In this paper, we investigate the three-dimensional nature of dynamic stall. Conducting the investigation, the flow around a harmonically pitching National Advisory Committee for Aeronautics (NACA) 0012 airfoil is numerically simulated using Unsteady-Reynolds-Averaged Navier–Stokes (URANS) and multiple detached eddy simulation (DES) solvers: the Delayed-DES (DDES) and the Improved-DDES (IDDES). Two- and three-dimensional simulations are performed for each solver, and the results are compared against experimental measurements in the literature. The results showed that three-dimensional simulations surpass two-dimensional ones in capturing the stages of dynamic stall and predicting the lift coefficient values, with a distinguished performance of the DES solvers over the URANS ones. For instance, the IDDES simulations, as an inherently three-dimensional solver, predicted the necessary cascaded amalgamation process of vortices to form the adequate strength of the dynamic stall vortex. This vortex size and timing provided accurate and sufficient suction that resulted in identical matching of the numerical and experimental lift coefficients at the peak value. Hence, the hypothesis that dynamic stall has a three-dimensional nature is supported by the superiority of the three-dimensional simulation in all aspects. In conclusion, it is found that dynamic stall is intrinsically a three-dimensional phenomenon.
- Award ID(s):
- 1852102
- NSF-PAR ID:
- 10414214
- Date Published:
- Journal Name:
- AIAA Region I Conference, March 2023
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
more » « less
-
null (Ed.)Flow of a semidilute neutrally buoyant and non-colloidal suspension is numerically studied in the Taylor–Couette geometry where the inner cylinder is rotating and the outer one is stationary. We consider a suspension with bulk particle volume fraction ${\phi _b} = 0.1$ , the radius ratio $(\eta = {r_i}/{r_o} = 0.877)$ and two particle size ratios $\mathrm{\epsilon }\,( = \; d\textrm{/}a) = 60,\;200$ , where d is the gap width ( $= {r_o} - {r_i}$ ) between cylinders, a is the suspended particles’ radius and $r_i$ and $r_o$ are the inner and outer radii of the cylinder, respectively. Numerical simulations are conducted using the suspension balance model (SBM) and rheological constitutive laws. We predict the critical Reynolds number in which counter-rotating vortices arise in the annulus. It turns out that the primary instability appears through a supercritical bifurcation. For the suspension of $\mathrm{\epsilon } = 200$ , the circular Couette flow (CCF) transitions via Taylor vortex flow (TVF) to wavy vortex flow (WVF). Additional flow states of non-axisymmetric vortices, namely spiral vortex flow (SVF) and wavy spiral vortex flow (WSVF) are observed between CCF and WVF for the suspension of $\mathrm{\epsilon } = 60$ ; thus, the transitions occur following the sequence of CCF → SVF → WSVF → WVF. Furthermore, we estimate the friction and torque coefficients of the suspension. Suspended particles substantially enhance the torque on the inner cylinder, and the axial travelling wave of spiral vortices reduces the friction and torque coefficients. However, the coefficients are practically the same in the WVF regime where particles are almost uniformly distributed in the annulus by the axial oscillating flow.more » « less
-
Well-resolved measurements of the small-scale dissipation statistics within turbulent channel flow are reported for a range of Reynolds numbers from $Re_{{\it\tau}}\approx 500$ to 4000. In this flow, the local large-scale Reynolds number based on the longitudinal integral length scale is found to poorly describe the Reynolds number dependence of the small-scale statistics. When a length scale based on Townsend’s attached-eddy hypothesis is used to define the local large-scale Reynolds number, the Reynolds number scaling behaviour was found to be more consistent with that observed in homogeneous, isotropic turbulence. The Reynolds number scaling of the dissipation moments up to the sixth moment was examined and the results were found to be in good agreement with predicted scaling behaviour (Schumacher et al. , Proc. Natl Acad. Sci. USA , vol. 111, 2014, pp. 10961–10965). The probability density functions of the local dissipation scales (Yakhot, Physica D, vol. 215 (2), 2006, pp. 166–174) were also determined and, when the revised local large-scale Reynolds number is used for normalization, provide support for the existence of a universal distribution which scales differently for inner and outer regions.more » « less
-
more » « less
Abstract A flow vessel with an elastic wall can deform significantly due to viscous fluid flow within it, even at vanishing Reynolds number (no fluid inertia). Deformation leads to an enhancement of throughput due to the change in cross‐sectional area. The latter gives rise to a non‐constant pressure gradient in the flow‐wise direction and, hence, to a nonlinear flow rate–pressure drop relation (unlike the Hagen–Poiseuille law for a rigid tube). Many biofluids are non‐Newtonian, and are well approximated by generalized Newtonian (say, power‐law) rheological models. Consequently, we analyze the problem of steady low Reynolds number flow of a generalized Newtonian fluid through a slender elastic tube by coupling fluid lubrication theory to a structural problem posed in terms of Donnell shell theory. A perturbative approach (in the slenderness parameter) yields analytical solutions for both the flow and the deformation. Using matched asymptotics, we obtain a uniformly valid solution for the tube's radial displacement, which features both a boundary layer and a corner layer caused by localized bending near the clamped ends. In doing so, we obtain a “generalized Hagen–Poiseuille law” for soft microtubes. We benchmark the mathematical predictions against three‐dimensional two‐way coupled direct numerical simulations (DNS) of flow and deformation performed using the commercial computational engineering platform by ANSYS. The simulations show good agreement and establish the range of validity of the theory. Finally, we discuss the implications of the theory on the problem of the flow‐induced deformation of a blood vessel, which is featured in some textbooks.
-
Accurate prediction of the dynamics and deformation of freely moving drops is crucial for numerous droplet applications. When the Weber number is finite but below a critical value, the drop deviates from its spherical shape and deforms as it is accelerated by the gas stream. Since aerodynamic drag on the drop depends on its shape oscillation, accurately modeling the drop shape evolution is essential for predicting the drop's velocity and position. In this study, 2D axisymmetric interface-resolved simulations were performed to provide a comprehensive dataset for developing a data-driven model. Parametric simulations were conducted by systematically varying the drop diameter and free-stream velocity, achieving wide ranges of Weber and Reynolds numbers. The instantaneous drop shapes obtained in simulations are characterized by spherical harmonics. Temporal data of the drag and modal coefficients are collected from the simulation data to train a {Nonlinear Auto-Regressive models with eXogenous inputs} (NARX) neural network model. The overall model consists of two multi-layer perceptron networks, which predict the modal coefficients and the drop drag, respectively. The drop shape can be reconstructed with the predicted modal coefficients. The model predictions are validated against the simulation data in the testing set, showing excellent agreement for the evolutions of both the drop shape and drag.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Conference Paper:
- The DOI is not currently available.
