Southern Alps, New Zealand, provide insight into the origin of mantle seismic anisotropy related to the Australian‐Pacific plate boundary. Most xenoliths from within 100 km lateral distance of the Alpine Fault are coarse grained, but a small number are finer grained protomylonites. The protomylonites contain connected networks of fine grains with a different crystallographic preferred orientation (CPO) to coarse porphyroclasts in the same xenolith, suggesting that protomylonites and coarse‐grained samples record different deformation kinematics. The CPOs of fine grains in protomylonites have monoclinic symmetry, with the 2‐fold rotation axis normal to a plane that contains olivine [010] and orthopyroxene [100] maxima, suggesting that the protomylonite deformation involved significant simple shear. Some coarse‐grained samples contain unconnected lenses and layers of fine grains with the same CPO as the coarse grains. Microstructures suggest that these fine grains formed by subgrain rotation recrystallization and that protomylonites may represent an up‐strain progression of this microstructure, where the connectivity of fine grains has allowed them to localize shear and develop a new Alpine Fault CPO. The samples tell us about the state of the mantle at 25 Ma, in the early history of the plate boundary. If this suite of samples is representative of the mantle beneath the Alpine Fault in the present day, then we can interpret the complex seismic anisotropy patterns in the lithospheric mantle as representative of blocks containing variably rotated older CPOs juxtaposed by narrow shear zones associated with Alpine Fault deformation.
-
more » « less
Abstract The microstructural properties of deep arc cumulates (arclogites) are poorly understood, but are essential in gaining a comprehensive picture of the rheology of continental lithosphere. Here, we analyze 16 arclogite xenoliths, comprising a low MgO and a high MgO suite, from Arizona, USA using electron backscatter diffraction to map microstructures, clinopyroxene shape preferred orientations (SPO), and clinopyroxene crystallographic preferred orientations (CPO). The lower pressure (∼1 GPa) low MgO arclogites show a variety of different clinopyroxene fabrics (S, L, and LS‐type), whereas the high pressure (>2 GPa) high MgO arclogites show predominantly LS‐type fabrics. Furthermore, clinopyroxenes in low MgO arclogites all show a pronounced correspondence between the long axis of their grain shape ellipsoids with the [001] crystal direction, indicating an SPO control on the CPO. In contrast, high MgO arclogite clinopyroxenes lack such a correspondence. We propose that both arclogite types originated as igneous cumulates, consistent with previous studies, but that the high MgO suite experienced substantial recrystallization which diminished the original igneous SPO‐induced CPO. Using strain rates appropriate for arc settings, we calculate a strength profile for the lithosphere and argue that the deepest arclogite textures are consistent with lithospheric foundering through ductile deformation under high shear strain (10−14–10−12 s−1). Our study shows that there is a high degree of shear strain localization in deep arc roots while shallower portions are relatively undeformed.
-
more » « less
Abstract To understand the effects of secondary minerals on changes in the mechanical properties of upper mantle rocks due to phase mixing, we conducted high‐strain torsion experiments on aggregates of iron‐rich olivine + orthopyroxene (opx) with opx volume fractions of
f opx = 0.15, 0.26, and 0.35. For samples with larger amounts of opx,f opx = 0.26 and 0.35, the value of the stress exponent decreases with increasing strain fromn ≈ 3 for γ≲ 5 ton ≈ 2 for 5≲ γ≲ 25, indicating that the deformation mechanism changes as strain increases. In contrast, for samples withf opx = 0.15, the stress exponent is constant atn ≈ 3.3 for 1≲ γ≲ 25, suggesting that no change in deformation mechanism occurs with increasing strain for samples with smaller amounts of opx. The microstructures of samples with larger amounts of opx provide insight into the change in deformation mechanism derived from the mechanical data. Elongated grains align subparallel to the shear direction for samples of all three compositions deformed to lower strains. However, strain weakening with grain size reduction and the formation of a thoroughly mixed, fine‐grained texture only develops in samples withf opx = 0.26 and 0.35 deformed to higher strains of γ≳ 16. These mechanical and associated microstructural properties imply that rheological weakening due to phase mixing only occurs in the samples with largerf opx, which is an important constraint for understanding strain localization in the upper mantle of Earth. -
more » « less
Abstract Iron‐rich olivine is mechanically weaker than olivine of mantle composition, ca. Fo90, and thus is more amenable to study under a wide range of laboratory conditions. To investigate the effects of iron content on deformation‐produced crystallographic preferred orientation (CPO) and grain size, we analyzed the microstructures of olivine samples with compositions of Fo70, Fo50, and Fo0that were deformed in torsion under either anhydrous or hydrous conditions at 300 MPa. Electron backscatter diffraction (EBSD) observations reveal a transition in CPO from D‐type fabric, induced by dislocation glide on both the (010)[100] and the (001)[100] slip systems, at low strains, to A‐type fabric, caused by dislocation glide on the (010)[100] slip system, at high strains for all of our samples, independent of iron content and hydrous/anhydrous conditions. A similar evolution of fabric with increasing strain is also reported to occur for Fo90. Radial seismic anisotropy increases with increasing strain, reaching a maximum value of ∼1.15 at a shear strain of ∼3.5 for each sample, demonstrating that the seismic anisotropy of naturally deformed olivine‐rich rocks can be well approximated by that of iron‐rich olivine. Based on EBSD observations, we derived a piezometer for which recrystallized grain size decreases inversely with stress to the ∼1.2 power. Also, recrystallized grain size increases with increasing iron content. Our experimental results contribute to understanding the microstructural evolution in the mantle of not only Earth but also Mars, where the iron content in olivine is higher.
