An official website of the United States government
Abstract Stress‐driven melt segregation may have important geochemical and geophysical effects but remains a poorly understood process. Few constraints exist on the permeability and distribution of melt in deformed partially molten rocks. Here, we characterize the 3D melt network and resulting permeability of an experimentally deformed partially molten rock containing several melt‐rich bands based on an X‐ray microtomography data set. Melt fractions range from 0.08 to 0.28 in the ∼20‐μm‐thick melt‐rich bands, and from 0.02 to 0.07 in the intervening ∼30‐μm‐thick regions. We simulated melt flow through subvolumes extracted from the reconstructed rock at five length scales ranging from the grain scale (3 μm) to the minimum length required to fully encompass two melt‐rich bands (64 μm). At grain scale, few subvolumes contain interconnected melt, and permeability is isotropic. As the length scale increases, more subvolumes contain melt that is interconnected parallel to the melt bands, but connectivity diminishes in the direction perpendicular to them. Even if melt is connected in all directions, permeability is lower perpendicular to the bands, in agreement with the elongation of melt pockets. Permeability parallel to the bands is proportional to melt fraction to the power of an exponent that increases from ∼2 to 5 with increasing length scale. The permeability in directions parallel to the bands is comparable to that for an isotropic partially molten rock. However, no flow is possible perpendicular to the bands over distances similar to the band spacing. Melt connectivity limits sample scale melt flow to the plane of the melt‐rich bands.
more »
« less
Volatiles in olivine-hosted melt inclusions from a rejuvenated Oʻahu tephra: Degree of melting controls the primary melt CO2 content—And extent of H2O degassing—Of OIB
- PAR ID:
- 10650521
- Publisher / Repository:
- Chemical Geology
- Date Published:
- Journal Name:
- Chemical Geology
- Volume:
- 678
- Issue:
- C
- ISSN:
- 0009-2541
- Page Range / eLocation ID:
- 122604
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract Seismic and magnetotelluric studies suggest hydrous silicate melts atop the 410 km discontinuity form 30–100 km thick layers. Importantly, in some regions, two layers are observed. These stagnant layers are related to their comparable density to the surrounding mantle, but their formation mechanisms and detailed structures remain unclear. Here we report a large decrease of silicate melt viscosity at ~14 GPa, from 96(5) to 11.7(6) mPa⋅s, as water content increases from 15.5 to 31.8 mol% H₂O. Such low viscosities facilitate rapid segregation of melt, which would typically prevent thick layer accumulation. Our 1D finite element simulations show that continuous dehydration melting of upwelling mantle material produces a primary melt layer above 410 km and a secondary layer at the depth of equal mantle-melt densities. These layers can merge into a single thick layer under low density contrasts or high upwelling rates, explaining both melt doublets and thick single layers.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript
- Journal Article:
- https://doi.org/10.1016/j.chemgeo.2024.122604
