More Like this

1. Investigating temperature and origin of fluids that circulated within a brittle fault array in the West Antarctic Rift System

   Pollatsek, Emory ; Siddoway, Christine ; and Gevedon, Michelle ( September 2022 , 29th West Antarctic Ice Sheet Workshop)

   Outcrops of brittle faults are rare in Marie Byrd Land, West Antarctica, because fault damage zones commonly undergo enhanced erosion and form bedrock troughs occupied by glacier ice. Where exposures do exist, faults yield information about regional strain in the West Antarctic Rift System (WARS) and may host minerals that contain a record of the temperature and chemistry of fluids during regional-scale faulting. In MBL’s southern Ford Ranges, bordering Ross Sea, a distinctive fault array was sampled that hosts tourmaline and quartz, a mineral-pair that can provide temperature and composition of fault-associated fluids, using 18O. Host rocks are tourmaline-free. At three separate sites, fault surfaces display strongly aligned tourmaline, suggesting that mineralization occurred during tectonism. One site features highly polished, or mirrored, surfaces, a characteristic that may indicate tourmaline precipitation during seismic slip. The orientation and kinematics of the high angle faults are NNW-striking: normal-slip, and WNW-ESE striking: right-lateral strike-slip. The timing of mineralization is yet to be determined, but viable possibilities are that the faults formed during broad intracontinental extension during formation of Ross Embayment in the Cretaceous, or during development of deep, narrow basins beneath the RIS grounding zone, in the Neogene (newly detected, see Tankersley et al., this meeting). Once formed, tourmaline is resistant to chemical and isotopic re-equilibration, and therefore can retain a record of its conditions during formation. We used oxygen isotope compositions of tourmaline and quartz pairs to investigate temperatures, fluid-rock ratios, and fluid sources, with bearing on fault-localized flux of fluids and geothermal heat. Analyzed tourmaline and quartz were separated from the upper ~2mm of the fault surfaces, as well as quartz separated from host rock in the same hand samples. Tourmaline 18O ratios (n=4) fall within a range of +9.2 to +10.4 ± 0.1 ‰ VSMOW (average 9.7‰, StDev = 0.7). Paired quartz yield 18O values of +11.1 to +10.3 ± 0.1 ‰. Relative isotopic homogeneity between sites suggests similar fluid conditions were present across the region and supports field evidence for that the structures form a regional fault array. ∆Qtz-Trm values fall between 1.3 and 2.0, and 18O of quartz in faults closely resembles 18O of host rock quartz. We tentatively determine the water oxygen isotope ratio as greater than ~7.7 ‰. Plutonic-metamorphic associations in the immediate region, and comparisons with similar faults elsewhere (i.e. Isola d’Elba, Italy), suggest temperatures as high as 500°C for the fluids that circulated into the faults. The data are interpreted to show that brittle faults provided pathways for hot fluids derived from mid-crustal processes to make their way to shallow crustal depths. 18O values indicate magmatic and/or metamorphic fluid sources, with minor to no introduction of meteoric fluids. Tourmaline-quartz pairs did not attain equilibrium, likely due to tourmaline’s rapid crystallization. On-going investigation includes analysis of H and B isotopes in tourmaline, which will better characterize the relationship between fault-hosted and mid-crustal fluids. 

   more » « less
2. STYLES AND HISTORY OF CONVERGENT MARGIN DEFORMATION IN THE SOUTHERN CALIFORNIA BATHOLITH DURING THE LATE CRETACEOUS BEGINNING OF THE LARAMIDE OROGENY

   https://doi.org/10.1130/abs/2023AM-394531  

   Baskin, Jillyan ; Klepeis, Keith ; Schwartz, Joshua ; Miranda, Elena ; Robles, Francine ; Mora-Klepeis, Gabriela ( October 2023 , Geological Society of America Abstracts with Programs)

   In the eastern San Gabriel Mountains, located north of Los Angeles, California, the late Cenozoic Cucamonga thrust has uplifted and exposed the lower crustal root of the Mesozoic Southern California Batholith. We use structural data and U-Pb zircon analyses from these exposures to document changes in the style of intra-arc deformation in the batholith as the Laramide Orogeny began during the Late Cretaceous (at or after ~90 Ma). At the base of the uplifted section, a 4 km-thick package of metasedimentary rock records the intrusion of amphibolite, charnokite and other dikes of probable Jurassic to Early Cretaceous age. The oldest gneissic fabrics (S1, S2) in these rocks record Early Cretaceous partial melting, granulite-facies metamorphism, and top-to-the-S and -SE (present day reference frame) reverse motion on surfaces that dip moderately to the N and NW. These structures define a D1/D2 thrust system that formed on the trench side of the arc and was active during the Early Cretaceous. From 89-77 Ma this thrust system was reactivated by oblique-slip shear zones (D3) that record sinistral-reverse displacements on N- and NW-dipping surfaces. The timing of deformation in these latter shear zones is indicated by the age of 90-85 Ma syn-kinematic intrusions of the Tonalite of San Sevaine Lookout. After emplacement of the tonalite, the lower crustal section was deformed by a series of S-vergent, overturned folds. The emplacement of granodioritic dikes into the axial planes of some of these folds suggests that they formed during the latest stages of D3 transpression and tonalite emplacement. Superimposed on all these structures are a series of ductile-to-brittle thrust faults and folds that appear to be related to formation of the late Cenozoic Cucamonga thrust fault at the southern edge of the San Gabriel mountains. These data show that the Southern California Batholith in the San Gabriel Mountains records a tectonic transition from Early Cretaceous reverse faulting and crustal imbrication on the trench side of the arc to Late Cretaceous transpression and oblique sinistral-reverse deformation during a magmatic flare-up from 89-77 Ma. Another major episode of shortening and crustal imbrication occurred during the late Cenozoic when the Cucamonga thrust uplifted the San Gabriel block. 

   more » « less
3. Paleoseismic Trenching Reveals Late Quaternary Kinematics of the Leech River Fault: Implications for Forearc Strain Accumulation in Northern Cascadia

   https://doi.org/10.1785/0120200204  

   Harrichhausen, Nicolas ; Morell, Kristin D. ; Regalla, Christine ; Bennett, Scott E. ; Leonard, Lucinda J. ; Lynch, Emerson M. ; Nissen, Edwin ( January 2021 , Bulletin of the Seismological Society of America)

   null (Ed.)

   ABSTRACT New paleoseismic trenching indicates late Quaternary oblique right-lateral slip on the Leech River fault, southern Vancouver Island, Canada, and constrains permanent forearc deformation in northern Cascadia. A south-to-north reduction in northward Global Navigation Satellite System velocities and seismicity across the Olympic Mountains, Strait of Juan de Fuca (JDF), and the southern Strait of Georgia, has been used as evidence for permanent north–south crustal shortening via thrust faulting between a northward migrating southern forearc and rigid northern backstop in southwestern Canada. However, previous paleoseismic studies indicating late Quaternary oblique right-lateral slip on west-northwest-striking forearc faults north of the Olympic Mountains and in the southern Strait of Georgia are more consistent with forearc deformation models that invoke oroclinal bending and(or) westward extrusion of the Olympic Mountains. To help evaluate strain further north across the Strait of JDF, we present the results from two new paleoseismic trenches excavated across the Leech River fault. In the easternmost Good Hope trench, we document a vertical fault zone and a broad anticline deforming glacial till. Comparison of till clast orientations in faulted and undeformed glacial till shows evidence for postdeposition faulted till clast rotation, indicating strike-slip shear. The orientation of opening mode fissuring during surface rupture is consistent with right-lateral slip and the published regional SHmax directions. Vertical separation and the formation of scarp-derived colluvium along one fault also indicate a dip-slip component. Radiocarbon charcoal dating within offset glacial till and scarp-derived colluvium suggest a single surface rupturing earthquake at 9.4±3.4  ka. The oblique right-lateral slip sense inferred in the Good Hope trench is consistent with slip kinematics observed on other regional west-northwest-striking faults and indicates that these structures do not accommodate significant north–south shortening via thrust faulting. 

   more » « less
4. How a strong low-angle normal fault formed: The Whipple detachment, southeastern California

   https://doi.org/10.1130/B35386.1  

   Axen, Gary J. ( December 2019 , GSA Bulletin)

   Abstract Many low-angle normal faults (dip ≤30°) accommodate tens of kilometers of crustal extension, but their mechanics remain contentious. Most models for low-angle normal fault slip assume vertical maximum principal stress σ1, leading many authors to conclude that low-angle normal faults are poorly oriented in the stress field (≥60° from σ1) and weak (low friction). In contrast, models for low-angle normal fault formation in isotropic rocks typically assume Coulomb failure and require inclined σ1 (no misorientation). Here, a data-based, mechanical-tectonic model is presented for formation of the Whipple detachment fault, southeastern California. The model honors local and regional geologic and tectonic history and laboratory friction measurements. The Whipple detachment fault formed progressively in the brittle-plastic transition by linking of “minidetachments,” which are small-scale analogs (meters to kilometers in length) in the upper footwall. Minidetachments followed mylonitic anisotropy along planes of maximum shear stress (45° from the maximum principal stress), not Coulomb fractures. They evolved from mylonitic flow to cataclasis and frictional slip at 300–400 °C and ∼9.5 km depth, while fluid pressure fell from lithostatic to hydrostatic levels. Minidetachment friction was presumably high (0.6–0.85), based upon formation of quartzofeldspathic cataclasite and pseudotachylyte. Similar mechanics are inferred for both the minidetachments and the Whipple detachment fault, driven by high differential stress (∼150–160 MPa). A Mohr construction is presented with the fault dip as the main free parameter. Using “Byerlee friction” (0.6–0.85) on the minidetachments and the Whipple detachment fault, and internal friction (1.0–1.7) on newly formed Reidel shears, the initial fault dips are calculated at 16°–26°, with σ1 plunging ∼61°–71° northeast. Linked minidetachments probably were not well aligned, and slip on the evolving Whipple detachment fault probably contributed to fault smoothing, by off-fault fracturing and cataclasis, and to formation of the fault core and fractured damage zone. Stress rotation may have occurred only within the mylonitic shear zone, but asymmetric tectonic forces applied to the brittle crust probably caused gradual rotation of σ1 above it as a result of: (1) the upward force applied to the base of marginal North America by buoyant asthenosphere upwelling into an opening slab-free window and/or (2) basal, top-to-the-NE shear traction due to midcrustal mylonitic flow during tectonic exhumation of the Orocopia Schist. The mechanical-tectonic model probably applies directly to low-angle normal faults of the lower Colorado River extensional corridor, and aspects of the model (e.g., significance of anisotropy, stress rotation) likely apply to formation of other strong low-angle normal faults. 

   more » « less
5. Origin of Au-Rich Carbonate-Hosted Replacement Deposits of the Kassandra Mining District, Northern Greece: Evidence for Late Oligocene, Structurally Controlled, and Zoned Hydrothermal Systems

   https://doi.org/10.5382/econgeo.4664  

   Siron, Chris R. ; Thompson, John F.H. ; Baker, Tim ; Darling, Robert ; Dipple, Gregory ( November 2019 , Economic Geology)

   Abstract The Au-rich polymetallic massive sulfide orebodies of the Kassandra mining district belong to the intrusion-related carbonate-hosted replacement deposit class. Marble lenses contained within the Stratoni fault zone host the Madem Lakkos and Mavres Petres deposits at the eastern end of the fault system, where paragenetically early skarn and massive sulfide are spatially associated with late Oligocene aplitic and porphyritic dikes. Skarn transitions into predominant massive and banded replacement sulfide bodies, which are overprinted by a younger assemblage of boulangerite-bearing, quartz-rich sulfide and late quartz-rhodochrosite vein breccias. The latter style of mineralization is most abundant at the Piavitsa prospect at the western end of the exposed fault system. The sulfide orebodies at the Olympias deposit are hosted by marble in association with the Kassandra fault, where textural and mineralogical similarities to the sulfide bodies within the Stratoni fault zone suggest a genetic relationship. Estimated trapping temperatures and pressures based on fluid inclusion data indicate that carbonate replacement mineralization took place at depths less than about 5.9 km. Carbon and oxygen isotope patterns in carbonate from the Stratoni fault zone support isotopic exchange principally through fluid–wall-rock interaction, whereas decarbonation and fluid-rock exchange reactions were important at the Olympias deposit. Carbonate minerals associated with skarn and replacement sulfide throughout the district have isotopic compositions that are consistent with formation from a hydrothermal fluid of magmatic origin. Lower homogenization temperatures and salinities in the younger quartz-rich sulfide assemblage and quartz-rhodochrosite vein breccias, together with low δ18O values of gangue carbonate, suggest dilution of a primary magmatic fluid with meteoric water late in the evolution of the hydrothermal system in both the Olympias area and the Stratoni fault zone. The replacement sulfide orebodies in the district likely inherited their uniform Pb isotope composition from a late Oligocene igneous source and the isotopically heterogeneous metamorphic basement units. Metal distribution patterns at the scale of the Stratoni fault zone show diminishing Cu concentration with decreasing Pb/Zn and Ag/Au ratios from Madem Lakkos to Mavres Petres and the Piavitsa prospect in the west. The sulfide orebodies at the Olympias deposit exhibit elevated Cu values in the east with increasing Pb/Zn and Ag/Au ratios down-plunge to the south-southwest. Metal concentration and ratios support zoning related to temperature and solubility changes with increasing distance from a probable magmatic source. Structural and igneous relationships, together with fluid inclusion microthermometric and carbon-oxygen isotope data and metal distribution patterns, are supportive of a zoned hydrothermal system that exceeded 12 km along the Stratoni fault zone, sourced by an igneous intrusion to the southeast of the Madem Lakkos deposit. The Olympias replacement sulfide orebodies, associated with the Kassandra fault, resulted from a local hydrothermal system that was likely derived from a concealed igneous intrusion to the east of the deposit. 

   more » « less