%AXin, Binbin%AEkström, Erik%AShih, Yueh-Ting%AHuang, Liping%ALu, Jun%AElsukova, Anna%AZhang, Yun%AZhu, Wenkai%ABorca-Tasciuc, Theodorian%ARamanath, Ganpati%ALe Febvrier, Arnaud%APaul, Biplab%AEklund, Per%BJournal Name: Nanoscale Advances; Journal Volume: 4; Journal Issue: 16 %D2022%I %JJournal Name: Nanoscale Advances; Journal Volume: 4; Journal Issue: 16 %K %MOSTI ID: 10357436 %PMedium: X %TEngineering thermoelectric and mechanical properties by nanoporosity in calcium cobaltate films from reactions of Ca(OH) 2 /Co 3 O 4 multilayers %XControlling nanoporosity to favorably alter multiple properties in layered crystalline inorganic thin films is a challenge. Here, we demonstrate that the thermoelectric and mechanical properties of Ca 3 Co 4 O 9 films can be engineered through nanoporosity control by annealing multiple Ca(OH) 2 /Co 3 O 4 reactant bilayers with characteristic bilayer thicknesses (b t ). Our results show that doubling b t , e.g. , from 12 to 26 nm, more than triples the average pore size from ∼120 nm to ∼400 nm and increases the pore fraction from 3% to 17.1%. The higher porosity film exhibits not only a 50% higher electrical conductivity of σ ∼ 90 S cm −1 and a high Seebeck coefficient of α ∼ 135 μV K −1 , but also a thermal conductivity as low as κ ∼ 0.87 W m −1 K −1 . The nanoporous Ca 3 Co 4 O 9 films exhibit greater mechanical compliance and resilience to bending than the bulk. These results indicate that annealing reactant multilayers with controlled thicknesses is an attractive way to engineer nanoporosity and realize mechanically flexible oxide-based thermoelectric materials. %0Journal Article