An advanced aerosol treatment, with a focus on semivolatile nitrate formation, is introduced into the Community Atmosphere Model version 5 with interactive chemistry (CAM5‐chem) by coupling the Model for Simulating Aerosol Interactions and Chemistry (MOSAIC) with the 7‐mode Modal Aerosol Module (MAM7). An important feature of MOSAIC is dynamic partitioning of all condensable gases to the different fine and coarse mode aerosols, as governed by mode‐resolved thermodynamics and heterogeneous chemical reactions. Applied in the free‐running mode from 1995 to 2005 with prescribed historical climatological conditions, the model simulates global distributions of sulfate, nitrate, and ammonium in good agreement with observations and previous studies. Inclusion of nitrate resulted in ∼10% higher global average accumulation mode number concentrations, indicating enhanced growth of Aitken mode aerosols from nitrate formation. While the simulated accumulation mode nitrate burdens are high over the anthropogenic source regions, the sea‐salt and dust modes respectively constitute about 74% and 17% of the annual global average nitrate burden. Regional clear‐sky shortwave radiative cooling of up to −5 W m−2due to nitrate is seen, with a much smaller global average cooling of −0.05 W m−2. Significant enhancements in regional cloud condensation nuclei (at 0.1% supersaturation) and cloud droplet number concentrations are also attributed to nitrate, causing an additional global average shortwave cooling of −0.8 W m−2. Taking into consideration of changes in both longwave and shortwave radiation under all‐sky conditions, the net change in the top of the atmosphere radiative fluxes induced by including nitrate aerosol is −0.7 W m−2.
We incorporate the Model for Simulating Aerosol Interactions and Chemistry (MOSAIC) module in the Community Earth System Model version 2 (CESM2) Community Atmosphere Model Version 6 with interactive chemistry (CAM6‐chem), and couple it with the four mode version of the Modal Aerosol Module (MAM4). The MOSAIC module is used to simulate the thermodynamics of the gas‐aerosol mass exchange, with a special focus on simulating nitrate aerosol. By comparing against ground and satellite observations, we found that the MOSAIC/MAM4 scheme performs reasonably well in simulating spatiotemporal distributions of aerosols, including nitrate aerosol. We conducted a series of model experiments with and without nitrate aerosols, and examined the radiative effect (RE) associated with nitrate aerosols in 1975, 2000, and 2010, and accessed the radiative forcing (RF) of nitrate aerosols between the present day and pre‐industrial periods. Comparing with the nitrate aerosol RE, we predicted relatively small RF of anthropogenic nitrate aerosol from aerosol‐radiation interactions (RFari: −0.014 W m−2) and large RF from aerosol‐cloud interactions (RFaci: −0.219 W m−2). Regional signatures of nitrate RE/RF are noticeable and important: for instance, very small changes in REariin Europe and USA, but 2.8–3 times increases in REariin India and China from 1975 to 2010, while REaci/RFaciin China is a warming effect due to the competing effect between sulfate and nitrate aerosols as cloud condensation nuclei.
more » « less- PAR ID:
- 10449030
- Publisher / Repository:
- DOI PREFIX: 10.1029
- Date Published:
- Journal Name:
- Journal of Geophysical Research: Atmospheres
- Volume:
- 126
- Issue:
- 17
- ISSN:
- 2169-897X
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
more » « less
Abstract -
Abstract. Black carbon (BC) is one of the dominant absorbing aerosol species in the atmosphere. It normally has complex fractal-like structures due to the aggregation process during combustion. A wide range of aerosol–radiation interactions (ARIs) of BC have been reported throughout experimental and modeling studies. One reason for the large discrepancies among multiple studies is the application of the oversimplified spherical morphology for BC in ARI estimates. In current climate models, the Mie theory is commonly used to calculate the optical properties of spherical BC aerosols. Here, we employ a regional chemical transport model coupled with a radiative transfer code that utilizes the non-spherical BC optical simulations to re-evaluate the effects of particles' morphologies on BC shortwave ARI, and the wavelength range of 0.3–4.0 µm was considered. Anthropogenic activities and wildfires are two major sources of BC emissions. Therefore, we choose the typical polluted area in eastern China, which is dominated by anthropogenic emissions, and the fire region in the northwest US, which is dominated by fire emissions in this study. A 1-month simulation in eastern China and a 7 d simulation in the fire region in the northwest US were performed. The fractal BC model generally presents a larger clear-sky ARI compared to the spherical BC model. Assuming BC particles are externally mixed with other aerosols, the relative differences in the time-averaged clear-sky ARI between the fractal model with a fractal dimension (Df) of 1.8 and the spherical model are 12.1 %–20.6 % and 10.5 %–14.9 % for typical polluted urban cities in China and fire sites in the northwest US, respectively. Furthermore, the regional-mean clear-sky ARI is also significantly affected by the BC morphology, and relative differences of 17.1 % and 38.7 % between the fractal model with a Df of 1.8 and the spherical model were observed in eastern China and the northwest US, respectively. However, the existence of clouds would weaken the BC morphological effects. The time-averaged all-sky ARI relative differences between the fractal model with a Df of 1.8 and the spherical model are 4.9 %–6.4 % and 9.0 %–11.3 % in typical urban polluted cities and typical fire sites, respectively. Besides, for the regional-mean all-sky ARI, the relative differences between the fractal model and the spherical model are less than 7.3 % and 16.8 % in the polluted urban area in China and the fire region in the US, respectively. The results imply that current climate modeling may significantly underestimate the BC ARI uncertainties as the morphological effects on BC ARI are ignored in most climate models.more » « less
-
more » « less
Abstract Since 2013, Chinese policies have dramatically reduced emissions of particulates and their gas‐phase precursors, but the implications of these reductions for aerosol‐radiation interactions are unknown. Using a global, coupled chemistry‐climate model, we examine how the radiative impacts of Chinese air pollution in the winter months of 2012 and 2013 affect local meteorology and how these changes may, in turn, influence surface concentrations of PM2.5, particulate matter with diameter <2.5 μm. We then investigate how decreasing emissions through 2016 and 2017 alter this impact. We find that absorbing aerosols aloft in winter 2012 and 2013 heat the middle‐ and lower troposphere by ∼0.5–1 K, reducing cloud liquid water, snowfall, and snow cover. The subsequent decline in surface albedo appears to counteract the ∼15–20 W m−2decrease in shortwave radiation reaching the surface due to attenuation by aerosols overhead. The net result of this novel cloud‐snowfall‐albedo feedback in winters 2012–2013 is a slight increase in surface temperature of ∼0.5–1 K in some regions and little change elsewhere. The aerosol heating aloft, however, stabilizes the atmosphere and decreases the seasonal mean planetary boundary layer (PBL) height by ∼50 m. In winter 2016 and 2017, the ∼20% decrease in mean PM2.5weakens the cloud‐snowfall‐albedo feedback, though it is still evident in western China, where the feedback again warms the surface by ∼0.5–1 K. Regardless of emissions, we find that aerosol‐radiation interactions enhance mean surface PM2.5pollution by 10%–20% across much of China during all four winters examined, mainly though suppression of PBL heights.
-
more » « less
Abstract Aerosols interact with radiation and clouds. Substantial progress made over the past 40 years in observing, understanding, and modeling these processes helped quantify the imbalance in the Earth's radiation budget caused by anthropogenic aerosols, called aerosol radiative forcing, but uncertainties remain large. This review provides a new range of aerosol radiative forcing over the industrial era based on multiple, traceable, and arguable lines of evidence, including modeling approaches, theoretical considerations, and observations. Improved understanding of aerosol absorption and the causes of trends in surface radiative fluxes constrain the forcing from aerosol‐radiation interactions. A robust theoretical foundation and convincing evidence constrain the forcing caused by aerosol‐driven increases in liquid cloud droplet number concentration. However, the influence of anthropogenic aerosols on cloud liquid water content and cloud fraction is less clear, and the influence on mixed‐phase and ice clouds remains poorly constrained. Observed changes in surface temperature and radiative fluxes provide additional constraints. These multiple lines of evidence lead to a 68% confidence interval for the total aerosol effective radiative forcing of ‐1.6 to ‐0.6 W m−2, or ‐2.0 to ‐0.4 W m−2with a 90% likelihood. Those intervals are of similar width to the last Intergovernmental Panel on Climate Change assessment but shifted toward more negative values. The uncertainty will narrow in the future by continuing to critically combine multiple lines of evidence, especially those addressing industrial‐era changes in aerosol sources and aerosol effects on liquid cloud amount and on ice clouds.
-
more » « less
Abstract Aerosols have significant and complex impacts on regional climate in East Asia. Cloud‐aerosol‐precipitation interactions (CAPI) remain most challenging in climate studies. The quantitative understanding of CAPI requires good knowledge of aerosols, ranging from their formation, composition, transport, and their radiative, hygroscopic, and microphysical properties. A comprehensive review is presented here centered on the CAPI based chiefly, but not limited to, publications in the special section named EAST‐AIRcpc concerning (1) observations of aerosol loading and properties, (2) relationships between aerosols and meteorological variables affecting CAPI, (3) mechanisms behind CAPI, and (4) quantification of CAPI and their impact on climate. Heavy aerosol loading in East Asia has significant radiative effects by reducing surface radiation, increasing the air temperature, and lowering the boundary layer height. A key factor is aerosol absorption, which is particularly strong in central China. This absorption can have a wide range of impacts such as creating an imbalance of aerosol radiative forcing at the top and bottom of the atmosphere, leading to inconsistent retrievals of cloud variables from space‐borne and ground‐based instruments. Aerosol radiative forcing can delay or suppress the initiation and development of convective clouds whose microphysics can be further altered by the microphysical effect of aerosols. For the same cloud thickness, the likelihood of precipitation is influenced by aerosols: suppressing light rain and enhancing heavy rain, delaying but intensifying thunderstorms, and reducing the onset of isolated showers in most parts of China. Rainfall has become more inhomogeneous and more extreme in the heavily polluted urban regions.
