Outcrops of brittle faults are rare in Marie Byrd Land, West Antarctica, because fault damage zones commonly undergo enhanced erosion and form bedrock troughs occupied by glacier ice. Where exposures do exist, faults yield information about regional strain in the West Antarctic Rift System (WARS) and may host minerals that contain a record of the temperature and chemistry of fluids during regional-scale faulting. In MBL’s southern Ford Ranges, bordering Ross Sea, a distinctive fault array was sampled that hosts tourmaline and quartz, a mineral-pair that can provide temperature and composition of fault-associated fluids, using 18O. Host rocks are tourmaline-free. At three separate sites, fault surfaces display strongly aligned tourmaline, suggesting that mineralization occurred during tectonism. One site features highly polished, or mirrored, surfaces, a characteristic that may indicate tourmaline precipitation during seismic slip. The orientation and kinematics of the high angle faults are NNW-striking: normal-slip, and WNW-ESE striking: right-lateral strike-slip. The timing of mineralization is yet to be determined, but viable possibilities are that the faults formed during broad intracontinental extension during formation of Ross Embayment in the Cretaceous, or during development of deep, narrow basins beneath the RIS grounding zone, in the Neogene (newly detected, see Tankersley et al., this meeting).
Once formed, tourmaline is resistant to chemical and isotopic re-equilibration, and therefore can retain a record of its conditions during formation. We used oxygen isotope compositions of tourmaline and quartz pairs to investigate temperatures, fluid-rock ratios, and fluid sources, with bearing on fault-localized flux of fluids and geothermal heat. Analyzed tourmaline and quartz were separated from the upper ~2mm of the fault surfaces, as well as quartz separated from host rock in the same hand samples.
Tourmaline 18O ratios (n=4) fall within a range of +9.2 to +10.4 ± 0.1 ‰ VSMOW (average 9.7‰, StDev = 0.7). Paired quartz yield 18O values of +11.1 to +10.3 ± 0.1 ‰. Relative isotopic homogeneity between sites suggests similar fluid conditions were present across the region and supports field evidence for that the structures form a regional fault array. ∆Qtz-Trm values fall between 1.3 and 2.0, and 18O of quartz in faults closely resembles 18O of host rock quartz. We tentatively determine the water oxygen isotope ratio as greater than ~7.7 ‰. Plutonic-metamorphic associations in the immediate region, and comparisons with similar faults elsewhere (i.e. Isola d’Elba, Italy), suggest temperatures as high as 500°C for the fluids that circulated into the faults.
The data are interpreted to show that brittle faults provided pathways for hot fluids derived from mid-crustal processes to make their way to shallow crustal depths. 18O values indicate magmatic and/or metamorphic fluid sources, with minor to no introduction of meteoric fluids. Tourmaline-quartz pairs did not attain equilibrium, likely due to tourmaline’s rapid crystallization. On-going investigation includes analysis of H and B isotopes in tourmaline, which will better characterize the relationship between fault-hosted and mid-crustal fluids.
more »
« less
Focusing Fluids in Faults: Evidence From Stable Isotopic Studies of Dated Clay‐Rich Fault Gouge of the Alberta Rockies
Isotopic studies of Canadian Rocky Mountain thrust faults preserve the timing and identity of orogenic fluids and their fault zone pathways. Using previously dated samples, we measure the O‐ and H‐isotopic compositions of fault gouge. These nearly 100% neomineralized gouges and their associated damage zones act as primary orogenic fluid pathways. As such, they provide a specific and local look into the nature of the Late Jurassic to Early Eocene orogenic plumbing system in the Alberta Rockies. Considering clay polytype stability and regional temperature conditions, we obtain a range of geofluid isotopic compositions during Jurassic‐Eocene thrust faulting: δ18Ofluidranged from ∼−3.3 to 9.2 ± 3.2‰; δDfluidranged from −119 to −46 ± 13‰ VSMOW. The range of O‐ and H‐isotopic compositions reflects mixing of fluid sources, including the pervasive presence of surface‐sourced fluids (up to ∼90%). The interpreted prevalence of a surface fluid source in fault rocks is in agreement with regional isotopic trends previously observed in undated veins of fractured host rock. Our results confirm that thrust faults of the Alberta Rocky Mountains acted as major fluid‐focusing conduits during orogenic activity. We further show that these faults incorporated both deeply sourced and surface‐sourced fluids into zones of enhanced and dynamic permeability, heterogeneously distributing fluids along fault planes across the fold‐thrust belt, promoting the growth of fault‐zone weakening clay minerals.
more » « less- NSF-PAR ID:
- 10363610
- Publisher / Repository:
- DOI PREFIX: 10.1029
- Date Published:
- Journal Name:
- Geochemistry, Geophysics, Geosystems
- Volume:
- 22
- Issue:
- 11
- ISSN:
- 1525-2027
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
more » « less
Abstract Tectonic mélanges, characterized by conditions reflective of modern subduction fault zones, preserve mineral veins formed through mass transfer, a mechanism influencing the slip behavior of subduction megathrusts. In this study, we apply secondary ion mass spectrometry quartz‐calcite oxygen isotope thermometry and clumped isotope thermometry to examine the temperatures of vein formations in six mélange units in the Cretaceous Shimanto belt and one mélange in the Kodiak accretionary prism. Calcite in the veins exhibits δ13CPDBvalues ranging from −17.2‰ to −6.8‰, indicative of a carbon source mixing with sedimentary carbonate and organic matter. δ18OSMOWvalues of calcite range from +11.1‰ to +17.2‰; quartz yields δ18OSMOWvalues of +14.9‰ to +21.7‰. Oxygen isotopic signatures in minerals reveal that most vein‐forming fluids are significantly affected by rock buffering, while some retain isotopic compositions of seawater and meteoric water. Temperature estimates, derived from both thermometers, fall within the range of 100–250°C. Notably, vein temperatures remain constant across diverse vein types and mélange units with distinct maximum temperatures. The combined temperature records and fluid isotopic compositions imply vein formations at shallower depths linked to the incorporation of seawater, meteoric water, and fluid released from early dehydration reactions. At greater depths, vein formations are associated with fluid released from clay dehydration and long‐distance fluid flow. Reduced vein formations between 250 and 350°C may correlate with a shift to fluid‐unsaturated conditions resulting from clay hydration reactions. Our study highlights potential mechanical and hydraulic variations within the thermal conditions of 100–350°C along the plate boundary driven by fluid‐mineral interactions.
-
Brittle faults in the southern Ford Ranges of Marie Byrd Land, West Antarctica, provide unique opportunity to study fluid-rock interactions in the West Antarctic Rift System and the role of crustal fluids during regional-scale faulting. This fault array contains steep, NNW-striking, normal-oblique slip faults and sub-vertical WNW-ESE strike-oblique faults. \ Faults at Mt. Douglass, Mt. Dolber, and Lewissohn Nunatak display strongly aligned tourmaline, indicating syntectonic mineralization; surfaces in one location feature distinctive mirror surfaces, suggestive of formation during seismic slip. Tourmaline has been demonstrated to resist chemical and isotopic re-equilibration during even high-temperature metamorphism, and to maintain a record of conditions during formation, therefore oxygen isotope compositions of tourmaline and quartz pairs may elucidate crustal conditions (e.g. temperatures and fluid-rock ratios) and fluids sources. Analyzed tourmaline and quartz were separated from the upper ~2mm of the fault surfaces; host rocks are tourmaline-free. Tourmaline 18O ratios (n=4) fall within a range of +9.2 to +10.4 ± 0.1 ‰ VSMOW (average 9.7‰, StDev = 0.7). Paired quartz yield 18O values of +11.1 to +10.3 ± 0.1 ‰; ∆Qtz-Trm values between 1.3 and 2.0 may reflect an inability of quartz to equilibrate during tourmaline crystallization. Equilibrium between quartz and tourmaline would suggest temperatures of formation in excess of 550°C. Relative isotopic homogeneity between sites suggests similar fluid conditions were present across the region and supports field evidence for that the structures form a regional fault array. Geometric and kinematic relationships suggest a link to deeper level shears hosting muscovite, and sillimanite with garnet. On-going investigation includes O isotope analyses of these shears, as well as analysis of H and B isotopes in tourmaline, which will better characterize the relationship between the deeper crustal shears with the brittle fault array, and the fluid sources and metasomatic processes of regional fault systems. Furthermore, temporal constraints on tourmaline mineralization will establish whether faulting is associated with Cretaceous intracontinental extension of the West Antarctic rift system (Siddoway 2008) or a crustal response to Neogene mantle delamination beneath the South Pole region (Shen et al 2018).more » « less
-
The relationships between brittle detachment faulting and ductile shear zones in metamorphic core complexes are often ambiguous. Although it is commonly assumed that these two structures are kinematically linked and genetically related, direct observations of this coupling are rare. Here, we conducted a detailed field investigation to probe the connection between a detachment fault and mylonitic shear zone in the Ruby Mountain–East Humboldt Range metamorphic core complex, northeast Nevada. Field observations, along with new and published geochronology, demonstrate that Oligocene top-to-the-west mylonitic shear zones are crosscut by ca. 17 Ma subvertical basalt dikes, and these dikes are in turn truncated by middle Miocene detachment faults. The detachment faults appear to focus in preexisting weak zones in shaley strata and Mesozoic thrust faults. We interpret that the Oligocene mylonitic shear zones were generated in response to domal upwelling during voluminous plutonism and partial melting, which significantly predated the middle Miocene onset of regional extension and detachment slip. Our model simplifies mechanical issues with low-angle detachment faulting because there was an initial dip to the weak zones exploited by the future detachment-fault zone. This mechanism may be important for many apparent low-angle normal faults in the eastern Great Basin. We suggest that the temporal decoupling of mylonitic shearing and detachment faulting may be significant and underappreciated for many of the metamorphic core complexes in the North American Cordillera. In this case, earlier Eocene–Oligocene buoyant doming may have preconditioned the crust to be reactivated by Miocene extension thus explaining the spatial relationship between structures.more » « less
-
Brittle faults are widespread but rarely exposed in Marie Byrd Land, a part of the West Antarctic rift system, owing to enhanced erosion of zones of cataclasis by the regional ice sheet. Tourmaline-mineralized faults discovered at three locations in the Ford Ranges constitute a new record of fluid-rock interactions in this region of extended crust. Tourmaline resists re-equilibration, even during metamorphism, thus strongly aligned tourmaline from high-angle faults at Mt. Douglass, Mt. Dolber, and Lewissohn Nunatak likely contain direct records of fault-hosted fluids and timing of fault movements. The faults form an array oriented NNW-SSE and WNW-ESE, which displays brittle kinematic criteria indicating normal-oblique and strike-oblique displacement. Mirrored fault surfaces suggest formation during seismic slip. Tourmaline is concentrated within a 2 to 4 mm zone bordering the fault planes. Petrography and EMPA analyses show unzoned tourmaline , with the dravite variety at Lewissohn Nunatak and schorl at the other two sites. Fluid inclusions in dravite are tubular (A-axis-parallel), 10 to 15 um, and up to 25 um, in length, containing gas and fluid phases. Fluid inclusions in schorl are C-axis-parallel and breached. Tourmaline ∂18O ratios (n=4) range from 9.2 to 10.4 ± 0.1 ‰ VSMOW (average 9.7‰, s.dev. = 0.7). Paired quartz yield ∂18O values of 11.1 to 10.3 ± 0.1 ‰, and ∆Qtz-Trm values between 1.3 and 2.0. Brittle microfractures in parallel arrays, evident in thin section, indicate tensile opening along ENE- WSW axes, in accordance with outcrop evidence. The strong preferred orientation and uniform mineral composition of tourmaline indicate syntectonic growth of tourmaline along fault planes. ∆Qtz-Trm values suggest equilibration between host-rock quartz and tourmaline was not achieved, likely due to rapid tourmaline precipitation. Relative isotopic homogeneity between sites suggests similar fluid conditions across the region, for crust underlying a minimum area of 2000 km2. Preliminary results of tourmaline 40Ar/39Ar dating indicate broadly Cretaceous timing for fault-related fluid flow. Ongoing work seeks to determine the temperature of mineralizing fluids and evaluate whether the brittle array localizes geothermal heat beneath the contemporary icesheet.more » « less
