Attention:The NSF Public Access Repository (PAR) system and access will be unavailable from 11:00 PM ET on Thursday, November 12th until 12:00 AM ET on Friday, November 13th due to maintenance. We apologize for the inconvenience.


Title: Seismic data collected at Sít’ Kusá (Turner Glacier), Alaska, 2020-2025
We will deploy up to six pairs of three-component broadband passive seismic stations along the margins of Turner Glacier. Five more intermediate-period geophones will be installed on the glacier surface (stations from the University of Idaho). Each glacier-adjacent pair will be orientated normal to the glacier flow, with one station on each side of the glacier and installed on bedrock or shallow sediment. Continuous broadband seismic data will be recorded at 100 Hz for the duration of the field deployment. This configuration will allow us to replicate the surface wave anisotropy study by Zhan (2019). Zhan (2019) used seismic noise to interrogate the subglacial drainage system of a surging glacier and found that changes in mechanical coupling between the ice and the glacial bed not only affects ice flow, but also the overall (poro)elastic properties of the ice‐water‐till‐bedrock system. From observations of seismic noise and the corresponding frequency-dependent surface-wave anisotropy, Zhan (2019) was able to infer that high subglacial water pressures are maintained by the impoundment of water in transverse basal crevasses during a glacier surge. We will apply the methodology of Zhan (2019) to determine if fluid-filled transverse basal crevasses exist prior to, during, and after surging at Turner Glacier. Passive seismic data will also allow us to track variations in subglacial water discharge. Recent observations of flow‐induced seismic noise, including at Alaskan tidewater glaciers similar to Turner Glacier, have demonstrated the ability to track increases and decreases in subglacial discharge and sediment transport, changes in the efficiency of the subglacial hydrologic system, and the extent of subglacial water pressurization (Bartholomaus et al., 2015; Gimbert et al. 2016; Bartholomaus et al., in prep.). The passive seismic data will be coupled with a numerical model of noise production by subglacial water flow and sediment transport to disentangle the noise produced by water or sediment transport using a technique newly developed by co-I Beaud. Extension of these techniques to ~15 km of Turner Glacier will allow us an unprecedented view of imbalances in water and sediment transport along the glacier bed, including and extending beyond the length of the actively surging glacier. To complement our assessment of subglacial water storage and transport, we will track changes in till consolidation and failure using seismic coda wave changes over time. Coda wave methods can be used to track seismic velocity variations in the subsurface (e.g., Sens-Schönfelder and Wegler 2006; Meier et al. 2010; Mainsant et al. 2012; Hillers et al. 2014; Hillers et al. 2015; Rivet, et al. 2015; Larose et al. 2015, and references therein). In general, the observed seismic velocity changes are attributed to changes in tectonic stress, hydrologic loading, or climate variation (e.g. air temperature or pressure). Mainsant et al. (2012) used coda wave changes to observe the failure of a clay layer at depth during a landslide. They showed that the seismic velocity of the sliding material, from daily noise-based coda wave measurements, decreased continuously and rapidly for several days prior to the catastrophic failure event as the layer became oversaturated. In order to test hypothesis 1, we will monitor changes in the till layer using this technique to determine the till state prior to, during, and after surge along the length of the glacier. To further refine this methodology, we will use the glacier parameters derived from active-source seismic observations to model the frequency-dependent sensitivity of surface waves (Mainsant et al. 2012) to the till layer and incorporate a new wavelet-based coda wave change measurement technique to improve depth resolution (Mordret et al., in review). The till state will be inferred from the observed frequency-dependent seismic velocity changes, with decreases in seismic velocity directly proportional to decreases in the shear modulus of the till.  more » « less
Award ID(s):
1954021
PAR ID:
10699106
Author(s) / Creator(s):
; ; ; ;
Publisher / Repository:
Arctic Data Center, via https://doi.org/10.18739/A2KP7TT53 EarthScope Data Center, via https://doi.org/10.7914/SN/YG_2020 EarthScope Data Center, via https://doi.org/10.7914/t59y-k271
Date Published:
Subject(s) / Keyword(s):
Format(s):
Size: 300000 MB Other: SEED data
Size(s):
300000 MB
Location:
(East Bound Longitude:-139.174; North Bound Latitude:60.255; South Bound Latitude:59.976; West Bound Longitude:-139.866)
Institution:
University of Idaho
Sponsoring Org:
National Science Foundation
More Like this
  1. The recent surge of the Bering-Bagley Glacier System (BBGS), Alaska, in 2008-2013 provided a rare opportunity to study surging in a large and complex system. We simulate glacier evolution for a 20 year quiescent phase, where geometrical and hydrological changes lead to conditions favorable for surging, and the first two years of a surge phase where a surge-front propagates through the system activating the surging ice. For each phase, we analyze the simulated elevation-change and ice-velocity pattern, and infer information on the evolving basal drainage system through hydropotential analysis. During the quiescent phase simulation, several reservoir areas form at locations consistent with those observed. Up-glacier of these reservoir areas, water drainage paths become increasingly lateral and hydropotential wells form indicating an expanding storage capacity of subglacial water. These results are attributed to local bedrock topography characterized by large subglacial ridges that act to dam the down-glacier flow of ice and water. Based on the BBGS’s end-of-quiescence state, we propose several surge initiation criteria to predict when the system is set to surge. In the surge simulation, we model surge evolution through Bering Glacier’s trunk by implementing a new friction law that mimics a propagating surge-wave. Modeled surge velocities share spatial patterns and reach similar peaks as those observed in 2008-2010. As the surge progresses through the glacier, drainage efficiency further degrades in the active surging zone from its already inefficient, end-of-quiescence state. Satellite observations from 2013 indicate hydraulic drainage efficiency throughout the glacier was restored after the surge had ended. 
    more » « less
  2. Abstract Recent seismic measurements from upper Thwaites Glacier indicate that the bed-type variability is closely related to the along-flow basal topography. In high-relief subglacial highlands, stoss sides of topographic highs have a relatively higher acoustic impedance (‘hard’ bed) with lower acoustic impedance (‘soft’ till) on lee sides. This pattern is similar to observations of many deglaciated terrains. Subglacial hydraulic-potential gradient and its divergence show a tendency for water to diverge over the stoss sides and converge into the lee sides. Convergence favors a thicker or more widespread water system, which can more efficiently decouple ice from the underlying till. Under such circumstances, till deformation does occur but, fluxes are relatively small. Till carried from the lee sides onto stoss sides of downstream bumps should couple to the ice more efficiently, increasing the ability for transport by till deformation. In turn, this suggests that steady-state till transport can be achieved if the stoss-side till layer is thin or discontinuous. In addition, the large basal shear stress generated in the highlands seems too high for a bed lubricated by a continuous although thin deforming till, suggesting till discontinuity, which would allow debris-laden ice to erode bedrock on stoss sides, supplying additional till for transport. 
    more » « less
  3. Abstract The Bering‐Bagley Glacier System (BBGS), Alaska, Earth's largest temperate surging glacier, surged in 2008–2013. We use numerical modeling and satellite observations to investigate how surging in a large and complex glacier system differs from surging in smaller glaciers for which our current understanding of the surge phenomenon is based. With numerical simulations of a long quiescent phase and a short surge phase in the BBGS, we show that surging is more spatiotemporally complex in larger glaciers with multiple reservoir areas forming during quiescence which interact in a cascading manner when ice accelerates during the surge phase. For each phase, we analyze the simulated elevation‐change and ice‐velocity pattern, infer information on the evolving basal drainage system through hydropotential analysis, and supplement these findings with observational data such as CryoSat‐2 digital elevation maps. During the quiescent simulation, water drainage paths become increasingly lateral and hydropotential wells form indicating an expanding storage capacity of subglacial water. These results are attributed to local bedrock topography characterized by large subglacial ridges that dam the down‐glacier flow of ice and water. In the surge simulation, we model surge evolution through Bering Glacier's trunk by imposing a basal friction representation that mimics a propagating surge wave. As the surge progresses, drainage efficiency further degrades in the active surging‐zone from its already inefficient, end‐of‐quiescence state. Results from this study improve our knowledge of surging in large and complex systems which generalizes to glacial accelerations observed in outlet glaciers of Greenland, thus reducing uncertainty in modeling sea‐level rise. 
    more » « less
  4. Blood Falls is a unique feature that appears at the snout of the Taylor Glacier in the upper Taylor Valley, East Antarctica. It is an iron-rich brine that occasionally gets expulsed from a subglacial source due to the weight and movement of the overlying glacier. The brine that emanates stains the glacier as it oxidizes at the surface and flows towards the West Lobe of Lake Bonney (WLB). Recent work (Spigelet al.2018, Lawrenceet al.2020) has shown that, besides the Blood Falls contribution, the brine enters the WLB all along the front of Taylor Glacier, creating cold water anomalies at the depth where this subglacial brine’s density is matched by the surrounding lake water. Mikuckiet al.(2015) detected substantial brine at the base of Taylor Glacier using an airborne transient electromagnetic sensor. Badgeleyet al.(2017) used radio echo sounding to delineate the brine further and to show that there are subglacial flow pathways that direct the brine to the centre and south side of Taylor Glacier’s snout, in addition to what flows from Blood Falls. 
    more » « less
  5. In this active seismic experiment we will collect AVO data at two glacier sites. One is located over a glacier bed high and the other one over a depression. The goals is to use Amplitude vs Offset methods to determine the nature of the subglacial material. A line of 24 geophones will be buried in snow to protect them from wind noise and the line will be accurately surveyed with GPS. A set of 100 shot holes will be drilled into the underlying ice to obtain a large range of offsets, so that amplitudes can be compared over large offset angles. If possible, the data will also be used to find the thickness of a subglacial till layer. The seismic experiment is part of a large geophysical and remote sensing observational program with the goal to provide input data for an ice flow model that will explore possible future scenarios for this large glacier that is very vulnerable to future climate change. In a second experiment we will do attempt to measure the extent of buried ice in the glacier foreland. For this experiment we propose to use 4.5 Hz geophones and we will use a hammer for the active source. This is part of the same NSF funded work. 
    more » « less