An official website of the United States government
Phosphate fertilizers may contain elevated concentrations of toxic metals and metalloids and therefore, their excessive application can result in the accumulation of both phosphorus (P) and metal(loid)s in agricultural soils. This study aims to investigate the occurrence, distribution, and potential plant-availability of metal(loid)s originating from phosphate fertilizer in a long-term experimental field at the Tidewater Research Station in North Carolina, where topsoil (10-20 cm deep) and subsoil (up to 150 cm deep) samples were collected from five plots with consistent and individually different application rates of P-fertilizer since 1966. We conducted systematic analyses of P and metal(loid)s in bulk soils, in the plant available fraction, and in four sequentially extracted soil fractions (exchangeable, reducible, oxidizable, and residual). The results show that P content in topsoils were directly associated with the rate of P-fertilizer application (=1, p<0.05). Furthermore, P concentrations were highly correlated with concentrations of Cd, U, Cr, V, and As in the bulk topsoil (>0.58, p<0.05), as well as the potential plant-available fraction (>0.67, p<0.01), indicating the accumulation of the fertilizer-derived toxic metal(loid)s in the topsoil. Significant correlations (p<0.001) of metal(loid)s concentrations between the bulk soil and the potential plant-available fraction raises the possibility that P-fertilizer application could increase the accumulation of toxic metal(loid)s in plants, which could increase human exposure. Results from sequential leaching experiments revealed that large portions of the trace elements, in particular Cd, occur in the soluble (exchangeable and reducing) fractions of topsoil with higher P-fertilizer input, whereas the levels of redox-sensitive elements (As, V, U, Cr) were higher in the reducible and oxidizable fractions of the soils. Overall, the data presented in this study demonstrate the effect of long-term P-fertilizer application on the occurrence and accumulation of a wide range of toxic metal(loid)s in agricultural topsoil.
more »
« less
Accuracy of methods for reporting inorganic element concentrations and radioactivity in oil and gas wastewaters from the Appalachian Basin, U.S. based on an inter-laboratory comparison
Accurate and precise analyses of oil and gas (O&G) wastewaters and solids ( e.g. , sediments and sludge) are important for the regulatory monitoring of O&G development and tracing potential O&G contamination in the environment. In this study, 15 laboratories participated in an inter-laboratory comparison on the chemical characterization of three O&G wastewaters from the Appalachian Basin and four solids impacted by O&G development, with the goal of evaluating the quality of data and the accuracy of measurements for various analytes of concern. Using a variety of different methods, analytes in the wastewaters with high concentrations ( i.e. , >5 mg L −1 ) were easily detectable with relatively high accuracy, often within ±10% of the most probable value (MPV). In contrast, often less than 7 of the 15 labs were able to report detectable trace metal(loid) concentrations ( i.e. , Cr, Ni, Cu, Zn, As, and Pb) with accuracies of approximately ±40%. Despite most labs using inductively coupled plasma mass spectrometry (ICP-MS) with low instrument detection capabilities for trace metal analyses, large dilution factors during sample preparation and low trace metal concentrations in the wastewaters limited the number of quantifiable determinations and likely influenced analytical accuracy. In contrast, all the labs measuring Ra in the wastewaters were able to report detectable concentrations using a variety of methods including gamma spectroscopy and wet chemical approaches following Environmental Protection Agency (EPA) standard methods. However, the reported radium activities were often greater than ±30% different to the MPV possibly due to calibration inconsistencies among labs, radon leakage, or failing to correct for self-attenuation. Reported radium activities in solid materials had less variability (±20% from MPV) but accuracy could likely be improved by using certified radium standards and accounting for self-attenuation that results from matrix interferences or a density difference between the calibration standard and the unknown sample. This inter-laboratory comparison illustrates that numerous methods can be used to measure major cation, minor cation, and anion concentrations in O&G wastewaters with relatively high accuracy while trace metal(loid) and radioactivity analyses in liquids may often be over ±20% different from the MPV.
more »
« less
- PAR ID:
- 10093914
- Date Published:
- Journal Name:
- Environmental Science: Processes & Impacts
- Volume:
- 21
- Issue:
- 2
- ISSN:
- 2050-7887
- Page Range / eLocation ID:
- 224 to 241
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
null (Ed.)High concentrations of trace metal(loid)s exported from abandoned mine wastes and acid rock drainage pose a risk to the health of aquatic ecosystems. To determine if and when the hyporheic zone mediates metal(loid) export, we investigated the relationship between streamflow, groundwater–stream connectivity, and subsurface metal(loid) concentrations in two ~1-km stream reaches within the Bonita Peak Mining District, a US Environmental Protection Agency Superfund site located near Silverton, Colorado, USA. The hyporheic zones of reaches in two streams—Mineral Creek and Cement Creek—were characterized using a combination of salt-tracer injection tests, transient-storage modeling, and geochemical sampling of the shallow streambed (<0.7 m). Based on these data, we present two conceptual models for subsurface metal(loid) behavior in the hyporheic zones, including (1) well-connected systems characterized by strong hyporheic mixing of infiltrating stream water and upwelling groundwater and (2) poorly connected systems delineated by physical barriers that limit hyporheic mixing. The comparatively large hyporheic zone and high hydraulic conductivities of Mineral Creek created a connected stream–groundwater system, where mixing of oxygen-rich stream water and metal-rich groundwater facilitated the precipitation of metal colloids in the shallow subsurface. In Cement Creek, the precipitation of iron oxides at depth (~0.4 m) created a low-hydraulic-conductivity barrier between surface water and groundwater. Cemented iron oxides were an important regulator of metal(loid) concentrations in this poorly connected stream–groundwater system due to the formation of strong redox gradients induced by a relatively small hyporheic zone and high fluid residence times. A comparison of conceptual models to stream concentration–discharge relationships exhibited a clear link between geochemical processes occurring within the hyporheic zone of the well-connected system and export of particulate Al, Cu, Fe, and Mn, while the poorly connected system did not have a notable influence on metal concentration–discharge trends. Mineral Creek is an example of a hyporheic system that serves as a natural dissolved metal(loid) sink, whereas poorly connected systems such as Cement Creek may require a combination of subsurface remediation of sediments and mitigation of upstream, iron-rich mine drainages to reduce metal export.more » « less
-
Abstract There are multiple protocols for determining total nitrogen (TN) in water, but most can be grouped into direct approaches (TN‐d) that convert N forms to nitrogen‐oxides (NOx) and combined approaches (TN‐c) that combine Kjeldahl N (organic N +NH3) and nitrite+nitrate (NO2+NO3‐N). TN concentrations from these two approaches are routinely treated as equal in studies that use data derived from multiple sources (i.e., integrated data sets) despite the distinct chemistries of the two methods. We used two integrated data sets to determine if TN‐c and TN‐d results were interchangeable. Accuracy, determined as the difference between reported concentrations and the most probable value (MPV) of reference samples, was high and similar in magnitude (within 3.5–4.5% of the MPV) for both methods, although the bias was significantly smaller at low concentrations for TN‐d. Detection limits and data flagged as below detection suggested greater sensitivity for TN‐d for one data set, while patterns from the other data set were ambiguous. TN‐c results were more variable (less precise) by many measures, although TN‐d data included a small fraction of notably inaccurate results. Precision of TN‐c was further compromised by propagated error, which may not be acknowledged or detectable in integrated data sets unless complete metadata are available and inspected. Finally, concurrent measures of TN‐c and TN‐d in lake samples were extremely similar. Overall, TN‐d tended to be slightly more accurate and precise, but similarities in accuracy and the near 1 : 1 relationship for concurrent TN‐d and TN‐c measurements support careful use of data interchangeably in analyses of heterogeneous, integrated data sets.more » « less
-
High concentrations of barium (Ba), strontium (Sr) and radium (Ra) are present in both the liquid and suspended solid portions of wastewater produced from hydraulic fracturing. These high concentrations often require special treatment in which the solid and liquid portions are separated and then independently treated prior to disposal. The solids are typically disposed in landfills while the liquids are further treated, recycled for future hydraulic fracturing, or disposed via injection wells. Finding optimal treatment methods of both the solid and the liquid fractions requires a thorough understanding of potential Ra mobility from both the raw suspended solids and mineral precipitates formed during treatment. Using a sequential extraction procedure, we found that, without treatment, more than 50% of Ra-226 in the suspended solids was associated with soluble salts and readily exchangeable fractions. When the liquid portion of the wastewater was treated by mixing with acid mine drainage (AMD), which contained high sulfate concentrations, approximately 80–97% of the total Ra-226 in the mixture solution is found in the insoluble sulfate fraction of the precipitate. The activity of Ra-226 sequestered in the precipitated solid sulfate fractions is positively correlated with the Sr/Ba ratio of the wastewater-AMD solution. We discuss implications of these findings for effective long-term management of elevated radium in both solid and liquid wastes.more » « less
-
Unconventional oil and gas residual solid wastes are generally disposed in municipal waste landfills (RCRA Subtitle D), but they contain valuable raw materials such as proppant sands. A novel process for recovering raw materials from hydraulic fracturing residual waste is presented. Specifically, a novel hydroacoustic cavitation system, combined with physical separation devices, can create a distinct stream of highly concentrated sand, and another distinct stream of clay from the residual solid waste by the dispersive energy of cavitation conjoined with ultrasonics, ozone and hydrogen peroxide. This combination cleaned the sand grains, by removing previously aggregated clays and residues from the sand surfaces. When these unit operations were followed by a hydrocyclone and spiral, the solids could be separated by particle size, yielding primarily cleaned sand in one flow stream; clays and fine particles in another; and silts in yet a third stream. Consequently, the separation of particle sizes also affected radium distribution – the sand grains had low radium activities, as lows as 0.207 Bq g −1 (5.6 pCi g −1 ). In contrast, the clays had elevated radium activities, as high as 1.85–3.7 Bq g −1 (50–100 pCi g −1 ) – and much of this radium was affiliated with organics and salts that could be separated from the clays. We propose that the reclaimed sand could be reused as hydraulic fracturing proppant. The separation of sand from silt and clay could reduce the volume and radium masses of wastes that are disposed in landfills. This could represent a significant savings to facilities handling oil and gas waste, as much as $100 000–300 000 per year. Disposing the radium-enriched salts and organics downhole will mitigate radium release to the surface. Additionally, the reclaimed sand could have market value, and this could represent as much as a third of the cost savings. Tests that employed the toxicity characteristic leaching protocol (TCLP) on these separated solids streams determined that this novel treatment diminished the risk of radium mobility for the reclaimed sand, clays or disposed material, rendering them better suited for landfilling.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.1039/C8EM00359A
