An official website of the United States government
This study revealed the effects of incorporating ionic liquid (IL) molecules: 1-ethyl, 1-butyl, and 1-octyl-3-methyl-imidazolium chlorides with different alkyl chain lengths, in interfacial polymerization (IP) on the structure and property (i.e., permeate-flux and salt rejection ratio) relationships of resulting RO membranes. The IL additive was added in the aqueous meta-phenylene diamine (MPD; 0.1% w/v) phase, which was subsequently reacted with trimesoyl chloride (TMC; 0.004% w/v) in the hexane phase to produce polyamide (PA) barrier layer. The structure of resulting free-standing PA thin films was characterized by grazing incidence wide-angle X-rays scattering (GIWAXS), which results were correlated with the performance of thin-film composite RO membranes having PA barrier layers prepared under the same IP conditions. Additionally, the membrane surface properties were characterized by zeta potential and water contact angle measurements. It was found that the membrane prepared by the longer chain IL molecule generally showed lower salt rejection ratio and higher permeation flux, possibly due to the inclusion of IL molecules in the PA scaffold. This hypothesis was supported by the GIWAXS results, where a self-assembled surfactant-like structure formed by IL with the longest aliphatic chain length was detected.
more »
« less
Grazing Incidence Wide-Angle X-ray Scattering of Water Adsorption in Polyamide Barrier Layers of Reverse Osmosis Membranes
To understand the relationship between the intermolecular structure of aromatic polyamide (PA) scaffold and the water molecules in the barrier layers of reverse osmosis (RO) membranes, a grazing incidence wide-angle X-ray scattering (GIWAXS) study was carried out on freestanding PA thin films at varying relative humidity (RH) conditions. The scattering results were analyzed by an interference scattering model, containing a phase factor between a PA chain and an adsorbed water molecule. This model yielded good fits to the GIWAXS profiles where the water adsorption was found to vary linearly with RH. Atomistic molecular dynamics (MD) simulations were also performed to complement the experimental study. The simulations revealed that a rapid condensation layer initially formed on the PA film surface, followed by the slow water molecule diffusion inside the PA membrane. Sparse adsorbed water, isolated in subnanopores of the PA film adjacent to the polar atoms, even in very low quantities, modifies the X-ray scattering. Atomistic simulations at the microscopic scale provide partial support for several X-ray scattering findings.
more »
« less
- PAR ID:
- 10626995
- Publisher / Repository:
- ACS
- Date Published:
- Journal Name:
- Macromolecules
- Volume:
- 58
- Issue:
- 1
- ISSN:
- 0024-9297
- Page Range / eLocation ID:
- 723 to 732
- Subject(s) / Keyword(s):
- Humidity Membranes Molecules Scattering Thin Films
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Metal-organic framework (MOF) thin films offer exceptional properties for diverse applications, yet the mechanisms underlying MOF crystallization are not fully understood. Knowledge gaps remain regarding the nucleation and growth mechanisms of these highly porous, crystalline materials under dynamic evaporative conditions. Here, an in situ grazing incidence wide-angle X-ray scattering (GIWAXS) combined with a microkinetic model is used to probe the dynamic growth of MOF films. We show that while most high-order oligomers are produced in the solution phase, the key parameters that control thin-film growth are autocatalytic synthesis of secondary building units (SBUs) followed by physisorption on silicon wafer substrate, exponential growth due to evaporation-driven step growth, and transition to the stationary phase due to mass-transfer-limited growth. Importantly, this study demonstrates the applicability of this microkinetic modeling framework to predict film properties across a range of temperatures and reactant concentrations, allowing for rational design of MOF thin films.more » « less
-
While there has been rapid progress in the performance of perovskite solar cells, the details of film formation, effect of processing parameters and perovskite crystal structure are still under discussion. The details of the X-ray diffraction (XRD) pattern of the tetragonal phase of CH 3 NH 3 PbI 3 perovskite existing at room temperature are often overlooked, with unresolved (002) (at 2 θ = 13.99° for CuK α and q = 0.9927 Å −1 ) and (110) (at 2 θ = 14.14° and q = 1.003 Å −1 ) peaks considered to be one peak at 14°, leading to an inaccurate estimation of lattice parameters. In this study, we use an electrospray deposition technique to prepare perovskite films at room temperature, oriented in (002) and (110) directions, with (002) as the preferred orientation. The results of a detailed study on the emergence of the two orientations during perovskite formation are reported. The effect of process parameters, such as substrate temperature during deposition and annealing temperature, on the grain orientation was established using XRD and grazing incidence wide angle X-ray scattering (GIWAXS). The study suggests that an irreversible crystal reorientation from (002) to (110) occurs at high temperature during rapid annealing, whereas a reversible crystal thermal expansion is seen during slow annealing. Finally, the results of the grain reorientation are correlated with the film properties, and it is shown that the film with the dominant (110) orientation has improved morphology and optoelectronic properties. The detailed structural investigation and characterization presented in this study are important for the precise determination of crystal orientation and achievement of desirable photovoltaic properties of the absorber material by carefully observing the adjacent crystal plane peaks in the XRD pattern of the perovskite thin films.more » « less
-
null (Ed.)Measuring the attosecond movement of electrons in molecules is challenging due to the high temporal and spatial resolutions required. X-ray scattering-based methods are promising, but many questions remain concerning the sensitivity of the scattering signals to changes in density, as well as the means of reconstructing the dynamics from these signals. In this paper, we present simulations of stationary core-holes and electron dynamics following inner-shell ionization of the oxazole molecule. Using a combination of time-dependent density functional theory simulations along with X-ray scattering theory, we demonstrate that the sudden core-hole ionization produces a significant change in the X-ray scattering response and how the electron currents across the molecule should manifest as measurable modulations to the time dependent X-ray scattering signal. This suggests that X-ray scattering is a viable probe for measuring electronic processes at time scales faster than nuclear motion.more » « less
-
The activation of reactants by catalytically active metal sites at metal-oxide interfaces is important for understanding the effect of metal-support interactions on nanoparticle catalysts and for tuning activity and selectivity. Using a combined experimental and theoretical approach, we studied the activation of H2 and the effect of CO poisoning on isolated Rh atoms completely or partially covered by a copper oxide (Cu2O) thin film. Temperature programmed desorption (TPD) experiments conducted in ultra-high vacuum (UHV) show that neither a partially nor a fully oxidized Cu2O layer grown on a Rh/Cu(111) single-atom alloy can activate hydrogen in UHV. However, in situ ambient pressure X-ray photoelectron spectroscopy (AP-XPS) experiments performed at elevated H2 pressures reveal that Rh significantly accelerates the reduction of these Cu2O thin films by hydrogen. Remarkably, the fastest reduction rate is observed for the fully oxidized sample with all Rh sites covered by Cu2O. Both TPD and AP-XPS data demonstrate that these covered Rh sites are inaccessible to CO, indicating that Rh under Cu2O is active for H2 dissociation but cannot be poisoned by CO. In contrast, an incomplete oxide film leaves some of the Rh sites exposed and accessible to CO, and hence prone to CO poisoning. Density functional theory calculations demonstrate that unlike many reactions in which hydrogen activation is rate limiting, the rate-determining step in the dissociation of H2 on thin-film Cu2O with Rh underneath is the adsorption of H2 on the buried Rh site, and once adsorbed, the dissociation of H2 is barrierless. These calculations also explain why H2 can only be activated at higher pressures. Together, these results highlight how different the reactivity of atomically dispersed Rh in Cu can be depending on its accessibility through the oxide layer, providing a way to engineer Rh sites that are active for hydrogen activation but resilient to CO poisoning.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript
- Journal Article:
- https://doi.org/10.1021/acs.macromol.4c02699
