Title: Multi-mode interference waveguide spectrometer with optimized performance
Chip-scale integrated imaging spectrometers show significant potential for high-performance spectral analysis due to advancements in fabrication and computational techniques. Many practical applications, such as astronomy and molecular spectroscopy, require analyzing light at sub-nanowatt levels, where inherent enhancement in spectrometer signals can reduce the need for expensive photodetectors or long integration time. Previously, we introduced an integrated spectrometer scheme using machine learning to reconstruct spectra from imaging the wavelength-dependent patterns scattered out of a multimode interference (MMI) waveguide. In this work, we report a signal enhancement of 13.6 dB and an increase of device sensitivity and dynamic range by 15 dB by selective roughening of the waveguide surface via plasma etching. By imaging interference patterns at various points along the waveguide, we determine that the best spectrometer performance is achieved by imaging MMI sections with highest pattern variation. We report accurate spectral measurements using convolutional neural network-based spectral reconstruction with 1 nm resolution at input powers as low as 300 pW for the present experimental configuration, and a scattering coefficient of 1.109 cm-1from the etched section.  more » « less
Award ID(s):
2206564 2206259
PAR ID:
10634808
Author(s) / Creator(s):
; ; ; ; ; ; ; ;
Publisher / Repository:
Optica
Date Published:
Journal Name:
Optics Express
Volume:
32
Issue:
26
ISSN:
1094-4087
Page Range / eLocation ID:
45873
Subject(s) / Keyword(s):
Sponsoring Org:
National Science Foundation
More Like this
  1. A multi-mode interferometer (MMI) spectrometer is a type of reconstructive micro-spectrometer based on imaging light propagation patterns in MMI waveguides. A waveguide scattering surface accentuates imaging light patterns in the multi-mode interferometer. This technology has been proven with an SU-8 core waveguide with an etched SU-8 nanograss scattering surface. This paper describes our creation of a fully silicon-based spectrometer using a silica core MMI waveguide. Scattering features were created in silica using SU-8 nanograss as an etch mask in a reactive ion etch (RIE). With optimized etch parameters, the silica core MMI spectrometer achieved an SNR of three with an incident light power of −68 dBm, which was almost 6 dB lower than designs with an SU-8 core. 
    more » « less
  2. Spectral analysis of light is one of the oldest and most versatile scientific methods and the basis of countless techniques and instruments. Miniaturized spectrometers have recently seen great advances, but challenges remain before they are widely deployed. We report an integrated photonic spectrometer that achieves high performance with minimal component complexity by combining imaging of light propagation patterns in multi-mode interference waveguides with machine learning analysis. We demonstrate broadband operation in the visible and near-infrared, 0.05 nm spectral resolution, and an array of four spectrometers on a single chip. Two canonical applications are implemented: spectral analysis of the solar spectrum with neural network reconstruction and detection of Rayleigh scattering from microbeads on an optofluidic chip using principal component classification. These results illustrate the potential of this approach for high-performance spectroscopy across disciplines. 
    more » « less
  3. We demonstrate a compact, foundry-compatible silicon thermo-optic phase shifter (TOPS) based on a substrate-undercut doped-silicon heater, achieving aπ-phase-shift power ofPπ=0.74 mW at a drive voltage of onlyVπ=0.91 V. Prior low-power phase shifters reach comparable or lowerPπonly by extending the heated length, enlarging the footprint, and none report CMOS-compatible drive voltages. Here, both the heater and the 2×2 multimode interference (MMI) couplers are optimized using particle swarm optimization (PSO), the former to jointly minimizePπand optical loss at a fixed 100 µm length in a compact 240×73 µm2footprint. Integrated into a Mach–Zehnder switch, the device shows an insertion loss of 0.90 dB, an extinction ratio of 23 dB, and rise/fall times of 1.38/1.02 ms. To our knowledge, this is the first foundry-fabricated TOPS to combine sub-milliwattPπ, a compact low-latency arm, and a sub-1-V CMOS-compatibleVπ, offering a scalable route to low-energy programmable silicon photonic meshes. 
    more » « less
  4. In this paper, we present the design, optimization, and implementation of a sub-wavelength grating (SWG) multi-mode interference coupler (MMI) on the silicon nitride photonic integrated circuit (PIC) platform with a significantly enhanced bandwidth compared to the conventional MMI. We extend the SWG MMI theory, previously presented for the silicon-on-insulator platform, to the Si3N4/SiO2platform. Our approach involves an initial parameter optimization for a non-paired design, followed by a shift to a paired design that offers a smaller footprint and a broader bandwidth. The optimized SWG MMI exhibits a 1 dB bandwidth of 300 nm for both the insertion loss and power imbalance, making it a significant addition to silicon nitride photonics. 
    more » « less
  5. Sanders, Glen A.; Lieberman, Robert A.; Udd Scheel, Ingrid (Ed.)
    Evanescent wave sensors in photonic integrated circuits have been demonstrated for gas sensing applications. While some methods rely on the distinctive response of certain polymers for sensing specific gases, absorption spectroscopy identifies any gas uniquely from their unique vibration signatures. Based on the Beer-Lambert principle, the sensitivity of absorption by a gas on chip relies on the length of the sensing region, the optical overlap integral with the analyte gas and the absorption cross-section at the wavelength with the fundamental vibration signature. The overlap of the optical mode with the analyte has been enhanced in photonic devices by combining slot waveguide confinements with photonic crystal slow light effects. While the absorption cross-section is a property of the gas, the length of the sensing region is limited by the available area on a chip and waveguide propagation losses that limit the minimum signal to noise ratio. In this paper, we show that by incorporating reflecting loop mirrors, the absorption path length can be doubled for the same geometric length of the absorption sensing waveguide. Light from a waveguide is split into two paths, each with a slow light photonic crystal waveguide, by a 2×2 multimode interference (MMI) power splitter. Each path is terminated by a loop mirror that causes the light to retrace its path back down the sensing arms thereby doubling the optical path length over which light interacts with the analyte. Results on the enhancement of phase sensitivity and absorbance sensitivity in the interferometric configuration are presented 
    more » « less