Abstract Silicate vapors play a key role in planetary evolution, especially dominating early stages of rocky planet formation through outgassed magma ocean atmospheres. Our open-source thermodynamic modeling software “VapoRock” combines the MELTS liquid model with gas-species properties from multiple thermochemistry tables. VapoRock calculates the partial pressures of 34 gaseous species in equilibrium with magmatic liquid in the system Si–Mg–Fe–Al–Ca–Na–K–Ti–Cr–O at desired temperatures and oxygen fugacities (fO2, or partial pressure of O2). Comparison with experiments shows that pressures and melt-oxide activities (which vary over many orders of magnitude) are reproduced to within a factor of ∼3, consistent with measurement uncertainties. We also benchmark the model against a wide selection of igneous rock compositions including bulk silicate Earth, predicting elemental vapor abundances that are comparable to (Na, Ca, and Al) or more realistic than (K, Si, Mg, Fe, and Ti) those of the closed-source MAGMA code (with maximum deviations by factors of 10–300 for K and Si). Vapor abundances depend critically on the activities of liquid components. The MELTS model underpinning VapoRock was calibrated and extensively tested on natural igneous liquids. In contrast, MAGMA’s liquid model assumes ideal mixtures of a limited set of chemically simplified pseudospecies, which only roughly approximates the nonideal compositional interactions typical of many-component natural silicate melts. Finally, we explore how relative abundances of SiO and SiO2provide a spectroscopically measurable proxy for oxygen fugacity in devolatilized exoplanetary atmospheres, potentially constrainingfO2in outgassed exoplanetary mantles.
more »
« less
Solubility of Rock in Steam Atmospheres of Planets
Extensive experimental studies show that all major rock-forming elements (e.g., Si, Mg, Fe, Ca, Al, Na, K) dissolve in steam to a greater or lesser extent. We use these results to compute chemical equilibrium abundances of rocky-element-bearing gases in steam atmospheres equilibrated with silicate magma oceans. Rocky elements partition into steam atmospheres as volatile hydroxide gases (e.g., Si(OH)4, Mg(OH)2, Fe(OH)2, Ni(OH)2, Al(OH)3, Ca(OH)2, NaOH, KOH) and via reaction with HF and HCl as volatile halide gases (e.g., NaCl, KCl, CaFOH, CaClOH, FAl(OH)2) in much larger amounts than expected from their vapor pressures over volatile-free solid or molten rock at high temperatures expected for steam atmospheres on the early Earth and hot rocky exoplanets. We quantitatively compute the extent of fractional vaporization by defining gas/magma distribution coefficients and show that Earth's subsolar Si/Mg ratio may be due to loss of a primordial steam atmosphere. We conclude that hot rocky exoplanets that are undergoing or have undergone escape of steam-bearing atmospheres may experience fractional vaporization and loss of Si, Mg, Fe, Ni, Al, Ca, Na, and K. This loss can modify their bulk composition, density, heat balance, and interior structure.
more »
« less
- Award ID(s):
- 1412175
- PAR ID:
- 10036394
- Date Published:
- Journal Name:
- Astrophysical journal
- Volume:
- 824
- ISSN:
- 1538-4357
- Page Range / eLocation ID:
- id 103
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
We provide estimates of atmospheric pressure and surface composition on short-period, rocky exoplanets with dayside magma pools and silicate-vapor atmospheres. Atmospheric pressure tends toward vapor-pressure equilibrium with surface magma, and magma-surface composition is set by the competing effects of fractional vaporization and surface-interior exchange. We use basic models to show how surface-interior exchange is controlled by the planet’s temperature, mass, and initial composition. We assume that mantle rock undergoes bulk melting to form the magma pool, and that winds flow radially away from the substellar point. With these assumptions, we find that: (1) atmosphere-interior exchange is fast when the planet’s bulk-silicate FeO concentration is low, and slow when the planet’s bulk-silicate FeO concentration is high; (2) magma pools are compositionally well mixed for substellar temperatures ≲2400 K, but compositionally variegated and rapidly variable for substellar temperatures ≳2400 K; (3) currents within the magma pool tend to cool the top of the solid mantle (“tectonic refrigeration”) (4) contrary to earlier work, many magma planets have time-variable surface compositions.more » « less
-
Abstract The recent JWST detections of carbon-bearing molecules in a habitable-zone sub-Neptune have opened a new era in the study of low-mass exoplanets. The sub-Neptune regime spans a wide diversity of planetary interiors and atmospheres not witnessed in the solar system, including mini-Neptunes, super-Earths, and water worlds. Recent works have investigated the possibility of gas dwarfs, with rocky interiors and thick H2-rich atmospheres, to explain aspects of the sub-Neptune population, including the radius valley. Interactions between the H2-rich envelope and a potential magma ocean may lead to observable atmospheric signatures. We report a coupled interior-atmosphere modeling framework for gas dwarfs to investigate the plausibility of magma oceans on such planets and their observable diagnostics. We find that the surface–atmosphere interactions and atmospheric composition are sensitive to a wide range of parameters, including the atmospheric and internal structure, mineral composition, volatile solubility and atmospheric chemistry. While magma oceans are typically associated with high-temperature rocky planets, we assess if such conditions may be admissible and observable for temperate sub-Neptunes. We find that a holistic modeling approach is required for this purpose and to avoid unphysical model solutions. Using our model framework, we consider the habitable-zone sub-Neptune K2-18 b as a case study and find that its observed atmospheric composition is incompatible with a magma ocean scenario. We identify key atmospheric molecular and elemental diagnostics, including the abundances of CO2, CO, NH3, and, potentially, S-bearing species. Our study also underscores the need for fundamental material properties for accurate modeling of such planets.more » « less
-
Abundances of minor and trace elements in olivine are increasingly used as petrogenetic indicators for mantle source lithologies, mantle metasomatism history, mantle potential temperatures, and magmatic differentiation. As it is common for olivine to be complexly zoned on a fine-scale, high precision analytical methods for EPMA (electron microprobe microanalyzer, or Electron Microprobe) trace element analysis under high spatial resolution have been developed. However, previous studies have focused more on analytical precision with fewer efforts in examining the accuracy of the data. In this study, we used the Cameca SXFive field emission (FE) EPMA to fully evaluate the effects of beam settings, background offsets and background regression models, and primary calibration standards on the data accuracy of 10 key petrogenetic elements (Na, Al, P, Ca, Ti, Cr, Mn, Co, Ni, and Zn) using MongOlSh11–2 olivine as a reference material. Our results indicate that high voltage, high beam current and long counting time not only improve data precision, but also improve data accuracy, especially on elements with low P/B (peak/background) ratios such as Zn and Cr. Importantly, careful background offsets and background regression models need to be obtained via high resolution WDS relative scans or step scans on each target element. Special care needs to be paid to Co element analysis to avoid or correct for peak interference of Fe Kβ. Among 10 minor and trace elements, exponential background regression models need to be applied to Al, Mn, and Ti elements, whereas other elements require linear background regression. Furthermore, to avoid Al and Zn surface contamination due to alumina polishing or brass presence, ultrasonic cleaning between each intermediate polishing steps and plasma cleaning immediately prior to EPMA experiments is highly recommended. Micro-inclusions such as chromite and spinel in olivine or adjacent Ca-rich phases need to be avoided to minimize primary or secondary fluorescence-related contamination on Al, Cr, or Ca. As a volatile element, Na element needs to be analyzed first with appropriate counting time to minimize the Na loss under high beam conditions. It needs mentioning that major elements (Mg, Fe, and Si) are best analyzed using MongOlSh11–2 or San Carlos olivine as primary standards for calibrations, which can yield more accurate data for both major elements and trace elements because of the improved matrix- corrections. Using our recommended analytical protocols, we have successfully discriminated “depleted” mantle olivine cores from an EMORB in northern East Pacific Rise (EPR) via Ca, Ti, Ni, Co, and Mn abundances. Our olivine data from Siqueiros Transform and the nearby 8◦20′ N seamounts also help reveal a metasomatized peridotite mantle beneath the northern EPR. Overall, the protocols proposed in this study can serve as a guide for accurate EPMA olivine trace element analyses, which potentially contributes to the efforts of fostering a comparable olivine database worldwide.more » « less
An official website of the United States government

