The recent discovery of Li‐excess cation‐disordered rock salt cathodes has greatly enlarged the design space of Li‐ion cathode materials. Evidence of facile lattice fluorine substitution for oxygen has further provided an important strategy to enhance the cycling performance of this class of materials. Here, a group of Mn3+–Nb5+‐based cation‐disordered oxyfluorides, Li1.2Mn3+0.6+0.5
Li‐excess disordered rocksalts (DRXs) are emerging as promising cathode materials for Li‐ion batteries due to their ability to use earth‐abundant transition metals. In this work, a new strategy based on partial Li deficiency engineering is introduced to optimize the overall electrochemical performance of DRX cathodes. Specifically, by using Mn‐based DRX as a proof‐of‐concept, it is demonstrated that the introduction of cation vacancies during synthesis (e.g., Li1.3‐
- NSF-PAR ID:
- 10386034
- Publisher / Repository:
- Wiley Blackwell (John Wiley & Sons)
- Date Published:
- Journal Name:
- Advanced Energy Materials
- Volume:
- 13
- Issue:
- 4
- ISSN:
- 1614-6832
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
more » « less
Abstract x Nb5+0.2−0.5x O2−x Fx (x = 0, 0.05, 0.1, 0.15, 0.2) is investigated and it is found that fluorination improves capacity retention in a very significant way. Combining spectroscopic methods and ab initio calculations, it is demonstrated that the increased transition‐metal redox (Mn3+/Mn4+) capacity that can be accommodated upon fluorination reduces reliance on oxygen redox and leads to less oxygen loss, as evidenced by differential electrochemical mass spectroscopy measurements. Furthermore, it is found that fluorine substitution also decreases the Mn3+‐induced Jahn–Teller distortion, leading to an orbital rearrangement that further increases the contribution of Mn‐redox capacity to the overall capacity. -
more » « less
Abstract Mn‐redox‐based oxides and oxyfluorides are considered the most promising earth‐abundant high‐energy cathode materials for next‐generation lithium‐ion batteries. While high capacities are obtained in high‐Mn content cathodes such as Li‐ and Mn‐rich layered and spinel‐type materials, local structure changes and structural distortions ( often lead to voltage fade, capacity decay, and impedance rise, resulting in unacceptable electrochemical performance upon cycling. In the present study, structural transformations that exploit the high capacity of Mn‐rich oxyfluorides while enabling stable cycling, in stark contrast to commonly observed structural changes that result in rapid performance degradation, are reported. It is shown that upon cycling of a cation‐disordered rocksalt (DRX) cathode (Li1.1Mn0.8Ti0.1O1.9F0.1, an ultrahigh capacity of ≈320 mAh g−1(energy density of ≈900 Wh kg−1) can be obtained through dynamic structural rearrangements upon cycling , along with a unique voltage profile evolution and capacity rise. At high voltage, the presence of Mn4+and Li+vacancies promotes local cation ordering, leading to the formation of domains of a “
δ phase” within the disordered framework. On deep discharge, Mn4+reduction, along with Li+insertion transform the structure to a partially ordered DRX phase with aβ ′‐LiFeO2‐type arrangement. At the nanoscale, domains of the in situ formed phases are randomly oriented, allowing highly reversible structural changes and stable electrochemical cycling. These new insights not only help explain the superior electrochemical performance of high‐Mn DRXbut also provide guidance for the future development of Mn‐based, high‐energy density oxide, and oxyfluoride cathode materials. -
more » « less
Abstract Cation‐disordered rocksalt (DRX) cathodes have recently emerged as a promising class of cobalt‐free, high‐capacity cathodes for lithium‐ion batteries. To facilitate their commercialization, the development of scalable synthesis techniques providing control over composition and morphology is critical. To this end, a sol‐gel synthesis route to prepare Mn‐rich DRX cathodes with high capacities is presented here. Several compositions with varied Mn content and nominal F doping are successfully prepared using this technique. In‐situ X‐ray diffraction measurements demonstrate that DRX formation proceeds at moderate temperature (800 °C) through the sol‐gel route, which enables intimate mixing among reactive intermediate phases that form at lower temperatures. All synthesized compositions possess cation short‐range order, as evidenced by neutron pair distribution function and electron diffraction analysis. These DRX materials demonstrate promising electrochemical performance with reversible capacities up to 275 mAh g. Compared to the baseline oxide (Li1.2Mn0.4Ti0.4O2), the Mn‐rich compositions exhibit improved cycling stability, with some showing an increase in capacity upon cycling. Overall, this study demonstrates the feasibility of preparing high‐capacity DRX cathodes through a sol‐gel based synthesis route, which may be further optimized to provide better control over the product morphology compared to traditional synthesis methods.
-
more » « less
Abstract A new concentrated ternary salt ether‐based electrolyte enables stable cycling of lithium metal battery (LMB) cells with high‐mass‐loading (13.8 mg cm−2, 2.5 mAh cm−2) NMC622 (LiNi0.6Co0.2Mn0.2O2) cathodes and 50 μm Li anodes. Termed “CETHER‐3,” this electrolyte is based on LiTFSI, LiDFOB, and LiBF4with 5 vol% fluorinated ethylene carbonate in 1,2‐dimethoxyethane. Commercial carbonate and state‐of‐the‐art binary salt ether electrolytes were also tested as baselines. With CETHER‐3, the electrochemical performance of the full‐cell battery is among the most favorably reported in terms of high‐voltage cycling stability. For example, LiNi
x Mny Co1–x –y O2(NMC)‐Li metal cells retain 80% capacity at 430 cycles with a 4.4 V cut‐off and 83% capacity at 100 cycles with a 4.5 V cut‐off (charge at C/5, discharge at C/2). According to simulation by density functional theory and molecular dynamics, this favorable performance is an outcome of enhanced coordination between Li+and the solvent/salt molecules. Combining advanced microscopy (high‐resolution transmission electron microscopy, scanning electron microscopy) and surface science (X‐ray photoelectron spectroscopy, time‐of‐fight secondary ion mass spectroscopy, Fourier‐transform infrared spectroscopy, Raman spectroscopy), it is demonstrated that a thinner and more stable cathode electrolyte interphase (CEI) and solid electrolyte interphase (SEI) are formed. The CEI is rich in lithium sulfide (Li2SO3), while the SEI is rich in Li3N and LiF. During cycling, the CEI/SEI suppresses both the deleterious transformation of the cathode R‐3m layered near‐surface structure into disordered rock salt and the growth of lithium metal dendrites. -
more » « less
Abstract The performance of all‐solid‐state batteries (ASSBs) relies on the Li+transport and stability characteristics of solid electrolytes (SEs). Li3PS4is notable for its stability against lithium metal, yet its ionic conductivity remains a limiting factor. This study leverages local structural disorder via O substitution to achieve an ionic conductivity of 1.38 mS cm−1with an activation energy of 0.34 eV for Li3PS4−
x Ox (x = 0.31). Optimal O substitution transforms Li+transport from 2D to 3D pathways with increased ion mobility. Li3PS3.69O0.31exhibits improvements in the critical current density and stability against Li metal and retains its electrochemical stability window compared with Li3PS4. The practical implementation of Li3PS3.69O0.31in ASSBs half‐cells, particularly when coupled with TiS2as the cathode active material, demonstrates substantially enhanced capacity and rate performance. This work elucidates the utility of introducing local structural disorder to ameliorate SE properties and highlights the benefits of strategically combining the inherent strengths of sulfides and oxides via creating oxysulfide SEs.
