An official website of the United States government
Ternary III-nitride-based nanowires with highly efficient light-emitting properties are essential for a broad range of applications. By using the selective area molecular-beam epitaxy method, InGaN/AlGaN quantum disks (QDs) embedded in hexagonal GaN nanowires were successfully grown. With the help of atomic-scale-resolved transmission electron microscopy and atom probe tomography, atomic ordering and other related structural information, such as crystallography and local chemistry, have been unambiguously revealed to provide unique insights into the exceptionally strong photoluminescence enhancements. A boomerang-shaped InGaN/AlGaN QD was identified, and atomic-level 1 : 1 periodic chemical ordering within the boomerang shaped AlGaN layers along the c -direction was revealed, confirming the preferential site occupation of Al-atoms. This type of growth provides a strong suppression of the quantum-confined Stark effect and is thus likely a very strong contributor to the exceptional properties. This work therefore enables us to directly establish the key structural elements necessary to understand the exceptionally strong emission exhibited by these materials. Optimization of the configurations of QDs could be an alternative design tool for developing various advanced LED device applications with well-designed structure and desirable optical properties.
more »
« less
This content will become publicly available on March 7, 2027
Nanoscale analysis of MOCVD-grown Mg-doped Al x Ga1− x N/GaN quantum well infrared photodetector (QWIP): Insights into dopant distribution and device performance
Quantum well infrared photodetectors (QWIPs) have emerged as a high-performance and versatile platform for IR detection applications owing to their design flexibility, fast response time, and wavelength tunability across a wide spectral range. While research and development in this field have predominantly focused on GaAs-based QWIPs owing to their mature growth technique and well-understood material properties, III-nitride-based QWIPs can offer potential advantages such as a wider bandgap and strong polarization charges. However, the study of GaN-based QWIPs is still in its early stages and requires further exploration to achieve optimal device performance. Compared to n-QWIPs, p-QWIPs allow for normal-incident absorption, significantly reducing device complexity and size by eliminating the light coupler, which is particularly advantageous for hand-held and imaging applications. We perform detailed atomic-scale characterization of the distribution of Mg acceptors in layers and at interfaces of a Mg-doped AlGaN/GaN p-QWIP grown by metal organic chemical vapor deposition. Device design, device structure growth conditions, and electrical characterization of the QWIP are presented. Initial electrical characterizations revealed a small but noticeable increase in photocurrent upon illumination. We suspect that photoresponsivity (∼μA/W) is highly impacted by low or inefficient Mg incorporation in the QWIP, limiting the carrier population in quantum wells. Atom probe tomography was employed to study the Mg concentration and distribution in the Mg-doped AlGaN/GaN p-QWIP and revealed Mg segregation and clustering in QWIP layers. These findings provide critical insights and pathways to enhance photoresponsivity and overall device performance in QW-based devices that require Mg p-doping.
more »
« less
- Award ID(s):
- 2145091
- PAR ID:
- 10690447
- Publisher / Repository:
- AIP journals
- Date Published:
- Journal Name:
- Journal of Applied Physics
- Volume:
- 139
- Issue:
- 9
- ISSN:
- 0021-8979
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
null (Ed.)Abstract Gallium nitride (GaN) has emerged as one of the most attractive base materials for next-generation high-power and high-frequency electronic devices. Recent efforts have focused on realizing vertical power device structures such as in situ oxide, GaN interlayer based vertical trench metal–oxide–semiconductor field-effect transistors (OG-FETs). Unfortunately, the higher-power density of GaN electronics inevitably leads to considerable device self-heating which impacts device performance and reliability. Halide vapor-phase epitaxy (HVPE) is currently the most common approach for manufacturing commercial GaN substrates used to build vertical GaN transistors. Vertical device structures consist of GaN layers of diverse doping levels. Hence, it is of crucial importance to measure and understand how the dopant type (Si, Fe, and Mg), doping level, and crystal quality alter the thermal conductivity of HVPE-grown bulk GaN. In this work, a steady-state thermoreflectance (SSTR) technique was used to measure the thermal conductivity of HVPE-grown GaN substrates employing different doping schemes and levels. Structural and electrical characterization methods including X-ray diffraction (XRD), secondary-ion mass spectrometry (SIMS), Raman spectroscopy, and Hall-effect measurements were used to determine and compare the GaN crystal quality, dislocation density, doping level, and carrier concentration. Using this comprehensive suite of characterization methods, the interrelation among structural/electrical parameters and the thermal conductivity of bulk GaN substrates was investigated. While doping is evidenced to reduce the GaN thermal conductivity, the highest thermal conductivity (201 W/mK) is observed in a heavily Si-doped (1–5.00 × 1018 cm−3) substrate with the highest crystalline quality. This suggests that phonon-dislocation scattering dominates over phonon-impurity scattering in the tested HVPE-grown bulk GaN substrates. The results provide useful information for designing thermal management solutions for vertical GaN power electronic devices.more » « less
-
Abstract In this work, an alternative scheme to estimate the resistivity and ionization energy of Al-rich p-AlGaN epitaxial films is developed using two large-area ohmic contacts. Accordingly, the resistivities measured using current–voltage measurements were observed to corroborate the Hall measurements in the Van der Pauw configuration. A free hole concentration of ∼1.5 × 10 17 cm −3 and low ionization energy of ∼65 meV in Mg-doped Al 0.7 Ga 0.3 N films is demonstrated. Nearly an order of magnitude lower hydrogen concentration than Mg in the as-grown AlGaN films is thought to reduce the Mg passivation and enable higher hole concentrations in Al-rich p-AlGaN films, compared to p-GaN films. The alternate methodology proposed in this work is expected to provide a simpler pathway to evaluate the electrical characteristics of Al-rich p-AlGaN films for future III-nitride ultraviolet light emitters.more » « less
-
Strassburg, Martin; Kim, Jong Kyu; Krames, Michael R. (Ed.)AlGaN-based ultra-violet light emitting diodes (UV LEDs) are promising for a range of applications, including water purification, air disinfection and medical sensing. However, widespread adoption of UV LEDs is limited by the poor device efficiency. This has been attributed to the strong internal light absorption and poor electrical injection efficiency for the conventional UV LED structures, which typically use an absorbing p-GaN layer for p-type contact. Recent development of ultra-wide banggap AlGaN tunnel junctions enabled a novel UV LED design with the absence of the absorbing p-GaN contact layer. In this presentation, we will discuss recent progress of the AlGaN tunnel junctions and the development of tunnel junction-based UV LEDs, and discuss the challenges and future perspectives for the realization of high power, high efficiency UV LEDs.more » « less
-
The demand for high power and high-frequency radio frequency (RF) power amplifiers makes AlGaN/GaN high electron mobility transistors (HEMTs) an attractive option due to their large critical field, high saturation velocity, and reduced device footprint as compared to Si-based counterparts. However, due to the high operating power densities, intense device self-heating occurs, which degrades the electrical performance and compromises the device’s reliability. The self-heating behavior of AlGaN/GaN HEMTs is known to be not solely a function of the dissipated power but is highly bias-dependent. As the operation of RF power amplifiers involves alteration of the device operation from fully-open to pinched-off channel conditions, it is critical to experimentally map the full channel temperature profile as a function of bias conditions. However, such measurement is difficult using optical thermography techniques due to the lack of optical access underneath the gate electrode, where the peak temperature is expected to occur. To address this challenge, an AlGaN/GaN HEMT employing a transparent gate made of indium tin oxide (ITO) was fabricated, which enables full channel temperature mapping using Raman spectroscopy. It was found that the maximum channel temperature rise under a partially pinched-off condition is more than ∼93% higher than that for an open channel condition, although both conditions would lead to an identical power dissipation level. The channel peak temperature probed in an ITO-gated device (underneath the gate) is ∼33% higher than the highest channel temperature that can be measured for a standard metal-gated AlGaN/GaN HEMT (i.e., next to the metal gate structure) operating under an identical bias condition. This indicates that one may significantly underestimate the device’s thermal resistance when solely relying on performing thermal characterization on the optically accessible region of a standard AlGaN/GaN HEMT. The outcomes of this study are important in terms of conducting a more accurate lifetime prediction of the device lifetime and designing thermal management solutions.more » « less
