skip to main content


Title: Fracturing dams, fractured data: Empirical trends and characteristics of existing and removed dams in the United States: Fracturing Dams, Fractured Data
NSF-PAR ID:
10063544
Author(s) / Creator(s):
 ;  ;  
Publisher / Repository:
Wiley Blackwell (John Wiley & Sons)
Date Published:
Journal Name:
River Research and Applications
Volume:
34
Issue:
6
ISSN:
1535-1459
Page Range / eLocation ID:
526 to 537
Format(s):
Medium: X
Sponsoring Org:
National Science Foundation
More Like this
  1. Hydraulic fracturing can be recognized as an emerging method used in the mining of heat in Enhanced Geothermal Systems as well as in the extraction of oil and gas entrapped within shale formations. While there are several experimental studies focusing on the initiation and propagation of hydraulically-induced fractures under uniaxial and biaxial loading conditions, a very limited number of experimental studies investigate the effect of triaxial loading conditions on fracture initiation and propagation. This study describes an experimental setup, which was designed to allow one to independently apply and control three orthogonal stresses in prismatic granite specimens while simultaneously applying a hydraulic pressure inside pre-fabricated flaws. Moreover, the test setup allows one to observe and subsequently interpret the fracturing processes through visual and acoustic emission (AE) monitoring. The observations obtained in the current study using a triaxial state of stress were interpreted and compared with existing experimental studies that used other states of stress. It was observed that whitening of some grains and high-amplitude AE events occurred where visible cracks eventually developed for the triaxial state of stress investigated. Comparison with previous studies, in which only vertical loads (uniaxial) were applied, shows that the aperture of the hydraulically-induced fractures for the triaxial condition is significantly smaller than for the uniaxial loadings and that the coalescence patterns are, in general, stress-state-dependent. In terms of AE data, the total number of AE events in the specimens subject to triaxial stresses were significantly higher than in the tests using uniaxial stresses, even though most of the events (65%) had a relatively low-amplitude (<50dB) in contrast to the uniaxial tests, in which low-amplitude events were typically less than 50%. 
    more » « less