The potential of an environmentally friendly and emerging chalcogenide perovskite CaZrSe3for thermoelectric applications is examined. The orthorhombic phase of CaZrSe3has an optimum band gap (1.35–1.40 eV) for single‐junction photovoltaic applications. The predictions reveal that CaZrSe3possesses an absorption coefficient of ≈4 × 105cm−1at photon energies of 2.5 eV with an early onset of optical absorption (≈0.2 eV) well below the optimum band gap. Seebeck coefficient,
The thermoelectric material ZnSb utilizes elements that are inexpensive, abundant, and viable for mass production. While a high thermoelectric figure of merit
- NSF-PAR ID:
- 10453224
- Publisher / Repository:
- Wiley Blackwell (John Wiley & Sons)
- Date Published:
- Journal Name:
- Advanced Energy Materials
- Volume:
- 11
- Issue:
- 20
- ISSN:
- 1614-6832
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
more » « less
Abstract S , is inversely proportional to the carrier mobility as the calculated average effective mass for electrons is higher than for holes;p ‐type doping enhances the electrical conductivity, σ. The electronic thermal conductivityκe remains low at all temperatures. The upper limit of the thermoelectric figure of merit (ZTe ) attains ≈1.0 when doped at specific chemical potentials, while a high Seebeck coefficient contributes to the ZTe = 1.95 at 50 K forp ‐type doping with 1018cm−3carrier concentration, demonstrating high thermoelectric efficiency. -
more » « less
Abstract PbSe is an attractive thermoelectric material due to its favorable electronic structure, high melting point, and lower cost compared to PbTe. Herein, the hitherto unexplored alloys of PbSe with NaSbSe2(NaPb
m SbSem +2) are described and the most promising p‐type PbSe‐based thermoelectrics are found among them. Surprisingly, it is observed that below 500 K, NaPbm SbSem +2exhibits unorthodox semiconducting‐like electrical conductivity, despite possessing degenerate carrier densities of ≈1020cm−3. It is shown that the peculiar behavior derives from carrier scattering by the grain boundaries. It is further demonstrated that the high solubility of NaSbSe2in PbSe augments both the thermoelectric properties while maintaining a rock salt structure. Namely, density functional theory calculations and photoemission spectroscopy demonstrate that introduction of NaSbSe2lowers the energy separation between the L‐ and Σ‐valence bands and enhances the power factors under 700 K. The crystallographic disorder of Na+, Pb2+, and Sb3+moreover provides exceptionally strong point defect phonon scattering yielding low lattice thermal conductivities of 1–0.55 W m‐1K‐1between 400 and 873 K without nanostructures. As a consequence, NaPb10SbSe12achieves maximumZT ≈1.4 near 900 K when optimally doped. More importantly, NaPb10SbSe12maintains highZT across a broad temperature range, giving an estimated recordZT avgof ≈0.64 between 400 and 873 K, a significant improvement over existing p‐type PbSe thermoelectrics. -
Semiconductor engineering relies heavily on doping efficiency and dopability. Low doping efficiency may cause low mobility and failure to reach target carrier concentrations or even the desired carrier type. Semiconducting thermoelectric materials perform best with degenerate carrier concentrations, meaning high performance in new materials might not be realized experimentally without a route to optimal doping. Doping in the classic PbTe thermoelectric system has been largely successful but reported doping efficiencies can vary, raising concerns about reproducibility. Here, we stress the importance of phase equilibria considerations during synthesis to avoid undesired intrinsic defects leading to sub-optimal doping. By saturation annealing at 973 K, we decidedly fix the composition in single crystal iodine-doped PbTe samples to be Pb-rich or Te-rich without introducing impurity phases. We show that, regardless of iodine concentration, degenerate n-type carrier concentrations with ideal doping efficiency require Pb-rich compositions. Electrons in Te-rich samples are heavily compensated by charged intrinsic Pb vacancy defects. From Hall effect measurements and a simple defect model supported by modern defect calculations, we map out the 973 K ternary Pb–Te–I phase diagram to explicitly link carrier concentration and composition. Furthermore, we discuss unintentional composition changes due to loss of volatile Te during synthesis and measurements. The methods and concepts applied here may guide doping studies on other lead chalcogenide systems as well as any doped, complex semiconductor.more » « less
-
null (Ed.)The Zintl phases, Yb 14 M Sb 11 ( M = Mn, Mg, Al, Zn), are now some of the highest thermoelectric efficiency p-type materials with stability above 873 K. Yb 14 MnSb 11 gained prominence as the first p-type thermoelectric material to double the efficiency of SiGe alloy, the heritage material in radioisotope thermoelectric generators used to power NASA’s deep space exploration. This study investigates the solid solution of Yb 14 Mg 1− x Al x Sb 11 (0 ≤ x ≤ 1), which enables a full mapping of the metal-to-semiconductor transition. Using a combined theoretical and experimental approach, we show that a second, high valley degeneracy ( N v = 8) band is responsible for the groundbreaking performance of Yb 14 M Sb 11 . This multiband understanding of the properties provides insight into other thermoelectric systems (La 3− x Te 4 , SnTe, Ag 9 AlSe 6 , and Eu 9 CdSb 9 ), and the model predicts that an increase in carrier concentration can lead to zT > 1.5 in Yb 14 M Sb 11 systems.more » « less
-
more » « less
Abstract Sb‐doped and GeTe‐alloyed n‐type thermoelectric materials that show an excellent figure of merit
ZT in the intermediate temperature range (400–800 K) are reported. The synergistic effect of favorable changes to the band structure resulting in high Seebeck coefficient and enhanced phonon scattering by point defects and nanoscale precipitates resulting in reduction of thermal conductivity are demonstrated. The samples can be tuned as single‐phase solid solution (SS) or two‐phase system with nanoscale precipitates (Nano) based on the annealing processes. The GeTe alloying results in band structure modification by widening the bandgap and increasing the density‐of‐states effective mass of PbTe, resulting in significantly enhanced Seebeck coefficients. The nanoscale precipitates can improve the power factor in the low temperature range and further reduce the lattice thermal conductivity (κlat). Specifically, the Seebeck coefficient of Pb0.988Sb0.012Te–13%GeTe–Nano approaches −280 µV K−1at 673 K with a low κlatof 0.56 W m−1K−1at 573 K. Consequently, a peakZT value of 1.38 is achieved at 623 K. Moreover, a high averageZT avgvalue of ≈1.04 is obtained in the temperature range from 300 to 773 K for n‐type Pb0.988Sb0.012Te–13%GeTe–Nano.
