Nucleation of H2O vapor bubbles in magma requires surpassing a chemical supersaturation threshold via decompression. The threshold is minimized in the presence of a nucleation substrate (heterogeneous nucleation, <50 MPa), and maximized when no nucleation substrate is present (homogeneous nucleation, >100 MPa). The existence of explosively erupted aphyric rhyolite magma staged from shallow (<100 MPa) depths represents an apparent paradox that hints at the presence of a cryptic nucleation substrate. In a pair of studies focusing on Glass Mountain eruptive units from Medicine Lake, California, we characterize titanomagnetite nanolites and ultrananolites in pumice, obsidian, and vesicular obsidian (Brachfeld et al., 2024,https://doi.org/10.1029/2023GC011336), calculate titanomagnetite crystal number densities, and compare titanomagnetite abundance with the physical properties of pumice to evaluate hypotheses on the timing of titanomagnetite crystallization. Titanomagnetite crystals with grain sizes of approximately 3–33 nm are identified in pumice samples from the thermal unblocking of low‐temperature thermoremanent magnetization. The titanomagnetite number densities for pumice are 10^18 to 10^20 m^−3, comparable to number densities in pumice and obsidian obtained from room temperature methods (Brachfeld et al., 2024,https://doi.org/10.1029/2023GC011336'>https://doi.org/10.1029/2023GC011336). This range exceeds reported bubble number densities (BND) within the pumice from the same eruptive units (average BND ∼4 × 10^14 m^−3). The similar abundances of nm‐scale titanomagnetite crystals in the effusive and explosive products of the same eruption, together with the lack of correlation between pumice permeability and titanomagnetite content, are consistent with titanomagnetite formation having preceded the bubble formation. Results suggest sub‐micron titanomagnetite crystals are responsible for heterogeneous bubble nucleation in this nominally aphyric rhyolite magma.
more »
« less
This content will become publicly available on February 10, 2027
Magma in the microwave
Classroom demonstrations of volcanic processes are typically performed with low-temperature materials designed to exhibit behaviors conceptually analogous to magma. However, there are advantages to finding methods by which real magma can be created and used with audiences and students. Here, we describe a method by which magma can be made at home or in a classroom using a standard household microwave. We have tested a particular demonstration of how volatiles such as H2O exsolve from natural obsidian to form pumice and ash, a direct replica of the volcanic phenomenon that drives eruptions on Earth and other planets. To demonstrate this, we used three obsidian samples—from Mono Craters (U.S.A.), Arteni (Armenia), and Hrafntinnuhryggur (Iceland)—within an off-the-shelf ceramics microwave kiln in both a 700 and 1000 W microwave. We found that millimetric obsidian chips will vesiculate to form pumice-like textures at low microwave power or low initial H2O content and will fragment safely within the kiln at high microwave power or high initial H2O content. This can be used to supplement existing well-known demonstrations using low-temperature analogs for magma. The demonstration results in real products that can be examined just as a geologist would examine natural specimens.
more »
« less
- PAR ID:
- 10684940
- Publisher / Repository:
- Volcanica
- Date Published:
- Journal Name:
- Volcanica
- Volume:
- 9
- Issue:
- 1
- ISSN:
- 2610-3540
- Page Range / eLocation ID:
- 219 to 230
- Subject(s) / Keyword(s):
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Volcanic eruptions of rhyolitic magma often show shifts from powerful (Vulcanian to Plinian) explosive episodes to a more gentle effusion of viscous lava forming obsidian flows. Another prevailing characteris-tic of these eruptions is the presence of pyroclastic obsidians intermingled with the explosive tephra. This dense, juvenile product is similar to the tephra and obsidian flow in composition, but is generally less degassed than its flow counterpart. The formation mechanism(s) of pyroclastic obsidians and the information they can provide concerning the extent to which magma degassing modulates the eruptive style of rhyolitic eruptions are currently subject to active research. Porous tephra and pyroclastic and flow obsidians from the 1060CE Glass Mountain rhyolitic eruption at Medicine Lake Volcano (California) were analyzed for their porosity, φ, water content, H2O, and hydrogen isotopic composition, δD. H2O in porous pyroclasts is correlated negatively with δD and positively with φ, indicating that the samples were affected by post-eruptive rehydration. Numerical modeling suggests that this rehydration occurred at an average rate of 10−23.5±0.5m2s−1during the ∼960 years since the eruption, causing some pyroclasts to gain up to 1 wt%of meteoric water. Pyroclastic and flow obsidians were not affected by rehydration due to their very low porosity. Comparison between modeled δD-H2O relationships in degassing magma and values measured in the Glass Mountain samples supports the idea that rhyolitic magma degasses in closed-system until its porosity reaches a value of about 65±5%, beyond which degassing occurs in open-system until quench. During the explosive phase, rapidly ascending magma fragments soon after it becomes permeable, creating porous lapilli and ash that continue to degas in open-system within an expanding gas phase. As suggested by recent studies, some ash may aggregate and sinter on the conduit sides at different depths above the fragmentation level, partly equilibrating with the continuously fluxing heavier magmatic vapor, explaining the wide range of H2O contents and high variability in δD measured in the pyroclastic obsidians. Using only H2O and δD, it is impossible to rule out the possibility that pyroclastic obsidians may also form by permeable foam collapse, either syn-explosively near the conduit sides below the fragmentation level or during more effusive periods interspersed in the explosive phase. During the final effusive phase of the eruption, slowly ascending magma degasses in open-system until it reaches the surface, creating flows with low H2O and δD. This study shows that H2O measured in highly porous pyroclasts of a few hundred years or more cannot be used to infer syn-eruptive magma degassing pathways, unless careful assessment of post-eruptive rehydration is first carried out. If their mechanism of formation can be better understood, detailed analysis of the variations in texture and volatile content of pyroclastic obsidians throughout the explosive phase may help decipher the reasons why rhyolitic eruptions commonly shift from explosive to effusive phases.more » « less
-
We document the presence, composition, and number density (TND) of titanomagnetite nanolites and ultra‐nanolites in aphyric rhyolitic pumice, obsidian, and vesicular obsidian from the 1060 CE Glass Mountain volcanic eruption of Medicine Lake Volcano, California, using magnetic methods. Curie temperatures indicate compositions of Fe2.40Ti0.60O4 to Fe3O4. Rock‐magnetic parameters sensitive to domain state, which is dependent on grain volume, indicate a range of particle sizes spanning superparamagnetic (<50–80 nm) to multidomain (>10 μm) particles. Cylindrical cores drilled from the centers of individual pumice clasts display anisotropy of magnetic susceptibility with prolate fabrics, with the highest degree of anisotropy coinciding with the highest vesicularity. Fabrics within a pumice clast require particle alignment within a fluid, and are interpreted to result from the upward transport of magma driven by vesiculation, ensuing bubble growth, and shearing in the conduit. Titanomagnetite number density (TND) is calculated from titanomagnetite volume fraction, which is determined from ferromagnetic susceptibility. TND estimates for monospecific assemblages of 1,000 nm–10 nm cubes predict 10^12 to 10^20 m^−3 of solid material, respectively. TND estimates derived using a power law distribution of grain sizes predict 10^18 to 10^19 m^−3. These ranges agree well with TND determinations of 10^18 to 10^20 m^−3 made by McCartney et al. (2024), and are several orders of magnitude larger than the number density of bubbles in these materials. These observations are consistent with the hypothesis that titanomagnetite crystals already existed in extremely high number‐abundance at the time of magma ascent and bubble nucleation.more » « less
-
The solidification of a deep magma ocean occurred early in Earth’s history. Although the initial amount of H2O in Earth’s magma ocean is predicted to be low (e.g., <3000 ppm), as an incompatible element it becomes highly enriched (e.g. >10 wt%) in the final few percent of crystallization. In order to understand how a hydrous magma ocean would crystallize at the top of the lower mantle, we determined liquidus phase relations in the MgO-FeOCaO-Al2O3-SiO2-H2O system at 24 GPa. We find that the bridgmanite (brg) + stishovite (st) + melt and bridgmanite (brg) + ferropericlase (fp) + melt cotectic boundary curves trend to Mg-rich melt compositions with decreasing temperature and extend to very high H2O contents (~80 mol% H2O). The brg+st+melt curve is a subtraction curve at < ~18 mol% H2O and a reaction curve at higher H2O contents, whereas the brg+fp+melt is a subtraction curve throughout its length. The density of melts along the two cotectics leads to neutral buoyancywith respect to shallow lower mantle and transition zone minerals at H2O contents up to ~25 mol%. A transient melt-rich layer can form at the top of the lower mantle during late-stage crystallization in a mushy magma ocean when melt percolation dominates. When crystallization exceeds ~98%, hydrous melts (>25 mol% H2O) become buoyant and can percolate into and hydrate the mantle transition zone.more » « less
-
There is a broad consensus that magma eruptibility—the ability of magma stored in the subsurface to erupt onto Earth's surface—is strongly controlled by viscosity. Related to this, a critical parameter that controls viscosity is crystallinity. However, there is uncertainty in the crystallinities that distinguish eruptible from non-eruptible magmas, and whether highly crystalline magmas (>60 vol.%) could be erupted in some conditions. An underutilized but important source of information for understanding this relationship is the observed crystallinities in erupted volcanic materials, which by definition represent a set of eruptible magmas. Here we present a compilation of reported crystallinities for nearly 1000 volcanic samples of differing composition, tectonic setting, and eruption style, which provides valuable insight into the fundamental mechanisms which drive eruptions. Overall, the 95th percentile crystallinity value of our full dataset is 57 vol.%, and \>99 % of all non-dome samples have crystallinity ≤53 vol.%. This suggests that 50–60 vol.% crystallinity represents a fundamental limit for eruptibility for most volcanic rocks. Some dome samples are clear exceptions to this and are erupted with considerably higher crystallinities. There is also a significant correlation between crystallinity and whole rock SiO2 content as observed previously, but a shallow slope suggests whole rock and melt silica content have less impact on critical crystallinity for erupted magma than previously thought. Melt viscosity (as a function of SiO2, temperature, and H2O content) and crystallinity both play important roles on increasing effective viscosity, where melt viscosity plays a more important role at low crystal fractions, and crystallinity plays a more important role at crystallinities greater than ~40 vol.%.more » « less
An official website of the United States government
