An official website of the United States government
Abstract Alkali and alkaline earth metal adducts of a branched glycan, XXXG, were analyzed with helium charge transfer dissociation (He‐CTD) and low‐energy collision‐induced dissociation (LE‐CID) to investigate if metalation would impact the type of fragments generated and the structural characterization of the analyte. The studied adducts included 1+ and 2+ precursors involving one or more of the cations: H+, Na+, K+, Ca2+, and Mg2+. Regardless of the metal adduct, He‐CTD generated abundant and numerous glycosidic and cross‐ring cleavages that were structurally informative and able to identify the 1,4‐linkage and 1,6‐branching patterns. In contrast, the LE‐CID spectra mainly contained glycosidic cleavages, consecutive fragments, and numerous neutral losses, which complicated spectral interpretation. LE‐CID of [M + K + H]2+and [M + Na]+precursors generated a few cross‐ring cleavages, but they were not sufficient to identify the 1,4‐linkage and 1,6‐branching pattern of the XXXG xyloglucan. He‐CTD predominantly generated 1+ fragments from 1+ precursors and 2+ product ions from 2+ precursors, although both LE‐CID and He‐CTD were able to generate 1+ product ions from 2+ adducts of magnesium and calcium. The singly charged fragments derive from the loss of H+from the metalated product ions and the formation of a protonated complementary product ion; such observations are similar to previous reports for magnesium and calcium salts undergoing electron capture dissociation (ECD) activation. However, during He‐CTD, the [M + Mg]2+precursor generated more singly charged product ions than [M + Ca]2+, either because Mg has a higher second ionization potential than Ca or because of conformational differences and the locations of the charging adducts during fragmentation. He‐CTD of the [M + 2Na]2+and the [M + 2 K]2+precursors generated singly charged product ions from the loss of a sodium ion and potassium ion, respectively. In summary, although the metal ions influence the mass and charge state of the observed product ions, the metal ions had a negligible effect on the types of cross‐ring cleavages observed.
more »
« less
Structural characterization of fatty acid anions via gas‐phase charge inversion using Mg(tri‐butyl‐terpyridine) 2 2+ reagent ions
RationaleFree fatty acids and lipid classes containing fatty acid esters are major components of lipidome. In the absence of a chemical derivatization step, FA anions do not yield all of the structural information that may be of interest under commonly used collision‐induced dissociation (CID) conditions. A line of work that avoids condensed‐phase derivatization takes advantage of gas‐phase ion/ion chemistry to charge invert FA anions to an ion type that provides the structural information of interest using conventional CID. This work was motivated by the potential for significant improvement in overall efficiency for obtaining FA chain structural information. MethodsA hybrid triple quadrupole/linear ion‐trap tandem mass spectrometer that has been modified to enable the execution of ion/ion reaction experiments was used to evaluate the use of 4,4′,4″‐tri‐tert‐butyl‐2,2′:6′,2″‐terpyridine (ttb‐Terpy) as the ligand in divalent magnesium complexes for charge inversion of FA anions. ResultsMg(ttb‐Terpy)22+complexes provide significantly improved efficiency in producing structurally informative products from FA ions relative to Mg(Terpy)22+complexes, as demonstrated for straight‐chain FAs, branched‐chain FAs, unsaturated FAs, and cyclopropane‐containing FAs. It was discovered that most of the structurally informative fragmentation from [FA‐H + Mg(ttb‐Terpy)]+results from the loss of a methyl radical from the ligand followed by radical‐directed dissociation (RDD), which stands in contrast to the charge‐remote fragmentation (CRF) believed to be operative with the [FA‐H + Mg(Terpy)]+ions. ConclusionsThis work demonstrates that a large fraction of product ions from the CID of ions of the form [FA‐H + Mg(ttb‐Terpy)]+are derived from RDD of the FA backbone, with a very minor fraction arising from structurally uninformative dissociation channels. This ligand provides an alternative to previously used ligands for the structural characterization of FAs via CRF.
more »
« less
- Award ID(s):
- 2304386
- PAR ID:
- 10498807
- Publisher / Repository:
- Wiley Blackwell (John Wiley & Sons)
- Date Published:
- Journal Name:
- Rapid Communications in Mass Spectrometry
- Volume:
- 38
- Issue:
- 11
- ISSN:
- 0951-4198
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
RationaleCoordinatively driven self‐assembly of transition metal ions and bidentate ligands gives rise to organometallic complexes that usually contain superimposed isobars, isomers, and conformers. In this study, the double dispersion ability of ion mobility mass spectrometry (IM‐MS) was used to provide a comprehensive structural characterization of the self‐assembled supramolecular complexes by their mass and charge, revealed by the MS event, and their shape and collision cross‐section (Ω), revealed by the IM event. MethodsSelf‐assembled complexes were synthesized by reacting a bis(terpyridine) ligand exhibiting a 60odihedral angle between the two ligating terpyridine sites (T) with divalent Zn, Ni, Cd, or Fe. The products were isolated as (Metal2+[T])n(PF6)2nsalts and analyzed using IM‐MS after electrospray ionization (ESI) which produced several charge states from eachn‐mer, depending on the number of PF6ˉ anions lost upon ESI. Experimental Ω data, derived using IM‐MS, and computational Ω predictions were used to elucidate the size and architecture of the complexes. ResultsOnly macrocyclic dimers, trimers, and tetramers were observed with Cd2+, whereas Zn2+formed the same plus hexameric complexes. These two metals led to the simplest product distributions and no linear isomers. In sharp contrast, Ni2+and Fe2+formed all possible ring sizes from dimer to hexamer as well as various linear isomers. The experimental and theoretical Ω data indicated rather planar macrocyclic geometries for the dimers and trimers, twisted 3D architectures for the larger rings, and substantially larger sizes with spiral conformation for the linear congeners. Adding PF6ˉ to the same complex was found to mainly cause size contraction due to new stabilizing anion–cation interactions. ConclusionsComplete structural identification could be accomplished using ESI‐IM‐MS. Our results affirm that self‐assembly with Cd2+and Zn2+proceeds through reversible equilibria that generate the thermodynamically most stable structures, encompassing exclusively macrocyclic architectures that readily accommodate the 60oligand used. In contrast, complexation with Ni2+and Fe2+, which form stronger coordinative bonds, proceeds through kinetic control, leading to more complex mixtures and kinetically trapped less stable architectures, such as macrocyclic pentamers and linear isomers.more » « less
-
The inherent structural complexity and diversity of glycans pose a major analytical challenge to their structural analysis. Radical chemistry has gained considerable momentum in the field of mass spectrometric biomolecule analysis, including proteomics, glycomics, and lipidomics. Herein, seven isomeric disaccharides and two isomeric tetrasaccharides with subtle structural differences are distinguished rapidly and accurately via one-step radical-induced dissociation. The free-radical-activated glycan-sequencing reagent (FRAGS) selectively conjugates to the unique reducing terminus of glycans in which a localized nascent free radical is generated upon collisional activation and simultaneously induces glycan fragmentation. Higher-energy collisional dissociation (HCD) and collision-induced dissociation (CID) are employed to provide complementary structural information for the identification and discrimination of glycan isomers by providing different fragmentation pathways to generate informative, structurally significant product ions. Furthermore, multiple-stage tandem mass spectrometry (MS3 CID) provides supplementary and valuable structural information through the generation of characteristic parent-structure-dependent fragment ions.more » « less
-
RationaleTandem‐ion mobility spectrometry/mass spectrometry methods have recently gained traction for the structural characterization of proteins and protein complexes. However, ion activation techniques currently coupled with tandem‐ion mobility spectrometry/mass spectrometry methods are limited in their ability to characterize structures of proteins and protein complexes. MethodsHere, we describe the coupling of the separation capabilities of tandem‐trapped ion mobility spectrometry/mass spectrometry (tTIMS/MS) with the dissociation capabilities of ultraviolet photodissociation (UVPD) for protein structure analysis. ResultsWe establish the feasibility of dissociating intact proteins by UV irradiation at 213 nm between the two TIMS devices in tTIMS/MS and at pressure conditions compatible with ion mobility spectrometry (2–3 mbar). We validate that the fragments produced by UVPD under these conditions result from a radical‐based mechanism in accordance with prior literature on UVPD. The data suggest stabilization of fragment ions produced from UVPD by collisional cooling due to the elevated pressures used here (“UVnoD2”), which otherwise do not survive to detection. The data account for a sequence coverage for the protein ubiquitin comparable to recent reports, demonstrating the analytical utility of our instrument in mobility‐separating fragment ions produced from UVPD. ConclusionsThe data demonstrate that UVPD carried out at elevated pressures of 2–3 mbar yields extensive fragment ions rich in information about the protein and that their exhaustive analysis requires IMS separation post‐UVPD. Therefore, because UVPD and tTIMS/MS each have been shown to be valuable techniques on their own merit in proteomics, our contribution here underscores the potential of combining tTIMS/MS with UVPD for structural proteomics.more » « less
-
null (Ed.)A guided-ion beam tandem mass spectrometric study was performed on collision-induced dissociation (CID) of a protonated 9-methylguanine–1-methylcytosine Watson–Crick base pair (designated as WC-[9MG·1MC + H] + ), from which dissociation pathways and dissociation energies were determined. Electronic structure calculations at the DFT, RI-MP2 and DLPNO-CCSD(T) levels of theory were used to identify product structures and delineate reaction mechanisms. Intra-base-pair proton transfer (PT) of WC-[9MG·1MC + H] + results in conventional base-pair conformations that consist of hydrogen-bonded [9MG + H] + and 1MC and proton-transferred conformations that are formed by PT from the N1 of [9MG + H] + to the N3′ of 1MC. Two types of conformers were distinguished by CID in which the conventional conformers produced [9MG + H] + product ions whereas the proton-transferred conformers produced [1MC + H] + . The conventional conformers have a higher population (99.8%) and lower dissociation energy than the proton-transferred counterparts. However, in contrast to what was expected from the statistical dissociation of the equilibrium base-pair conformational ensemble, the CID product ions of WC-[9MG·1MC + H] + were dominated by [1MC + H] + rather than [9MG + H] + . This finding, alongside the non-statistical CID reported for deprotonated guanine–cytosine (Lu et al. ; PCCP , 2016, 18 , 32222) and guanine–cytosine radical cation (Sun et al. ; PCCP , 2020, 22 , 14875), reinforces that non-statistical dissociation is a distinctive feature of singly-charged Watson–Crick guanine–cytosine base pairs. It implies that intra-base-pair PT facilitates the formation of proton-transferred conformers in these systems and the ensuing conformers have loose transition states for dissociation. The monohydrate of WC-[9MG·1MC + H] + preserves non-statistical CID kinetics and introduces collision-induced methanol elimination via the reaction of the water ligand with a methyl group.more » « less
