An official website of the United States government
Abstract Observations of high ferric iron content in diamond garnet inclusions and mantle plume melts suggest a highly heterogeneous distribution of ferric iron in the mantle. Recycling of oxidized materials such as carbonates from Earth’s surface by subduction could explain the observed variations. Here we present high-pressure high-temperature multi-anvil experiments to determine the redox reactions between calcium-, magnesium-, or iron-carbonate and ferrous iron-bearing silicate mineral (garnet or fayalite) at conditions representative of subduction zones with intermediate thermal structures. We show that both garnet and fayalite can be oxidized to ferric iron-rich garnets accompanied by reduction of calcium carbonate to form graphite. The ferric iron content in the synthetic garnets increases with increasing pressure, and is correlated with the Ca content in the garnets. We suggest that recycled sedimentary calcium carbonate could influence the evolution of the mantle oxidation state by efficiently increasing the ferric iron content in the deep upper mantle.
more »
« less
Thermodynamics of mantle minerals – III: the role of iron
SUMMARY We expand the scope of HeFESTo by encompassing the rich physics of iron in the mantle, including the existence of multiple valence and spin states. In our previous papers, we considered iron only in its most common state in the mantle: the high-spin divalent (ferrous) cation. We now add ferric iron end-members to six phases, as well as the three phases of native iron. We also add low-spin states of ferrous and ferric iron and capture the behaviour of the high-spin to low-spin transition. Consideration of the multi-state nature of iron, unique among the major elements, leads to developments of our theory, including generalization of the chemical potential to account for the possibility of multiple distinguishable states of iron co-existing on a single crystallographic site, the effect of the high-spin to low-spin transition on seismic wave velocities in multiphase systems, and computation of oxygen fugacity. Consideration of ferric iron also motivates the addition of the chromia component to several phases, so that we now consider the set of components: Ca, Na, Fe, Mg, Al, Si, O and Cr (CNFMASO+Cr). We present the results of a new global inversion of mineral properties and compare our results to experimental observations over the entire pressure–temperature range of the mantle and over a wide range of oxygen fugacity. Applications of our method illustrate how it might be used to better understand the seismic structure, dynamics and oxygen fugacity of the mantle.
more »
« less
- Award ID(s):
- 2223935
- PAR ID:
- 10504345
- Publisher / Repository:
- Oxford University Press
- Date Published:
- Journal Name:
- Geophysical Journal International
- Volume:
- 237
- Issue:
- 3
- ISSN:
- 0956-540X
- Format(s):
- Medium: X Size: p. 1699-1733
- Size(s):
- p. 1699-1733
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract Fe‐Al‐bearing bridgmanite may be the dominant host for ferric iron in Earth's lower mantle. Here we report the synthesis of (Mg0.5Fe3+0.5)(Al0.5Si0.5)O3bridgmanite (FA50) with the highest Fe3+‐Al3+coupled substitution known to date. X‐ray diffraction measurements showed that at ambient conditions, the FA50 adopted the LiNbO3structure. Upon compression at room temperature to 18 GPa, it transformed back into the bridgmanite structure, which remained stable up to 102 GPa and 2,600 K. Fitting Birch‐Murnaghan equation of state of FA50 bridgmanite yieldsV0 = 172.1(4) Å3,K0 = 229(4) GPa withK0′ = 4(fixed). The calculated bulk sound velocity of the FA50 bridgmanite is ~7.7% lower than MgSiO3bridgmanite, mainly because the presence of ferric iron increases the unit‐cell mass by 15.5%. This difference likely represents the upper limit of sound velocity anomaly introduced by Fe3+‐Al3+substitution. X‐ray emission and synchrotron Mössbauer spectroscopy measurements showed that after laser annealing, ~6% of Fe3+cations exchanged with Al3+and underwent the high‐ to low‐spin transition at 59 GPa. The low‐spin proportion of Fe3+increased gradually with pressure and reached 17–31% at 80 GPa. Since the cation exchange and spin transition in this Fe3+‐Al3+‐enriched bridgmanite do not cause resolvable unit‐cell volume reduction, and the increase of low‐spin Fe3+fraction with pressure occurs gradually, the spin transition would not produce a distinct seismic signature in the lower mantle. However, it may influence iron partitioning and isotopic fractionation, thus introducing chemical heterogeneity in the lower mantle.more » « less
-
Abstract The two most abundant minerals in the Earth’s lower mantle are bridgmanite and ferropericlase. The bulk modulus of ferropericlase (Fp) softens as iron d-electrons transition from a high-spin to low-spin state, affecting the seismic compressional velocity but not the shear velocity. Here, we identify a seismological expression of the iron spin crossover in fast regions associated with cold Fp-rich subducted oceanic lithosphere: the relative abundance of fast velocities in P- and S-wave tomography models diverges in the ~1,400-2,000 km depth range. This is consistent with a reduced temperature sensitivity of P-waves throughout the iron spin crossover. A similar signal is also found in seismically slow regions below ~1,800 km, consistent with broadening and deepening of the crossover at higher temperatures. The corresponding inflection in P-wave velocity is not yet observed in 1-D seismic profiles, suggesting that the lower mantle is composed of non-uniformly distributed thermochemical heterogeneities which dampen the global signature of the Fp spin crossover.more » « less
-
null (Ed.)Abstract Electronic states of iron in the lower mantle's dominant mineral, (Mg,Fe,Al)(Fe,Al,Si)O3 bridgmanite, control physical properties of the mantle including density, elasticity, and electrical and thermal conductivity. However, the determination of electronic states of iron has been controversial, in part due to different interpretations of Mössbauer spectroscopy results used to identify spin state, valence state, and site occupancy of iron. We applied energy-domain Mössbauer spectroscopy to a set of four bridgmanite samples spanning a wide range of compositions: 10–50% Fe/total cations, 0–25% Al/total cations, 12–100% Fe3+/total Fe. Measurements performed in the diamond-anvil cell at pressures up to 76 GPa below and above the high to low spin transition in Fe3+ provide a Mössbauer reference library for bridgmanite and demonstrate the effects of pressure and composition on electronic states of iron. Results indicate that although the spin transition in Fe3+ in the bridgmanite B-site occurs as predicted, it does not strongly affect the observed quadrupole splitting of 1.4 mm/s, and only decreases center shift for this site to 0 mm/s at ~70 GPa. Thus center shift can easily distinguish Fe3+ from Fe2+ at high pressure, which exhibits two distinct Mössbauer sites with center shift ~1 mm/s and quadrupole splitting 2.4–3.1 and 3.9 mm/s at ~70 GPa. Correct quantification of Fe3+/total Fe in bridgmanite is required to constrain the effects of composition and redox states in experimental measurements of seismic properties of bridgmanite. In Fe-rich, mixed-valence bridgmanite at deep-mantle-relevant pressures, up to ~20% of the Fe may be a Fe2.5+ charge transfer component, which should enhance electrical and thermal conductivity in Fe-rich heterogeneities at the base of Earth's mantle.more » « less
-
The large range in oxidation states of sulfur (-II to +VI) provides it with a large oxidation potential in rocks, even at relatively low concentrations. Most importantly, the transition from sulfide to sulfate species in rocks and silicate melts occurs in the same approximate fO2 region (for a given temperature) as the transition from ferrous to ferric iron, and reduced S species can coexist with oxidized Fe and vice versa. The result is a large potential for reactions involving sulfur to oxidize or reduce Fe in silicate minerals, since Fe only occurs in two oxidation states (+II and +III). In order for sulfur to be released during slab dehydration, sulfur in sulfide must be converted into an easily dissolved species, such as SO42− or H2S, through either oxidation or reduction. We propose that oxidation of sulfur in sulfide follows the generalized reaction: 8Fe3+SiaOb(OH)c +S2− = 8Fe2+SidOe +SO42− +(H2O)f (1) In this type of reaction, sulfur participates in the dehydration of greenschist- or blueschist-facies hydrous silicates during transition to the eclogite facies: ferric Fe in Fe-bearing silicates (chlorite, amphibole, epidote) is reduced to ferrous Fe in anhydrous ferromagnesian silicates (pyroxene, garnet). At the same time, the reaction consumes sulfide by oxidation of S2− to produce SO42−, which is readily dissolved in the fluid produced during dehydration. Additionally, a similar redox reaction could oxidize sulfur by reducing ferric Fe in oxides. It is important to note that one mole of S has the same redox potential as 8 moles of Fe. The molar ratio of 8 moles of Fe per 1 mole of S translates to a mass ratio of approximately 14; therefore, small concentrations of sulfur can have a large impact on reduction/oxidation of the silicate assemblage. Our observations show that sulfide minerals that can be identified as primary or related to the peak metamorphic stage are rare in eclogites and restricted to inclusions in garnet, consistent with reaction (1). Thermodynamic modeling is currently underway to assess the influence of sulfur on the phase equilibria of silicate phases during high pressure metamorphism.more » « less
