Multisatellite altimetry and an eddy‐resolving model with tides are used to quantify the attenuation of the mode‐1 M2 internal tide as it propagates from three major sources in the North Pacific. The model is used to correct the altimetric fluxes for the nonstationary signal that altimeters cannot detect. Because internal tides in the North Pacific are highly stationary, these corrections do not materially impact the decay rate estimates. Fluxes are integrated in wedges extending from the sources to account for interference and radial spreading. Observed attenuation rates are consistent with
The potential influences of turbulence on planktonic processes such as nutrient uptake, grazing, predation, infection, and mating have been explored in hundreds of laboratory and theoretical studies. However, the turbulence levels used may not represent those experienced by oceanic plankton, bringing into question their relevance for understanding planktonic dynamics in the ocean. Here, we take a data‐centric approach to understand the turbulence climate experienced by plankton in the ocean, analyzing over one million turbulence measurements acquired in the open ocean. Median dissipation rates in the upper 100 m were < 10−8 W kg−1, with 99% of the observations < 10−6 W kg−1. Below mixed layers, the median dissipation rate was ~ 10−10 W kg−1, with 99% of the observations < 10−7 W kg−1. Even in strongly mixing layers the median dissipation rates rarely reached 10−5 W kg−1, decreasing by orders of magnitude over 10 m or less in depth. Furthermore, episodes of intense turbulence were transient, transitioning to background levels within 10 min or less. We define three turbulence conditions in the ocean: weak (< 10−8 W kg−1), moderate (10−8–10−6 W kg−1), and strong (> 10−6 W kg−1). Even the strongest of these is much weaker than those used in most laboratory experiments. The most frequent turbulence levels found in this study are weak enough for most plankton—including small protists—to outswim them, and to allow chemical plumes and trails to persist for tens of minutes. Our analyses underscore the primary importance of planktonic behavior in driving individual interactions.
more » « less- NSF-PAR ID:
- 10367592
- Publisher / Repository:
- Wiley Blackwell (John Wiley & Sons)
- Date Published:
- Journal Name:
- Limnology and Oceanography
- Volume:
- 67
- Issue:
- 2
- ISSN:
- 0024-3590
- Page Range / eLocation ID:
- p. 348-363
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
more » « less
Abstract e ‐folding scales between 750 and 3,000 km, suggesting weak dissipation rates (≤10−10 W/kg or 0.75×10−3 W/m2) compared to typical open‐ocean turbulence levels, implicating near‐inertial waves and higher‐mode internal tides in providing the balance of the dissipation in the ocean interior. -
more » « less
Abstract Observations of salinity, temperature, and turbulent dissipation rate were made in the top meter of the ocean using the ship-towed Surface Salinity Profiler as part of the second Salinity Processes in the Upper Ocean Regional Study (SPURS-2) to assess the relationships between wind, rain, near-surface stratification, and turbulence. A wide range of wind and rain conditions were observed in the eastern tropical Pacific Ocean near 10°N, 125°W in summer–autumn 2016 and 2017. Wind was the primary driver of near-surface turbulence and the mixing of rain-formed fresh lenses, with lenses generally persisting for hours when wind speeds were under 5 m s−1and mixing away immediately at higher wind speeds. Rain influenced near-surface turbulence primarily through stratification. Near-surface stratification caused by rainfall or diurnal warming suppressed deeper turbulent dissipation rates when wind speeds were under 3 m s−1. In one case with 4–5 m s−1winds, rain-induced stratification enhanced dissipation rates within the stratified layer. At wind speeds above 7–8 m s−1, strong stratification was not observed in the upper meter during rain, indicating that rain lenses do not form at wind speeds above 8 m s−1. Raindrop impacts enhanced turbulent dissipation rates at these high wind speeds in the absence of near-surface stratification. Measurements of air–sea buoyancy flux, wind speed, and near-surface turbulence can be used to predict the presence of stratified layers. These findings could be used to improve model parameterizations of air–sea interactions and, ultimately, our understanding of the global water cycle.
-
more » « less
Abstract In the Arctic Ocean, limited measurements indicate that the strongest mixing below the atmospherically forced surface mixed layer occurs where tidal currents are strong. However, mechanisms of energy conversion from tides to turbulence and the overall contribution of tidally driven mixing to Arctic Ocean state are poorly understood. We present measurements from the shelf north of Svalbard that show abrupt isopycnal vertical displacements of 10–50 m and intense dissipation associated with cross‐isobath diurnal tidal currents of
∼ 0.15 m s−1 . Energy from the barotropic tide accumulated in a trapped baroclinic lee wave during maximum downslope flow and was released around slack water. During a 6‐hr turbulent event, high‐frequency internal waves were present, the full 300‐m depth water column became turbulent, dissipation rates increased by a factor of 100, and turbulent heat flux averaged 15 W m−2 compared with the background rate of 1 W m−2 . -
more » « less
Abstract Pacific Summer Water eddies and intrusions transport heat and salt from boundary regions into the western Arctic basin. Here we examine concurrent effects of lateral stirring and vertical mixing using microstructure data collected within a Pacific Summer Water intrusion with a length scale of ∼20 km. This intrusion was characterized by complex thermohaline structure in which warm Pacific Summer Water interleaved in alternating layers of
m thickness with cooler water, due to lateral stirring and intrusive processes. Along interfaces between warm/salty and cold/freshwater masses, the density ratio was favorable to double-diffusive processes. The rate of dissipation of turbulent kinetic energy ( ε ) was elevated along the interleaving surfaces, with values up to 3 × 10−8W kg−1compared to backgroundε of less than 10−9W kg−1. Based on the distribution ofε as a function of density ratioRρ , we conclude that double-diffusive convection is largely responsible for the elevatedε observed over the survey. The lateral processes that created the layered thermohaline structure resulted in vertical thermohaline gradients susceptible to double-diffusive convection, resulting in upward vertical heat fluxes. Bulk vertical heat fluxes above the intrusion are estimated in the range of 0.2–1 W m−2, with the localized flux above the uppermost warm layer elevated to 2–10 W m−2. Lateral fluxes are much larger, estimated between 1000 and 5000 W m−2, and set an overall decay rate for the intrusion of 1–5 years. -
more » « less
Abstract Physical processes behind flow‐topography interactions and turbulent transitions are essential for parameterization in numerical models. We examine how the Kuroshio cascades energy into turbulence upon passing over a seamount, employing a combination of shipboard measurements, tow‐yo microstructure profiling, and high‐resolution mooring. The seamount, spanning 5 km horizontally with two summits, interacts with the Kuroshio, whose flow speed ranges from 1 to 2 m s−1, modulated by tides. The forward energy cascade process is commenced by forming a train of 2–3 nonlinear lee waves behind the summit with a wavelength of 0.5–1 km and an amplitude of 50–100 m. A train of Kelvin‐Helmholtz (KH) billows develops immediately below the lee waves and extends downstream, leading to enhanced turbulence. The turbulent kinetic energy dissipation rate is
O (10−7–10−4) W kg−1, varying in phase with the upstream flow speed modulated by tides. KH billows occur primarily at the lee wave's trailing edge, where the combined strong downstream shear and low‐stratification recirculation trigger the shear instability,Ri < 1/4. The recirculation also creates an overturn susceptible to gravitational instability. This scenario resembles the rotor, commonly found in atmospheric mountain waves but rarely observed in the ocean. A linear stability analysis further suggests that critical levels, where the KH instability extracts energy from the mean flow, are located predominantly at the strong shear layer of the lee wave's upwelling portion, coinciding with the upper boundary of the rotor. These novel observations may provide insights into flow‐topography interactions and improve physics‐based turbulence parameterization.
