skip to main content

Attention:

The NSF Public Access Repository (PAR) system and access will be unavailable from 11:00 PM ET on Thursday, February 13 until 2:00 AM ET on Friday, February 14 due to maintenance. We apologize for the inconvenience.


Title: Subseafloor Temperature Variations Influenced by Variations in Bottom Water Temperature and Pressure: New High Resolution Observations and Implications
Abstract

A new instrument developed for monitoring acceleration, tilt, and pressure at the ocean floor also measures sediment temperature 1 m below the seafloor. Four deployments have been completed and connected to the Ocean Networks Canada cabled observatory, one on the inner Cascadia accretionary prism, two on the outer prism, and one on the sedimented eastern flank of the Juan de Fuca Ridge. Relative amplitudes and phases of temperature variations measured at the seafloor and in the sediment at periods greater than roughly 1 week constrain the thermal diffusivity of the upper meter of subseafloor sediment to be 4 × 10−7 m2/s. Clear ±0.1‐mK amplitude tidal sediment temperature variations are also resolved. These are too large and regular to be the consequence of downward thermal diffusion from the seafloor and too large to be the consequence of fluid migration driven along the sediment geotherm by poroelastic response to tidal loading. The variations are closely correlated with tidal pressure variations, however, and we infer that these temperature signals reflect adiabatic heating and cooling. The lapse rates inferred from the observations at two of the sites are close to the values for seawater but significantly higher than predicted for a mixture that includes sediment grains. The values observed by both instruments at the outer prism site, located near methane‐bearing‐fluid springs, are particularly high, 20% higher than predicted for a sediment‐seawater mixture. This discrepancy could be reconciled if free gas or methane hydrate were present within the pore volume.

 
more » « less
PAR ID:
10453930
Author(s) / Creator(s):
 ;  
Publisher / Repository:
DOI PREFIX: 10.1029
Date Published:
Journal Name:
Journal of Geophysical Research: Solid Earth
Volume:
124
Issue:
1
ISSN:
2169-9313
Page Range / eLocation ID:
p. 76-87
Format(s):
Medium: X
Sponsoring Org:
National Science Foundation
More Like this
  1. Abstract

    Ground shaking caused by earthquakes is accompanied by seafloor and sub‐seafloor formation fluid pressure variations in offshore areas, but there have been few collocated observations of these signals. In this work, we report seismic and high‐sampling‐rate fluid pressure records of the 2021 Mw 8.2 Alaska earthquake by the Ocean Networks Canada (ONC) NEPTUNE observatory at an epicentral distance of ∼2,200 km in the northeast Pacific Ocean. The system comprises observatory nodes in various tectonic environments, with each node including buried broadband seismometers, seafloor pressure sensors, and, at two nodes, borehole pressure sensors. Seismic and tsunami waveforms of the Mw 8.2 earthquake were documented in detail. Seismic seafloor pressure variations (Psf) were dominated by Rayleigh waves of periods between 5 and 50 s, with peak amplitudes of 3–4 kPa at most sites. Waveform similarity and the linear scaling betweenPsfand vertical ground acceleration indicate forced acceleration of the water column being dominant in governingPsfduring long‐period surface‐wave arrivals, with an additional component of elastic oscillation occurring at higher frequencies (>0.1 Hz) causing extra pressure signals. Analysis of formation pressure variations due to various types of ocean loading of distinctly different frequencies (e.g., tides, tsunami, and infragravity waves) shows stable one‐dimensional vertical loading efficiencies that depend on lithology at each borehole site, with loading response being strongly influenced by the presence of free gas at shallow depths within the Cascadia accretionary prism. Inter‐site comparisons of seismic and seafloor pressure waveforms demonstrate a key role of sediment thickness in the amplification of surface wave amplitudes.

     
    more » « less
  2. Shallow seabed depressions attributed to focused fluid seepage, known as pockmarks, have been documented in all continental margins. In this study, we demonstrate how pockmark formation can be the result of a combination of multiple factors—fluid type, overpressures, seafloor sediment type, stratigraphy and bottom currents. We integrate multibeam echosounder and seismic reflection data, sediment cores and pore water samples, with numerical models of groundwater and gas hydrates, from the Canterbury Margin (off New Zealand). More than 6800 surface pockmarks, reaching densities of 100 per km2, and an undefined number of buried pockmarks, are identified in the middle to outer shelf and lower continental slope. Fluid conduits across the shelf and slope include shallow to deep chimneys/pipes. Methane with a biogenic and/or thermogenic origin is the main fluid forming flow and escape features, although saline and freshened groundwaters may also be seeping across the slope. The main drivers of fluid flow and seepage are overpressure across the slope generated by sediment loading and thin sediment overburden above the overpressured interval in the outer shelf. Other processes (e.g. methane generation and flow, a reduction in hydrostatic pressure due to sea-level lowering) may also account for fluid flow and seepage features, particularly across the shelf. Pockmark occurrence coincides with muddy sediments at the seafloor, whereas their planform is elongated by bottom currents. 
    more » « less
  3. Abstract

    Low temperature hydrothermal systems hosted in the volcanic oceanic crust are responsible for ∼20% of Earth's global heat loss. Marine sediment ponds comprise an important type setting on young ridge flanks where hydrothermal circulation advectively extracts lithospheric heat, but the nature of coupled fluid‐heat transport in these settings remains poorly understood. Here we present coupled (fluid‐heat) numerical simulations of ocean crustal hydrogeology in and below North Pond, a sediment pond on ∼8 Ma seafloor of the North Atlantic Ocean. Two‐ and three‐dimensional simulations show that advective transport beneath North Pond is complex and time varying, with multiple spatial and temporal scales, consistent with seafloor and borehole observations. A unidirectional, single‐pass flow system is neither favored nor needed to match the spatial distribution of seafloor heat flux through North Pond sediments. When the permeability of the crustal aquifer is relatively high (10−10–10−9 m2), simulations can replicate much of the observed variability and suppression of seafloor heat flux and can explain basement overpressures and transient perturbations in pressure and temperature in the upper volcanic crust. Simulation results can also help explain heterogeneity in pore fluid chemistry and microbiology in the crust. Although driven by the same physical processes, the dynamics of hydrothermal circulation below North Pond are different from those seen on discharge‐dominated ridge flanks, where the permeability and exposed area of isolated basement outcrops control the extent of regional heat extraction.

     
    more » « less
  4. Abstract

    We use yearlong vertical temperature profile time‐series (seven thermistors at evenly spaced depth intervals from 10 to 70 cm) from five sites in and around the Deep Hole thermal area, southeast of Stevenson Island, Yellowstone Lake, to investigate heat and mass fluxes across the lake floor. The records demonstrate that thermal gradients in surficial sediments are modulated by a rich spectrum of bottom water temperature variations generated by hydrodynamic processes, and that sites inside the thermal area also respond to hydrothermal variations. We develop and implement a new method for estimating the sediment effective thermal diffusivity and pore fluid vertical flow rate that exploits the full spectrum of observed temperature variations to generate the parameter estimates, uncertainties, and metrics to assess statistical significance. Sediments at sites outside thermal areas have gradients of ∼7.5°C/m, in situ thermal diffusivities of ∼1.6 × 10−7 m2/s consistent with highly porous (80–90%) siliceous sediments, and experience hypolentic flow in the upper ∼20 cm. Sites inside the Deep Hole thermal area exhibit considerable spatial and temporal variability, with gradients of 1–32°C/m, and higher thermal diffusivities of ∼2–12 × 10−7 m2/s, consistent with hydrothermal alteration of biogenic silica to clays, quartz, and pyrite. Upward pore fluid flow at these sites is observed across multiple depth intervals, with maximum values of ∼3 cm/day. The observed spatial and temporal variability within the thermal area is consistent with upward finger flow combined with short wavelength convection within the porous sediments above a steam reservoir.

     
    more » « less
  5. Abstract

    Tectonic mélanges, characterized by conditions reflective of modern subduction fault zones, preserve mineral veins formed through mass transfer, a mechanism influencing the slip behavior of subduction megathrusts. In this study, we apply secondary ion mass spectrometry quartz‐calcite oxygen isotope thermometry and clumped isotope thermometry to examine the temperatures of vein formations in six mélange units in the Cretaceous Shimanto belt and one mélange in the Kodiak accretionary prism. Calcite in the veins exhibits δ13CPDBvalues ranging from −17.2‰ to −6.8‰, indicative of a carbon source mixing with sedimentary carbonate and organic matter. δ18OSMOWvalues of calcite range from +11.1‰ to +17.2‰; quartz yields δ18OSMOWvalues of +14.9‰ to +21.7‰. Oxygen isotopic signatures in minerals reveal that most vein‐forming fluids are significantly affected by rock buffering, while some retain isotopic compositions of seawater and meteoric water. Temperature estimates, derived from both thermometers, fall within the range of 100–250°C. Notably, vein temperatures remain constant across diverse vein types and mélange units with distinct maximum temperatures. The combined temperature records and fluid isotopic compositions imply vein formations at shallower depths linked to the incorporation of seawater, meteoric water, and fluid released from early dehydration reactions. At greater depths, vein formations are associated with fluid released from clay dehydration and long‐distance fluid flow. Reduced vein formations between 250 and 350°C may correlate with a shift to fluid‐unsaturated conditions resulting from clay hydration reactions. Our study highlights potential mechanical and hydraulic variations within the thermal conditions of 100–350°C along the plate boundary driven by fluid‐mineral interactions.

     
    more » « less