Single‐atom catalysts (SACs) have attracted much attentions due to the advantages of high catalysis efficiency and selectivity. However, the controllable and efficient synthesis of SACs remains a significant challenge. Herein, we report a controlled one‐pot synthesis of nickel single atoms embedded on nitrogen‐doped carbon nanotubes (NiSA−N−CNT) and nitrogen‐doped graphene (NiSA−N−G). The formation of NiSA−N−CNT is due to the solid‐to‐solid rolling up mechanism during the high temperature pyrolysis at 800 °C from the stacked and layered Ni‐doped g‐C3N4, g‐C3N4−Ni structure to a tubular CNT structure. Addition of citric acid introduces an amorphous carbon source on the layered g‐C3N4−Ni and after annealing at the same temperature of 800 °C, instead of formation of NiSA−N−CNT, Ni single atoms embedded in planar graphene type supports, NiSA−N−G were obtained. The density functional theory (DFT) calculation indicates the introduction of amorphous carbon source substantially reduces the structure fluctuation or curvature of layered g‐C3N4‐Ni intermediate products, thus interrupting the solid‐to‐solid rolling process and leading to the formation of planar graphene type supports for Ni single atoms. The as‐synthesized NiSA−N−G with Ni atomic loading of ∼6 wt% catalysts shows a better activity and stability for the CO2reduction reaction (CO2RR) than NiSA−N−CNT with Ni atomic loading of ∼15 wt% due to the open and exposed Ni single atom active sites in NiSA−N−G. This study demonstrates for the first time the feasibility in the control of the microstructure of carbon supports in the synthesis of SACs.
The development of low‐cost and efficient electrocatalysts for nitrogen reduction reaction (NRR) at ambient conditions is crucial for NH3synthesis and provides an alternative to the traditional Harber‐Bosch process. Herein, by means of density functional theory (DFT) computations, the catalytic performance of a series of single metal atoms supported on graphitic carbon nitride (g‐C3N4) for NRR is evaluated. Among all the candidates, the Gibbs free energy change of the potential‐determining step for five single‐atom catalysts (SACs), namely Ti, Co, Mo, W, and Pt atoms supported on g‐C3N4monolayer, is lower than that on the Ru(0001) stepped surface. In particular, the single tungsten (W) atom anchored on g‐C3N4(W@g‐C3N4) exhibits the highest catalytic activity toward NRR with a limiting potential of −0.35 V via associative enzymatic pathway, and can well suppress the competing hydrogen evolution reaction. The high NRR activity and selectivity of W@g‐C3N4are attributed to its inherent properties, such as significant positive charge and large spin moment on the W atom, excellent electrical conductivity, and moderate adsorption strength with NRR intermediates. This work opens up a new avenue of N2reduction for renewable energy supplies and helps guide future development of single‐atom catalysts for NRR and other related electrochemical process.
more » « less- Award ID(s):
- 1736093
- NSF-PAR ID:
- 10461238
- Publisher / Repository:
- Wiley Blackwell (John Wiley & Sons)
- Date Published:
- Journal Name:
- Small Methods
- Volume:
- 3
- Issue:
- 6
- ISSN:
- 2366-9608
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
more » « less
Abstract -
more » « less
Abstract Direct conversion of CO2into carbon‐neutral fuels or industrial chemicals holds a great promise for renewable energy storage and mitigation of greenhouse gas emission. However, experimentally finding an electrocatalyst for specific final products with high efficiency and high selectivity poses serious challenges due to multiple electron transfer, complicated intermediates, and numerous reaction pathways in electrocatalytic CO2reduction. Here, an intrinsic descriptor that correlates the catalytic activity with the topological, bonding, and electronic structures of catalytic centers on M–N–C based single‐atom catalysts is discovered. The “volcano”‐shaped relationships between the descriptor and catalytic activity are established from which the best single‐atom catalysts for CO2reduction are found. Moreover, the reaction mechanisms, intermediates, reaction pathways, and final products can also be distinguished by this new descriptor. The descriptor can also be used to predict the activity of the single‐atom catalysts for electrochemical reactions such as hydrogen evolution, oxygen reduction and evolution reactions in fuel cells and water‐splitting. These predictions are confirmed by the experimental results for onset potential and Faraday efficiency. The design principles derived from the descriptors open a door for rational design and rapid screening of highly efficient electrocatalysts for CO2conversion as well as other electrochemical energy systems.
-
more » « less
Abstract Carbon‐supported nitrogen‐coordinated single‐metal site catalysts (i.e., M−N−C, M: Fe, Co, or Ni) are active for the electrochemical CO2reduction reaction (CO2RR) to CO. Further improving their intrinsic activity and selectivity by tuning their N−M bond structures and coordination is limited. Herein, we expand the coordination environments of M−N−C catalysts by designing dual‐metal active sites. The Ni‐Fe catalyst exhibited the most efficient CO2RR activity and promising stability compared to other combinations. Advanced structural characterization and theoretical prediction suggest that the most active N‐coordinated dual‐metal site configurations are 2N‐bridged (Fe‐Ni)N6, in which FeN4and NiN4moieties are shared with two N atoms. Two metals (i.e., Fe and Ni) in the dual‐metal site likely generate a synergy to enable more optimal *COOH adsorption and *CO desorption than single‐metal sites (FeN4or NiN4) with improved intrinsic catalytic activity and selectivity.
-
more » « less
Abstract Carbon‐supported nitrogen‐coordinated single‐metal site catalysts (i.e., M−N−C, M: Fe, Co, or Ni) are active for the electrochemical CO2reduction reaction (CO2RR) to CO. Further improving their intrinsic activity and selectivity by tuning their N−M bond structures and coordination is limited. Herein, we expand the coordination environments of M−N−C catalysts by designing dual‐metal active sites. The Ni‐Fe catalyst exhibited the most efficient CO2RR activity and promising stability compared to other combinations. Advanced structural characterization and theoretical prediction suggest that the most active N‐coordinated dual‐metal site configurations are 2N‐bridged (Fe‐Ni)N6, in which FeN4and NiN4moieties are shared with two N atoms. Two metals (i.e., Fe and Ni) in the dual‐metal site likely generate a synergy to enable more optimal *COOH adsorption and *CO desorption than single‐metal sites (FeN4or NiN4) with improved intrinsic catalytic activity and selectivity.
-
more » « less
Abstract The effect of rare earth (RE) single atoms on photocatalytic activity is very complex due to its special electronic configuration, which leads to few reports on the RE single atoms. Here, Dy3+single atom composite photocatalysts are successfully constructed based on both the special role of Dy3+and the special advantages of CdS/g‐C3N4heterojunction in the field of photocatalysis. The results show that an efficient way of electron transfer is provided to promote charge separation, and the dual functions of CO2molecular activation of rare‐earth single atom and 4
f levels as electron transport bridge are fully exploited. It is exciting that under visible‐light irradiation, the catalytic performance of CdS:Dy3+/g‐C3N4is≈ 6.9 times higher than that of pure g‐C3N4. The catalytic performance of CdS:Dy3+and CdS:Dy3+/g‐C3N4are≈ 7 and≈ 13.7 times higher than those of pure CdS, respectively. Besides, not all RE ions are suitable for charge transfer bridges, which is not only related to the 4f levels of RE ions but also related to the bandgap structure of CdS and g‐C3N4. The pattern of combining single‐atom catalysis and heterojunction opens up new methods for enhancing photocatalytic activity.
