An official website of the United States government
The temporal variation of elastic property of the bulk material surrounding the fault is considered an important contribution to the observed co-seismic velocity reduction and interseismic healing. Paglialunga et al. [2021] found that as fault normal stress increases, co-seismic velocity reduction becomes larger because more cracks reopen with higher stress drops. Larger normal stress can lead to smaller nucleation size and contribute to larger co-seismic slip. By contrast, with larger co-seismic velocity reduction and interseismic healing, more slow slip events can propagate in the seismogenic zone [Thakur and Huang, 2021], because the temporal velocity change related to fault zone damage modulates earthquake nucleation. Hence, fault normal stress and temporal damage zone structure evolution have opposite influences on the spatial distribution and recurrence intervals of earthquakes. We conducted 2-D anti-plane fully-dynamic seismic cycle simulations and explored the effects of fault normal stress on seismic cycle when there is coseismic damage and interseismic healing in the fault damage zone. The normal stress is in a range of 40-70 MPa and the co-seismic rigidity reduction is in a range of 5-8%. We find larger normal stress results in larger co-seismic slip and fewer slow slip events, while more co-seismic velocity reduction and interseismic healing leads to more partial ruptures as well as slow slip events. With the increase of both normal stress and seismic velocity change, more regular earthquakes occur and slow slip events gradually disappear. For the selected parameter space, the influence of seismic velocity change is not as significant as the effect of normal stress. However, fault zone maturity or the initial rigidity of fault damage zones should also affect the competitive relationship between normal stress and seismic velocity change, and we will characterize earthquakes and slow-slip events in immature and mature fault damage zones when both on-fault normal stress and off-fault seismic velocity vary over earthquake cycles.
more »
« less
Seismological Stress Drops for Confined Ruptures Are Invariant to Normal Stress
Abstract Seismic moment and rupture length can be combined to infer stress drop, a key parameter for assessing earthquakes. In natural earthquakes, stress drops are largely depth‐independent, which is surprising given the expected dependence of frictional stress on normal stresses and hence overburden. We have developed a transparent experimental fault that allows direct observation of thousands of slip events, with ruptures that are fully contained within the fault. Surprisingly, the observed stress drops are largely independent of both the magnitude of normal stress and its heterogeneity, capturing the independence seen in nature. However, we observe larger, normal stress‐dependent stress drops when the fault area is reduced, which allows slip events to frequently reach the edge of the interface. We conclude that confined ruptures have normal stress independent stress drops, and thus the depth‐independent stress drops of tectonic earthquakes may be a consequence of their confined nature.
more »
« less
- Award ID(s):
- 1761987
- PAR ID:
- 10419760
- Publisher / Repository:
- DOI PREFIX: 10.1029
- Date Published:
- Journal Name:
- Geophysical Research Letters
- Volume:
- 50
- Issue:
- 9
- ISSN:
- 0094-8276
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract Many natural faults are believed to consist of velocity weakening (VW) patches surrounded by velocity strengthening (VS) sections. Numerical studies routinely employ this framework to study earthquake sequences including repeating earthquakes. In this laboratory study, we made a VW asperity, of lengthL, from a bare Poly(methyl methacrylate) PMMA frictional interface and coated the surrounding interface with Teflon to make VS fault sections. Behavior of this isolated asperity was studied as a function ofL(ranging from 100 to 400 mm) and the critical nucleation length, , which is inversely proportional to the applied normal stress (2–16 MPa). Consistent with recent numerical simulations, we observed aseismic slip for < 2, periodic slip for 2 < < 6, and non‐periodic slip for 10 < . Furthermore, we compared the experiments whereLwas contained by VS material to standard stick‐slip events whereLwas bounded by free surfaces (i.e.,L = the total sample length). The free surface case produced ∼10 times larger slip during stick‐slip events compared to the contained fault ruptures, even with identical . This disparity highlights how standard, complete‐rupture stick‐slip events differ from contained events expected in nature, due to both the free surface conditions and the heterogeneous normal stress along the fault near the free ends, as confirmed by Digital Image Correlation analysis. This study not only introduces the Teflon coating experimental technique for containing laboratory earthquake ruptures, but also highlights the utility of as a predictive parameter for earthquake behavior.more » « less
-
Abstract Determining conditions for earthquake slip on faults is a key goal of fault mechanics highly relevant to seismic hazard. Previous studies have demonstrated that enhanced dynamic weakening (EDW) can lead to dynamic rupture of faults with much lower shear stress than required for rupture nucleation. We study the stress conditions before earthquake ruptures of different sizes that spontaneously evolve in numerical simulations of earthquake sequences on rate‐and‐state faults with EDW due to thermal pressurization of pore fluids. We find that average shear stress right before dynamic rupture (aka shear prestress) systematically varies with the rupture size. The smallest ruptures have prestress comparable to the local shear stress required for nucleation. Larger ruptures weaken the fault more, propagate over increasingly under‐stressed areas due to dynamic stress concentration, and result in progressively lower average prestress over the entire rupture. The effect is more significant in fault models with more efficient EDW. We find that, as a result, fault models with more efficient weakening produce fewer small events and result in systematically lower b‐values of the frequency‐magnitude event distributions. The findings (a) illustrate that large earthquakes can occur on faults that appear not to be critically stressed compared to stresses required for slip nucleation; (b) highlight the importance of finite‐fault modeling in relating the local friction behavior determined in the lab to the field scale; and (c) suggest that paucity of small events or seismic quiescence may be the observational indication of mature faults that operate under low shear stress due to EDW.more » « less
-
Abstract We discuss data of three laboratory stick‐slip experiments on Westerly Granite samples performed at elevated confining pressure and constant displacement rate on rough fracture surfaces. The experiments produced complex slip patterns including fast and slow ruptures with large and small fault slips, as well as failure events on the fault surface producing acoustic emission bursts without externally‐detectable stress drop. Preparatory processes leading to large slips were tracked with an ensemble of ten seismo‐mechanical and statistical parameters characterizing local and global damage and stress evolution, localization and clustering processes, as well as event interactions. We decompose complex spatio‐temporal trends in the lab‐quake characteristics and identify persistent effects of evolving fault roughness and damage at different length scales, and local stress evolution approaching large events. The observed trends highlight labquake localization processes on different spatial and temporal scales. The preparatory process of large slip events includes smaller events marked by confined bursts of acoustic emission activity that collectively prepare the fault surface for a system‐wide failure by conditioning the large‐scale stress field. Our results are consistent overall with an evolving process of intermittent criticality leading to large failure events, and may contribute to improved forecasting of large natural earthquakes.more » « less
-
Abstract We use the discrete element method to create numerical analogs to subduction megathrusts with natural roughness and heterogeneous fault friction. Boundary conditions simulate tectonic loading, inducing fault slip. Intermittently, slip develops into complex rupture events that include foreshocks, mainshocks, and aftershocks. We probe the kinematics and stress evolution of the fault zone to gain insight into the physical processes that govern these phenomena. Prolonged, localized differential stress drops precede dynamic failure, a phenomenon we attribute to the gradual unlocking of contacts as the fault dilates prior to rupture. Slip stability in our system appears to be governed primarily by geometrical phenomena, which allow both slow and fast slip to take place at the same areas along the fault. Similarities in slip behavior between simulated faults and real subduction zones affirm that modeled physical processes are also at work in nature.more » « less
