2-Methyltetrols and a group of C5H10O3 isomers referred to as “alkene triols,” are chemical tracers used to estimate the contribution of isoprene oxidation to atmospheric PM2.5. The molecular structures and the mass contribution of alkene triols are uncertain, and their origin as analytical artifacts is contentious. Here, we report that the alkene triols are uptake products and present evidence of partitioning into the gas phase. Based on the hypothesis that rearrangement of IEPOX yields C5H10O3 isomers on reactive uptake, we synthesized “alkene triol” candidates and investigated their behavior under conventional derivatization gas chromatography/electron impact mass spectrometry (GC/EI-MS) and, in parallel, by non-destructive hydrophilic interaction liquid chromatography coupled with high-resolution quadrupole time-of-flight electrospray mass spectrometry (HILIC/ESI-HR-QTOFMS). Synthetic targets were 3-methyltetrahydrofuran-2,4-diol (1) and 3-methylene-1,2,4-trihydroxybutane (2). Using the standards, we confirmed 1 and 2 in chamber-generated cis- and trans-β-IEPOX SOA both by HILIC/ESI-HR-QTOFMS and derivatization GC/EI-MS. In ambient SOA collected in Research Triangle Park, NC, 1 and 2 were confirmed and quantitatively estimated by GC-EI/MS. Trimethylsilyl derivatization of 1 is problematic, yielding predominantly bis- but also a small amount (<10%) of tris-trimethylsilyl forms. Our findings are consistent with reports that the tris-trimethylsilyl derivatives 1 and 2 represent largely thermal decomposition of 2-methyltetrol sulfate esters; however, based on HILIC/ESI-HR-QTOFMS analysis of chamber-generated SOA, we estimate up to 10% and 50% of 1 and 2, respectively are not artifact-derived, and may arise from isomerization of IEPOX upon reactive uptake. Significant quantities of 1 and 2 were detected in impinger samples downstream from a denuder in series with a filter indicating partitioning into the gas phase. Results suggest that isoprene-derived “alkene triols” do form and are preferentially in the gas phase rather than particle phase, warranting studies on partitioning and gas-phase oxidation pathways.
more »
« less
This content will become publicly available on July 17, 2024
Technical note: Improved synthetic routes to cis - and trans -(2-methyloxirane-2,3-diyl)dimethanol ( cis - and trans - β -isoprene epoxydiol)
Abstract. We report improved synthetic routes to the isomericisoprene-derived β-epoxydiols (β-IEPOX) in high yield(57 %–69 %) from inexpensive, readily available starting compounds. Thesyntheses do not require the protection/deprotection steps or time-consumingpurification of intermediates and can readily be scaled up to yield thetarget IEPOX isomers in gram quantities. Emissions of isoprene(2-methyl-1,3-butadiene, C5H8), primarily from deciduousvegetation, constitute the largest source of nonmethane atmospherichydrocarbons. In the gas phase under low-nitric-oxide (NO) conditions,addition of the atmospheric hydroxyl radical (OH) followed by rapid addition ofO2 yields isoprene-derived hydroxyperoxyl radicals. The major sink(>90 %) for the peroxyl radicals is a sequential reaction withthe hydroperoxyl radical (HO2), OH, and O2, which is then followed bythe elimination of OH to yield a ∼2:1 mixture ofcis- and trans-(2-methyloxirane-2,3-diyl)dimethanol (cis- and trans-β-IEPOX). The IEPOXisomers account for about 80 % of closed-shell hydroxyperoxylproducts and are rapidly taken up into acidic aerosols to form secondaryorganic aerosol (SOA). IEPOX-derived SOA makes a significant masscontribution to fine particulate matter (PM2.5), which is known to be amajor factor in climate forcing as well as adversely affecting respiratory andcardiovascular systems of exposed populations. Prediction of ambientPM2.5 composition and distribution, both in regional- and global-scaleatmospheric chemistry models, crucially depends on the accuracy ofidentification and quantitation of uptake product formation. Accessibilityof authentic cis- and trans-β-IEPOX in high purity and in large quantity forlaboratory studies underpins progress in developing models as well asidentification and quantitation of PM2.5 components.
more » « less- Award ID(s):
- 2001027
- NSF-PAR ID:
- 10486753
- Publisher / Repository:
- EGU
- Date Published:
- Journal Name:
- Atmospheric Chemistry and Physics
- Volume:
- 23
- Issue:
- 14
- ISSN:
- 1680-7324
- Page Range / eLocation ID:
- 7859 to 7866
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract. Atmospheric oxidation of isoprene, the most abundantly emitted non-methane hydrocarbon, affects the abundances of ozone (O3), the hydroxyl radical (OH), nitrogen oxide radicals (NOx), carbon monoxide (CO), oxygenated and nitrated organic compounds, and secondary organic aerosol (SOA). We analyze these effects in box models and in the global GEOS-Chem chemical transport model using the new reduced Caltech isoprene mechanism (RCIM) condensed from a recently developed explicit isoprene oxidation mechanism. We find many similarities with previous global models of isoprene chemistry along with a number of important differences. Proper accounting of the isomer distribution of peroxy radicals following the addition of OH and O2 to isoprene influences the subsequent distribution of products, decreasing in particular the yield of methacrolein and increasing the capacity of intramolecular hydrogen shifts to promptly regenerate OH. Hydrogen shift reactions throughout the mechanism lead to increased OH recycling, resulting in less depletion of OH under low-NO conditions than in previous mechanisms. Higher organonitrate yields and faster tertiary nitrate hydrolysis lead to more efficient NOx removal by isoprene and conversion to inorganic nitrate. Only 20 % of isoprene-derived organonitrates (excluding peroxyacyl nitrates) are chemically recycled to NOx. The global yield of formaldehyde from isoprene is 22 % per carbon and less sensitive to NO than in previous mechanisms. The global molar yield of glyoxal is 2 %, much lower than in previous mechanisms because of deposition and aerosol uptake of glyoxal precursors. Global production of isoprene SOA is about one-third from each of the following: isoprene epoxydiols (IEPOX), organonitrates, and tetrafunctional compounds. We find a SOA yield from isoprene of 13 % per carbon, much higher than commonly assumed in models and likely offset by SOA chemical loss. We use the results of our simulations to further condense RCIM into a mini Caltech isoprene mechanism (Mini-CIM) for less expensive implementation in atmospheric models, with a total size (108 species, 345 reactions) comparable to currently used mechanisms.more » « less
-
Blum, Joel (Ed.)Atmospheric oxidation of isoprene yields large quantities of highly water-soluble isoprene epoxydiols (IEPOX) that partition into fogs, clouds, and wet aerosols. In aqueous aerosols, the acid-catalyzed ring-opening of IEPOX followed by nucleophilic addition of inorganic sulfate or water forms organosulfates and 2-methyltetrols, respectively, contributing substantially to secondary organic aerosol (SOA). However, the fate of IEPOX in clouds, fogs, and evaporating hydrometeors is not well understood. Here we investigate the rates, product branching ratios, and stereochemistry of organosulfates from reactions of dilute IEPOX (5–10 mM) under a range of sulfate concentrations (0.3–50 mM) and pH values (1.83–3.38) in order to better understand the fate of IEPOX in clouds and fogs. From these aqueous dark reactions of β-IEPOX isomers (trans- and cis-2-methyl-2,3-epoxybutane-1,4-diols), which are the predominant IEPOX isomers, products were identified and quantified using hydrophilic interaction liquid chromatography coupled to an electrospray ionization high-resolution quadrupole time-of-flight mass spectrometer operated in negative ion mode (HILIC/(−)ESI-HR-QTOFMS). We found that the regiochemistry and stereochemistry were affected by pH, and the tertiary methyltetrol sulfate (C5H12O7S) was promoted by increasing solution acidity. Furthermore, the rate constants for the reaction of IEPOX under cloud-relevant conditions are up to 1 order of magnitude lower than reported in the literature for aerosol-relevant conditions due to a markedly different solution activities. Nevertheless, the contribution of cloud and fog water reactions to IEPOX SOA may be significant in cases of lower aqueous-phase pH (model estimate) or during droplet evaporation (not studied).more » « less
-
The reaction of the D1-silylidyne radical (SiD; X 2 Π) with phosphine (PH 3 ; X 1 A 1 ) was conducted in a crossed molecular beams machine under single collision conditions. Merging of the experimental results with ab initio electronic structure and statistical Rice–Ramsperger–Kassel–Marcus (RRKM) calculations indicates that the reaction is initiated by the barrierless formation of a van der Waals complex (i0) as well as intermediate (i1) formed via the barrierless addition of the SiD radical with its silicon atom to the non-bonding electron pair of phosphorus of the phosphine. Hydrogen shifts from the phosphorous atom to the adjacent silicon atom yield intermediates i2a, i2b, i3; unimolecular decomposition of these intermediates leads eventually to the formation of trans / cis -phosphinidenesilyl (HSiPH, p2/p4) and phosphinosilylidyne (SiPH 2 , p3) via hydrogen deuteride (HD) loss (experiment: 80 ± 11%, RRKM: 68.7%) and d - trans / cis -phosphinidenesilyl (DSiPH, p2′/p4′) plus molecular hydrogen (H 2 ) (experiment: 20 ± 7%, RRKM: 31.3%) through indirect scattering dynamics via tight exit transition states. Overall, the study reveals branching ratios of p2/p4/p2′/p4′ ( trans / cis HSiPH/DSiPH) to p3 (SiPH 2 ) of close to 4 : 1. The present study sheds light on the complex reaction dynamics of the silicon and phosphorous systems involving multiple atomic hydrogen migrations and tight exit transition states, thus opening up a versatile path to access the previously elusive phosphinidenesilyl and phosphinosilylidyne doublet radicals, which represent potential targets of future astronomical searches toward cold molecular clouds (TMC-1), star forming regions (Sgr(B2)), and circumstellar envelopes of carbon rich stars (IRC + 10216).more » « less
-
Acid-driven multiphase chemistry of isoprene epoxydiols (IEPOX) with inorganic sulfate aerosols contributes substantially to formation of secondary organic aerosol (SOA), which constitutes a large mass fraction of atmospheric fine particulate matter (PM2.5). However, atmospheric chemical sinks of freshly generated IEPOX-SOA particles remain unclear. We examined the role of heterogeneous oxidation of freshly-generated IEPOX-SOA particles by gas-phase hydroxyl radical (•OH) under dark conditions as one potential atmospheric sink. After 4 h of gas-phase •OH exposure (~3x108 molecules cm-3), chemical changes in smog chamber-generated IEPOX-SOA particles were assessed by hydrophilic interaction liquid chromatography coupled with electrospray ionization high-resolution quadrupole time-of-flight mass spectrometry (HILIC/ESI-HR-QTOFMS). Comparison of molecular-level compositional changes in IEPOX-SOA particles during aging with or without •OH revealed that decomposition of oligomers by heterogeneous •OH oxidation acts as a sink for •OH and maintains a reservoir of low-volatility compounds including monomeric sulfate esters and oligomer fragments. We propose tentative structures and formation mechanisms for previously uncharacterized SOA constituents in PM2.5. Our results suggest that this •OH-driven renewal of low-volatility products may extend atmospheric lifetimes of IEPOX-SOA particles by slowing production of low-molecular weight, high-volatility organic fragments, and likely contributes to large quantities of 2-methyltetrols and methyltetrol sulfates reported in PM2.5.more » « less
