Search for: All records

There are numerous applications for deep UV AlGaN Light-Emitting Diodes (LEDs) in virus inactivation, air and water purification, sterilization, bioagent detection and UV polymer curing. The long-term stability of these LEDs is also of interest for long-duration space missions such as the Laser Interferometer Space Antenna (LISA), the first gravitational wave detector in space. We review the literature on long-term aging of these devices as a function of drive current, temperature and dc versus pulsed operation. The LEDs typically show a gradual decline in output power (up to 50%) over extended operating times (>100 h) and the rate of decline is mainly driven by current and temperature. Experimentally, the degradation rate is dependent on the cube of drive current density and exponentially on temperature. The main mechanism for this decline appears to be creation/migration of point defects. Pre-screening by considering the ratio of band edge-to-midgap emission and LED ideality factor is effective in identifying populations of devices that show long lifetimes (>10,000 h), defined as output power falling to 70% of the initial value.

This paper describes a novel, to the best of our knowledge, approach to build ultrastable interferometers using commercial mirror mounts anchored in an ultralow expansion (ULE) base. These components will play a critical role in any light particle search (ALPS) and will also be included in ground testing equipment for the upcoming laser interferometer space antenna (LISA) mission. Contrary to the standard ultrastable designs where mirrors are bonded to the spacers, ruling out any later modifications and alignments, our design remains flexible and allows the alignment of optical components at all stages to be optimized and changed. Here we present the dimensional stability and angular stability of two commercial mirror mounts characterized in a cavity setup. The long-term length change in the cavity did not exceed 30 nm and the relative angular stability was within 2 µrad, which meet the requirements for ALPS. We were also able to demonstrate$1\mathrm{p}\mathrm{m}/\sqrt{\mathrm{H}\mathrm{z}}$  length noise stability, which is a critical requirement for various subsystems in LISA. These results have led us to design similar opto-mechanical structures, which will be used in ground verification to test the LISA telescope.