An official website of the United States government
Hemoglobin is a biomarker of interest for the diagnosis and prognosis of various diseases such as anemia, sickle cell disease, and thalassemia. In this paper, we present a disposable device that has the potential of being used in a setting for accurately quantifying hemoglobin levels in whole blood based on colorimetric analysis using a smartphone camera. Our biosensor employs a disposable microfluidic chip which is made using medical-grade tapes and filter paper on a glass slide in conjunction with a custom-made PolyDimethylSiloaxane (PDMS) micropump for enhancing capillary flow. Once the blood flows through the device, the glass slide is imaged using a smartphone equipped with a custom 3D printed attachment. The attachment has a Light Emitting Diode (LED) that functions as an independent light source to reduce the noise caused by background illumination and external light sources. We then use the RGB values obtained from the image to quantify the hemoglobin levels. We demonstrated the capability of our device for quantifying hemoglobin in Bovine Hemoglobin Powder, Frozen Beef Blood, and human blood. We present a logarithmic model that specifies the relationship between the Red channel of the RGB values and Hemoglobin concentration.
more »
« less
A microfluidic approach for hemoglobin detection in whole blood
Diagnosis of anemia relies on the detection of hemoglobin levels in a blood sample. Conventional blood analyzers are not readily available in most low-resource regions where anemia is prevalent, so detection methods that are low-cost and point-of-care are needed. Here, we present a microfluidic approach to measure hemoglobin concentration in a sample of whole blood. Unlike conventional approaches, our microfluidic approach does not require hemolysis. We detect the level of hemoglobin in a blood sample optically by illuminating the blood in a microfluidic channel at a peak wavelength of 540 nm and measuring its absorbance using a CMOS sensor coupled with a lens to magnify the image onto the detector. We compare measurements in microchannels with channel heights of 50 and 115 μm and found the channel with the 50 μm height provided a better range of detection. Since we use whole blood and not lysed blood, we fit our data to an absorption model that includes optical scattering in order to obtain a calibration curve for our system. Based on this calibration curve and data collected, we can measure hemoglobin concentration within 1 g/dL for severe cases of anemia. In addition, we measured optical density for blood flowing at a shear rate of 500 s-1 and observed it did not affect the nonlinear model. With this method, we provide an approach that uses microfluidic detection of hemoglobin levels that can be integrated with other microfluidic approaches for blood analysis.
more »
« less
- Award ID(s):
- 1402673
- PAR ID:
- 10597501
- Publisher / Repository:
- American Institute of Physics
- Date Published:
- Journal Name:
- AIP Advances
- Volume:
- 7
- Issue:
- 10
- ISSN:
- 2158-3226
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Here, we developed a microfluidic electrochemical flow cell for fast-scan cyclic voltammetry which is capable of rapid on-chip dilution for efficient and cost-effective electrode calibration. Fast-scan cyclic voltammetry (FSCV) at carbon-fiber microelectrodes is a robust electroanalytical technique used to measure subsecond changes in neurotransmitter concentration over time.Traditional methods of electrode calibration for FSCV require several milliliters of a standard. Additionally, generating calibration curves can be time-consuming because separate solutions must be prepared for each concentration. Microfluidic electrochemical flow cells have been developed in the past; however, they often require incorporating the electrode in the device, making it difficult to remove for testing in biological tissues. Likewise, current microfluidic electrochemical flow cells are not capable of rapid on-chip dilution to eliminate the requirement of making multiple solutions. We designed a T-channel device, with microchannel dimensions of 100 μm × 50 μm, that delivered a standard to a 2-mm-diameter open electrode sampling well. A waste channel with the same dimensions was designed perpendicular to the well to flush and remove the standard. The dimensions of the T-microchannels and flow rates were chosen to facilitate complete mixing in the delivery channel prior to reaching the electrode. The degree of mixing was computationally modeled using COMSOL and was quantitatively assessed in the device using both colored dyes and electrochemical detection. On-chip electrode calibration for dopamine with FSCV was not significantly different than the traditional calibration method demonstrating its utility for FSCV calibration. Overall, this device improves the efficiency and ease of electrode calibration.more » « less
-
Abstract ObjectivesThis study explored differing levels of macronutrients in breast milk in relation to maternal anemia and hemoglobin. MethodsArchived milk specimens and data from a cross‐sectional sample of 208 breastfeeding mothers in northern Kenya, originally collected in 2006, were analyzed; data included milk fat, maternal hemoglobin concentration, and anemia status (anemia defined as hemoglobin <12 g/dL). Total protein and lactose were measured and energy was calculated. To explore the association between milk outcomes (fat, protein, lactose, and energy) and anemia, regression models were constructed with and without adjustment for maternal age, parity, and time (days) postpartum. The same models were constructed using hemoglobin as a continuous predictor in lieu of dichotomous anemia to explore the role of hemoglobin levels and anemia severity in predicting milk outcomes. ResultsThe group comparison indicated significantly higher milk protein and lower milk fat for anemic mothers relative to nonanemic counterparts. After adjustment for maternal age, parity, and time postpartum, maternal anemia was associated with significantly higher milk protein (P = 0.001) and significantly lower milk fat (P = 0.025). Hemoglobin had a significant inverse relationship with milk protein (P = 0.017) and a marginally significant positive relationship with milk fat (P = 0.060) after adjusting for the maternal variables. Neither anemia nor hemoglobin was significant in predicting lactose or milk energy. ConclusionsMaternal anemia and hemoglobin concentration may be associated with complex changes in milk macronutrients. Future research should clarify the impact of maternal anemia on a range of breast milk components while accounting for other maternal characteristics.more » « less
-
Rapid, simple, inexpensive, accurate, and sensitive point-of-care (POC) detection of viral pathogens in bodily fluids is a vital component of controlling the spread of infectious diseases. The predominant laboratory-based methods for sample processing and nucleic acid detection face limitations that prevent them from gaining wide adoption for POC applications in low-resource settings and self-testing scenarios. Here, we report the design and characterization of an integrated system for rapid sample-to-answer detection of a viral pathogen in a droplet of whole blood comprised of a 2-stage microfluidic cartridge for sample processing and nucleic acid amplification, and a clip-on detection instrument that interfaces with the image sensor of a smartphone. The cartridge is designed to release viral RNA from Zika virus in whole blood using chemical lysis, followed by mixing with the assay buffer for performing reverse-transcriptase loop-mediated isothermal amplification (RT-LAMP) reactions in six parallel microfluidic compartments. The battery-powered handheld detection instrument uniformly heats the compartments from below, and an array of LEDs illuminates from above, while the generation of fluorescent reporters in the compartments is kinetically monitored by collecting a series of smartphone images. We characterize the assay time and detection limits for detecting Zika RNA and gamma ray-deactivated Zika virus spiked into buffer and whole blood and compare the performance of the same assay when conducted in conventional PCR tubes. Our approach for kinetic monitoring of the fluorescence-generating process in the microfluidic compartments enables spatial analysis of early fluorescent “bloom” events for positive samples, in an approach called “Spatial LAMP” (S-LAMP). We show that S-LAMP image analysis reduces the time required to designate an assay as a positive test, compared to conventional analysis of the average fluorescent intensity of the entire compartment. S-LAMP enables the RT-LAMP process to be as short as 22 minutes, resulting in a total sample-to-answer time in the range of 17–32 minutes to distinguish positive from negative samples, while demonstrating a viral RNA detection as low as 2.70 × 10 2 copies per μl, and a gamma-irradiated virus of 10 3 virus particles in a single 12.5 μl droplet blood sample.more » « less
-
Using Monte Carlo simulated PPGs signals to train a deep learning model to predict hemoglobin levelsVolpe, Giovanni; Pereira, Joana B; Brunner, Daniel; Ozcan, Aydogan (Ed.)Measuring Hemoglobin (Hb) levels is required for the assessment of different health conditions, such as anemia, a condition where there are insufficient healthy red blood cells to carry enough oxygen to the body's tissues. Measuring Hb levels requires the extraction of a blood sample, which is then sent to a laboratory for analysis. This is an invasive procedure that may add challenges to the continuous monitoring of Hb levels. Noninvasive techniques, including imaging and photoplethysmography (PPG) signals combined with machine learning techniques, are being investigated for continuous measurements of Hb. However, the availability of real data to train the algorithms is limited to establishing a generalization and implementation of such techniques in healthcare settings. In this work, we present a computational model based on Monte Carlo simulations that can generate multispectral PPG signals that cover a broad range of Hb levels. These signals are then used to train a Deep Learning (DL) model to estimate hemoglobin levels. Through this approach, valuable insights about the relationships between PPG signals, oxygen saturation, and Hb levels are learned by the DL model. The signals were generated by propagating a source in a volume that contains the skin tissue properties and the target physiological parameters. The source consisted of plane waves using the 660 nm and 890 nm wavelengths. A range of 6 g/dL to 18 dL Hb values was used to generate 468 PPGs to train a Convolutional Neural Network (CNN). The initial results show high accuracy in detecting low levels of Hb. To the best of our knowledge, the complexity of biological interactions involved in measuring hemoglobin levels has yet to be fully modeled. The presented model offers an alternative approach to studying the effects of changes in Hb levels on the PPGs signal morphology and its interaction with other physiological parameters that are present in the optical path of the measured signals.more » « less
