Conventional fast-charging methods for lithium-ion batteries (LIBs) face challenges in balancing charging speed, adverse side reactions, and battery degradation. This research introduces a novel dynamic fast-charging control approach incorporated into an age-aware battery management system. The proposed system utilizes a simplified electrochemical model and integrates closed-loop observers to detect lithium plating and solid electrolyte interphase (SEI) growth, allowing real-time updates to charging profiles depending on battery states such as the state of charge (SoC), state of health, and temperature. Experimental validation is conducted using NMC811 LIB cells arranged in a 4S9P pack configuration at ambient temperatures of 25 ∘C and 0 ∘C to meet the operational requirements of electric vertical take-off and landing (eVTOL) applications. The results indicate that the dynamic fast-charging controller achieves an 80% SoC in less than 28 min while avoiding lithium plating and excessive SEI growth, enhancing battery longevity by 25.2% and 8.8% compared to constant-current–constant-voltage (CC–CV) and multi-constant current (MCC)–CV, respectively, and reducing internal impedance growth by 45% and 15%. These enhancements ensure safe operation and consistent performance in high-power, low-temperature conditions, where traditional techniques often fail. This study highlights the feasibility of the dynamic charging technique for real-world applications, improving economic efficiency and reliability in eVTOL operations.
more »
« less
A Comparative Review of Age-Aware Fast Charging Techniques for Advanced Battery Management Systems
Despite substantial technological advancements, the widespread adoption of electric vehicles (EVs) and electric vertical take-off and landing (eVTOL) aircraft remains constrained by limited range and prolonged charging times. Reducing charging duration to approximately 15 minutes has emerged as a potential approach to mitigating range anxiety; however, increasing charging current can accelerate battery degradation, resulting in capacity loss, power fade, and safety risks. This review comparatively analyzes more than 50 studies on age-aware fast charging, with emphasis on balancing charging time and long-term battery performance. Age-aware fast-charging techniques are systematically categorized according to modeling complexity, parameterization requirements, cell chemistry, and extent of real-world validation, and their strengths and limitations are evaluated in terms of cost-benefit tradeoffs and practical feasibility. Key research gaps are identified to support the development and implementation of age-aware fast-charging strategies for EV and eVTOL applications.
more »
« less
- Award ID(s):
- 2538372
- PAR ID:
- 10711638
- Publisher / Repository:
- IEEE
- Date Published:
- Journal Name:
- IEEE Access
- ISSN:
- 2169-3536
- Page Range / eLocation ID:
- 1 to 1
- Subject(s) / Keyword(s):
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Digital twin technology has emerged as a promising approach for integrating multi-physics models in real-time to optimize the operation of electric vehicles (EVs) and electric vertical take-off and landing (eVTOLs), particularly in terms of battery performance. However, the mitigation of dynamic lithium plating and solid electrolyte interphase (SEI) growth during fast charging remains unaddressed in current studies. This paper proposes an AI-enabled digital twin that uses partial-discharge data, data from incomplete discharge cycles, for real-time battery-health estimation and couples this insight with an age-aware fast-charging controller that adaptively controls the charging current to mitigate lithium plating and SEI growth. The experimental results demonstrated the framework’s robustness across varying ambient temperatures and initial state of charge (SoC) conditions. A novel real-time estimation model within the framework achieved a root mean square error (RMSE) of less than 0.5% and 0.4% for both battery capacity and internal resistance. Additionally, the proposed framework preserved battery capacity of 87.6% at 25 ° C compared to 81.4% and 64.3% for MCC-CV and CC-CV, respectively, representing relative improvements of +7.6% and +36.2% over MCC-CV and CC-CV, respectively. This approach helped mitigate battery side reactions during fast charging, while it reduced the time required to reach 80% SoC to less than 25 min, which was 28.6% faster than MCC-CV (35 min) and 35.9% faster than CC-CV (39 min) after 200 cycles. These results support practical deployment in embedded BMS and EV/eVTOL charging to enhance safety, reduce plating risk, and extend service life.more » « less
-
We study electric vehicle (EV) fleet and charging infrastructure planning in a spatial setting. For a centrally managed fleet that serves customer requests arriving continuously at a rate [Formula: see text] throughout the day, we determine the minimum number of vehicles and chargers for a target service level along with matching and charging policies. Whereas non-EV systems require extra [Formula: see text] vehicles because of pickup times, EV systems differ. Charging increases nominal capacity, enabling pickup time reductions and allowing for an extra fleet requirement of only [Formula: see text] for [Formula: see text], depending on charging infrastructure and battery pack sizes. We propose the power-of-d dispatching policy, which achieves this performance by selecting the closest vehicle with the highest battery level from d options. We extend our results to accommodate time-varying demand patterns and discuss conditions for transitioning between EV and non-EV capacity planning. Simulations verify our scaling results, insights, and policy effectiveness. Whereas long-range, fast-charging fleets resemble non-EV systems, short-range, low-cost fleets can still perform competitively, underscoring the need for EV-aware management policies. This paper was accepted by Victor Martínez de Albéniz, operations management. Supplemental Material: The online appendix is available at https://doi.org/10.1287/mnsc.2024.08524 .more » « less
-
Range anxiety and lack of adequate access to fast charging are proving to be important impediments to electric vehicle (EV) adoption. While many techniques to fast charging EV batteries (model-based & model-free) have been developed, they have focused on a single Lithium-ion cell. Extensions to battery packs are scarce, often considering simplified architectures (e.g., series-connected) for ease of modeling. Computational considerations have also restricted fast-charging simulations to small battery packs, e.g., four cells (for both series and parallel connected cells). Hence, in this paper, we pursue a model-free approach based on reinforcement learning (RL) to fast charge a large battery pack (comprising 444 cells). Each cell is characterized by an equivalent circuit model coupled with a second-order lumped thermal model to simulate the battery behavior. After training the underlying RL, the developed model will be straightforward to implement with low computational complexity. In detail, we utilize a Proximal Policy Optimization (PPO) deep RL as the training algorithm. The RL is trained in such a way that the capacity loss due to fast charging is minimized. The pack’s highest cell surface temperature is considered an RL state, along with the pack’s state of charge. Finally, in a detailed case study, the results are compared with the constant current-constant voltage (CC-CV) approach, and the outperformance of the RL-based approach is demonstrated. Our proposed PPO model charges the battery as fast as a CC-CV with a 5C constant stage while maintaining the temperature as low as a CC-CV with a 4C constant stage.more » « less
-
The driving mileage of electric vehicles (EVs) has been substantially improved in recent years with the adoption of Ni-based layered oxide materials as the battery cathode. The average charging period of EVs is still time-consuming, compared with the short refueling time of an internal combustion engine vehicle. With the guidance from the United States Department of Energy, the charging time of refilling 60% of the battery capacity should be less than 6 min for EVs, indicating that the corresponding charging rate for the cathode materials is to be greater than 6C. However, the sluggish kinetic conditions and insufficient thermal stability of the Ni-based layered oxide materials hinder further application in fast-charging operations. Most of the recent review articles regarding Ni-based layered oxide materials as cathodes for lithium-ion batteries (LIBs) only touch degradation mechanisms under slow charging conditions. Of note, the fading mechanisms of the cathode materials for fast-charging, of which the importance abruptly increases due to the development of electric vehicles, may be significantly different from those of slow charging conditions. There are a few review articles regarding fast-charging; however, their perspectives are limited mostly to battery thermal management simulations, lacking experimental validations such as microscale structure degradations of Ni-based layered oxide cathode materials. In this review, a general and fundamental definition of fast-charging is discussed at first, and then we summarize the rate capability required in EVs and the electrochemical and kinetic properties of Ni-based layered oxide cathode materials. Next, the degradation mechanisms of LIBs leveraging Ni-based cathodes under fast-charging operation are systematically discussed from the electrode scale to the particle scale and finally the atom scale (lattice oxygen-level investigation). Then, various strategies to achieve higher rate capability, such as optimizing the synthesis process of cathode particles, fabricating single-crystalline particles, employing electrolyte additives, doping foreign ions, coating protective layers, and engineering the cathode architecture, are detailed. All these strategies need to be considered to enhance the electrochemical performance of Ni-based oxide cathode materials under fast-charging conditions.more » « less
An official website of the United States government

