Two-dimensional (2D) ternary materials recently generated interest in optoelectronics and energy-related applications, alongside their binary counterparts. To date, only a few naturally occurring layered 2D ternary materials have been explored. The plethora of benefits owed to reduced dimensionality prompted exploration of expanding non-layered ternary chalcogenides into the 2D realm. This work presents a templating method that uses 2D transition metal dichalcogenides as initiators to be converted into the corresponding ternary chalcogenide upon addition of copper, via a solution-phase synthesis, conducted in high boiling point solvents. The process starts with preparation of VSe2nanosheets, which are next converted into Cu3VSe4sulvanite nanosheets (NSs) which retain the 2D geometry while presenting an X-ray diffraction pattern identical with the one for the bulk Cu3VSe4. Both the scanning electron microscopy and transmission microscopy electron microscopy show the presence of quasi-2D morphology. Recent studies of the sulfur-containing sulvanite Cu3VS4highlight the presence of an intermediate bandgap, associated with enhanced photovoltaic (PV) performance. The Cu3VSe4nanosheets reported herein exhibit multiple UV–Vis absorption peaks, related to the intermediate bandgaps similar to Cu3VS4and Cu3VSe4nanocrystals. To test the potential of Cu3VSe4NSs as an absorber for solar photovoltaic devices, Cu3VSe4NSs thin-films deposited on FTO were subjected to photoelectrochemical testing, showing p-type behavior and stable photocurrents of up to ~ 0.036 mA/cm2. The photocurrent shows a ninefold increase in comparison to reported performance of Cu3VSe4nanocrystals. This proves that quasi-2D sulvanite nanosheets are amenable to thin-film deposition and could show superior PV performance in comparison to nanocrystal thin-films. The obtained electrical impedance spectroscopy signal of the Cu3VSe4 NSs-FTO based electrochemical cell fits an equivalent circuit with the circuit elements of solution resistance (Rs), charge-transfer resistance (Rct), double-layer capacitance (Cdl), and Warburg impedance (W). The estimated charge transfer resistance value of 300 Ω cm2obtained from the Nyquist plot provides an insight into the rate of charge transfer on the electrode/electrolyte interface.
Understanding and controlling the energy transfer between silicon nanocrystals is of significant importance for the design of efficient optoelectronic devices. However, previous studies on silicon nanocrystal energy transfer were limited because of the strict requirements to precisely control the inter-dot distance and to perform all measurements in air-free environments to preclude the effect of ambient oxygen. Here, we systematically investigate the distance-dependent resonance energy transfer in alkyl-terminated silicon nanocrystals for the first time. Silicon nanocrystal solids with inter-dot distances varying from 3 to 5 nm are fabricated by varying the length and surface coverage of alkyl ligands in solution-phase and gas-phase functionalized silicon nanocrystals. The inter-dot energy transfer rates are extracted from steady-state and time-resolved photoluminescence measurements, enabling a direct comparison to theoretical predictions. Our results reveal that the distance-dependent energy transfer rates in Si NCs decay faster than predicted by the Förster mechanism, suggesting higher-order multipole interactions.
more » « less- NSF-PAR ID:
- 10364472
- Publisher / Repository:
- American Institute of Physics
- Date Published:
- Journal Name:
- The Journal of Chemical Physics
- Volume:
- 156
- Issue:
- 12
- ISSN:
- 0021-9606
- Page Range / eLocation ID:
- Article No. 124705
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
more » « less
Abstract -
Anion exchange is a facile, post-synthetic method to tune the emission wavelength of colloidal cesium lead halide (CsPbX3, X = Cl, Br, I) perovskite nanocrystals. While colloidal nanocrystals can exhibit size-dependent phase stability and chemical reactivity, the role of size in the mechanism of anion exchange in CsPbX3 nanocrystals has not been elucidated. We used single-particle fluorescence microscopy to monitor the transformation of individual CsPbBr3 nanocrystals to CsPbI3. By systematically varying the size of the nanocrystals and the concentration of substitutional iodide, we observed that smaller nanocrystals exhibit longer transition times in their fluorescence trajectories, while larger nanocrystals undergo a more abrupt transition during anion exchange. Monte Carlo simulations were used to rationalize the size-dependent reactivity, in which we varied how each exchange event affects the probability for further exchange. Greater cooperativity for simulated ion exchange leads to shorter transition times to complete the exchange. We propose that size-dependent miscibility between CsPbBr3 and CsPbI3 at the nanoscale controls the reaction kinetics. Smaller nanocrystals maintain a homogeneous composition during anion exchange. As the nanocrystal size increases, variations in the octahedral tilting patterns of the perovskite crystals lead to different structures for CsPbBr3 and CsPbI3. Thus, an iodide-rich region must first nucleate within larger CsPbBr3 nanocrystals, which is followed by rapid transformation to CsPbI3. While higher concentrations of substitutional anions can suppress this size-dependent reactivity, the inherent differences in reactivity between nanocrystals of different sizes are important to consider when scaling up this reaction for applications in solid-state lighting and biological imaging.more » « less
-
A general method is developed for removal of native nonpolar oleate ligands from colloidal metal oxide nanocrystals of varying morphologies and compositions. Ligand stripping occurs by phase transfer into potassium hydroxide solution, yielding stable aqueous dispersions with little nanocrystal aggregation and without significant changes to the nanomaterials’ physical or chemical properties. This method enables facile fabrication of conductive films of ligand-free nanocrystals.more » « less
-
more » « less
Abstract In an effort to produce the materials of next‐generation photoelectronic devices, postsynthesis halide exchange reactions of perovskite quantum dots are explored to achieve enhanced bandgap tunability. However, comprehensive understanding of the multifaceted halide exchange reactions is inhibited by their vast relevant parameter space and complex reaction network. In this work, a facile room‐temperature strategy is presented for rapid halide exchange of inorganic perovskite quantum dots. A comprehensive understanding of the halide exchange reactions is provided by isolating reaction kinetics from precursor mixing rates utilizing a modular microfluidic platform, Quantum Dot Exchanger (QDExer). The effects of ligand composition and halide salt source on the rate and extent of the halide exchange reactions are illustrated. This fluidic platform offers a unique time‐ and material‐efficient approach for studies of solution phase‐processed colloidal nanocrystals beyond those studied here and may accelerate the discovery and optimization of next‐generation materials for energy technologies.
-
Control over the nucleation and growth of lead-halide perovskite crystals is critical to obtain semiconductor films with high quantum yields in optoelectronic devices. In this report, we use the change in fluorescence brightness to image the transformation of individual lead bromide (PbBr 2 ) nanocrystals to methylammonium lead bromide (CH 3 NH 3 PbBr 3 ) via intercalation of CH 3 NH 3 Br. Analyzing this reaction one nanocrystal at a time reveals information that is masked when the fluorescence intensity is averaged over many particles. Sharp rises in the intensity of single nanocrystals indicate they transform much faster than the time it takes for the ensemble average to transform. While the ensemble reaction rate increases with increasing CH 3 NH 3 Br concentration, the intensity rises for individual nanocrystals are insensitive to the CH 3 NH 3 Br concentration. To explain these observations, we propose a phase-transformation model in which the reconstructive transitions necessary to convert a PbBr 2 nanocrystal into CH 3 NH 3 PbBr 3 initially create a high energy barrier for ion intercalation. A critical point in the transformation occurs when the crystal adopts the perovskite phase, at which point the activation energy for further ion intercalation becomes progressively smaller. Monte Carlo simulations that incorporate this change in activation barrier into the likelihood of reaction events reproduce key experimental observations for the intensity trajectories of individual particles. The insights gained from this study may be used to further control the crystallization of CH 3 NH 3 PbBr 3 and other solution-processed semiconductors.more » « less
