skip to main content


Search for: All records

Creators/Authors contains: "Ghadi, Hemant"

Note: When clicking on a Digital Object Identifier (DOI) number, you will be taken to an external site maintained by the publisher. Some full text articles may not yet be available without a charge during the embargo (administrative interval).
What is a DOI Number?

Some links on this page may take you to non-federal websites. Their policies may differ from this site.

  1. The impact of 1.8 MeV proton irradiation on metalorganic chemical vapor deposition grown (010) β-Ga2O3 Schottky diodes is presented. It is found that after a 10.8×1013cm−2 proton fluence the Schottky barrier height of (1.40±0.05 eV) and the ideality factor of (1.05±0.05) are unaffected. Capacitance–voltage extracted net ionized doping curves indicate a carrier removal rate of 268±10cm−1. The defect states responsible for the observed carrier removal are studied through a combination of deep level transient and optical spectroscopies (DLTS/DLOS) as well as lighted capacitance–voltage (LCV) measurements. The dominating effect on the defect spectrum is due to the EC-2.0 eV defect state observed in DLOS and LCV. This state accounts for ∼75% of the total trap introduction rate and is the primary source of carrier removal from proton irradiation. Of the DLTS detected states, the EC-0.72 eV state dominated but had a comparably smaller contribution to the trap introduction. These two traps have previously been correlated with acceptor-like gallium vacancy-related defects. Several other trap states at EC-0.36, EC-0.63, and EC-1.09 eV were newly detected after proton irradiation, and two pre-existing states at EC-1.2 and EC-4.4 eV showed a slight increase in concentration after irradiation, together accounting for the remainder of trap introduction. However, a pre-existing trap at EC-0.40 eV was found to be insensitive to proton irradiation and, therefore, is likely of extrinsic origin. The comprehensive defect characterization of 1.8 MeV proton irradiation damage can aid the modeling and design for a range of radiation tolerant devices.

     
    more » « less
  2. null (Ed.)