skip to main content
US FlagAn official website of the United States government
dot gov icon
Official websites use .gov
A .gov website belongs to an official government organization in the United States.
https lock icon
Secure .gov websites use HTTPS
A lock ( lock ) or https:// means you've safely connected to the .gov website. Share sensitive information only on official, secure websites.

Explore Research Products in the PAR
It may take a few hours for recently added research products to appear in PAR search results.


Title: Impact of process anneals on high-k/β-Ga 2 O 3 interfaces and capacitance
Gallium oxide (β-Ga 2 O 3 ) is becoming a popular material for high power electronic devices due to its wide bandgap and ease of processing. In this work, β-Ga 2 O 3 substrates received various annealing treatments before atomic layer deposition of HfO 2 and subsequent fabrication of metal–oxide–semiconductor (MOS) capacitors. Annealing of β-Ga 2 O 3 with forming gas or nitrogen produced degraded capacitance–voltage (C–V) behavior compared to a β-Ga 2 O 3 control sample with no annealing. A sample annealed with pure oxygen had improved C–V characteristics relative to the control sample, with a higher maximum capacitance and smaller flat-band voltage shift, indicating that oxygen annealing improved the C–V behavior. X-ray photoelectron spectroscopy also suggested a reduction in the oxygen vacancy concentration after O 2 annealing at 450 °C, which supports the improved C–V characteristics and indicates that O 2 annealing of β-Ga 2 O 3 may lead to better MOS device performance.  more » « less
Award ID(s):
2154535
PAR ID:
10420588
Author(s) / Creator(s):
; ; ; ;
Date Published:
Journal Name:
Journal of Vacuum Science & Technology A
Volume:
41
Issue:
2
ISSN:
0734-2101
Page Range / eLocation ID:
023203
Format(s):
Medium: X
Sponsoring Org:
National Science Foundation
More Like this
  1. ; ; ; ; ; ; ; (, Advanced Electronic Materials)
    Abstract High quality dielectric‐semiconductor interfaces are critical for reliable high‐performance transistors. This paper reports the in situ metal–organic chemical vapor deposition of Al2O3on β‐Ga2O3as a potentially better alternative to the most commonly used atomic layer deposition (ALD). The growth of Al2O3is performed in the same reactor as Ga2O3using trimethylaluminum and O2as precursors without breaking the vacuum at a growth temperature of 600 °C. The fast and slow near interface traps at the Al2O3/β‐Ga2O3interface are identified and quantified using stressed capacitance–voltage (CV) measurements on metal oxide semiconductor capacitor (MOSCAP) structures. The density of shallow and deep level initially filled traps (Dit) are measured using ultraviolet‐assisted CV technique. The average Ditfor the MOSCAP is determined to be 6.4×1011cm−2eV−1. The conduction band offset of the Al2O3/ Ga2O3interface is also determined from CV measurements and found out to be 1.7 eV which is in close agreement with the existing literature reports of ALD Al2O3/Ga2O3interface. The current–voltage characteristics are also analyzed and the average breakdown field is extracted to be approximately 5.8 MV cm−1. This in situ Al2O3dielectric on β‐Ga2O3with improved dielectric properties can enable Ga2O3‐based high‐performance devices. 
    more » « less
  2. (, ECS Journal of Solid State Science and Technology)
    β-Ga2O3is an emerging material and has the potential to revolutionize power electronics due to its ultra-wide-bandgap (UWBG) and lower native substrate cost compared to Silicon Carbide and Gallium Nitride. Sinceβ-Ga2O3technology is still not mature, experimental study ofβ-Ga2O3is difficult and expensive. Technology-Computer-Aided Design (TCAD) is thus a cost-effective way to study the potentials and limitations ofβ-Ga2O3devices. In this paper, TCAD parameters calibrated to experiments are presented. They are used to perform the simulations in heterojunction p-NiO/n-Ga2O3diode, Schottky diode, and normally-off Ga2O3vertical FinFET. Besides the current-voltage (I-V) simulations, breakdown, capacitance-voltage (C-V), and short-circuit ruggedness simulations with robust setups are discussed. TCAD Sentaurus is used in the simulations but the methodologies can be applied in other simulators easily. This paves the road to performing a holistic study ofβ-Ga2O3devices using TCAD. 
    more » « less
  3. ; ; ; ; ; (, Journal of Vacuum Science & Technology A)
    Focused Ga + ion milling of lightly Si-doped, n-type Ga 2 O 3 was performed with 2–30 kV ions at normal incidence and beam currents that were a function of beam voltage, 65 nA for 30 kV, 26 nA for 10 kV, 13 nA for 5 kV, and 7.1 nA for 2 kV, to keep the milling depth constant at 100 nm. Approximate milling rates were 15, 6, 2.75, and 1.5  μm 3 /s for 30, 10, 5, and 2 kV, respectively. The electrical effects of the ion damage were characterized by Schottky barrier height and diode ideality factor on vertical rectifier structures comprising 10  μm epitaxial n-Ga 2 O 3 on n + Ga 2 O 3 substrates, while the structural damage was imaged by transmission electron microscopy. The reverse bias leakage was largely unaffected even by milling at 30 kV beam energy, while the forward current-voltage characteristics showed significant deterioration at 5 kV, with an increase in the ideality factor from 1.25 to 2.25. The I–V characteristics no longer showed rectification for the 30 kV condition. Subsequent annealing up to 400 °C produced substantial recovery of the I–V characteristics for all beam energies and was sufficient to restore the initial ideality factor completely for beam energies up to 5 kV. Even the 30 kV-exposed rectifiers showed a recovery of the ideality factor to 1.8. The surface morphology of the ion-milled Ga 2 O 3 was smooth even at 30 kV ion energy, with no evidence for preferential sputtering of the oxygen. The surface region was not amorphized by extended ion milling (35 min) at 5 kV with the samples held at 25 °C, as determined by electron diffraction patterns, and significant recovery of the lattice order was observed after annealing at 400 °C. 
    more » « less
  4. ; ; ; ; (, Advanced Materials Technologies)
    Abstract Beta gallium oxide (β‐Ga2O3) has emerged as a highly promising semiconductor material with an ultrawide bandgap ranging from 4.5 to 4.9 eV for future applications in power electronics, optoelectronics, as well as gas and ultraviolet (UV) radiation sensors. Here, surface adsorption and air damping behavior of doubly clamped β‐Ga2O3nanomechanical resonators are probed and systemically studied by measuring the resonance characteristics under different gas and pressure conditions. High responsivities of resonance to pressure are obtained by heating the devices up to 300 °C to induce an accelerated adsorption–desorption process. The initial surface conditions of the β‐Ga2O3thin film play important roles in affecting the resonant behavior. UV ozone treatment proves effective in altering the initial surface conditions of β‐Ga2O3nanosheets by eliminating physisorbed contaminants and filling oxygen vacancy defects residing on the surface, resulting in a consequential and discernible modification of the resonance behavior of β‐Ga2O3nanomechanical resonators. The surface adsorption and desorption processes in β‐Ga2O3demonstrate clear reversibility by exposing the UV treated β‐Ga2O3to air. This study attains first‐hand information on how the surface conditions of β‐Ga2O3affect its mechanical properties, and helps guide future development of transducers via β‐Ga2O3nanoelectromechanical systems (NEMS) for pressure sensing applications, especially in harsh environments. 
    more » « less
  5. ; ; ; ; ; ; ; ; ; ; et al (, Journal of Applied Physics)
    We report on growth and electrical properties of α-Ga2O3films prepared by halide vapor phase epitaxy (HVPE) at 500 °C on α-Cr2O3buffers predeposited on sapphire by magnetron sputtering. The α-Cr2O3buffers showed a wide microcathodoluminescence (MCL) peak near 350 nm corresponding to the α-Cr2O3bandgap and a sharp MCL line near 700 nm due to the Cr+intracenter transition. Ohmic contacts to Cr2O3were made with both Ti/Au or Ni, producing linear current–voltage ( I– V) characteristics over a wide temperature range with an activation energy of conductivity of ∼75 meV. The sign of thermoelectric power indicated p-type conductivity of the buffers. Sn-doped, 2- μm-thick α-Ga2O3films prepared on this buffer by HVPE showed donor ionization energies of 0.2–0.25 eV, while undoped films were resistive with the Fermi level pinned at ECof 0.3 eV. The I– V and capacitance–voltage ( C– V) characteristics of Ni Schottky diodes on Sn-doped samples using a Cr2O3buffer indicated the presence of two face-to-face junctions, one between n-Ga2O3and p-Cr2O3, the other due to the Ni Schottky diode with n-Ga2O3. The spectral dependence of the photocurrent measured on the structure showed the presence of three major deep traps with optical ionization thresholds near 1.3, 2, and 2.8 eV. Photoinduced current transient spectroscopy spectra of the structures were dominated by deep traps with an ionization energy of 0.95 eV. These experiments suggest another pathway to obtain p–n heterojunctions in the α-Ga2O3system. 
    more » « less
  • Citation Formats
  • MLA
  • APA
  • Chicago
  • BibTeX
  • Save / Share this Record
  • Send to Email