An official website of the United States government
The Ogallala Aquifer, a primary irrigation water source in the High Plains region of the United States, is declining, thereby necessitating new water conservation strategies. This paper investigates the impact of mixed wettability on the evaporation dynamics of a 10-µl sessile water droplet placed within simulated soil pores comprised of hydrophobic Teflon beads (CA ∼ 108°) and hydrophilic glass (CA ∼ 41°) beads with 2.38-mm diameters, where homogeneous and heterogenous (i.e., mixed hydrophobicity and hydrophilicity) wettability configurations were investigated. Experiments were performed in an environmental chamber where the relative humidity and temperature were 60% ± 0.1% RH and 20 ± 0.4 °C, respectively. Wettability influenced evaporation times, with homogeneous hydrophobic pores (i.e., three Teflon beads) and heterogenous one glass, two Teflon pores having the longest average evaporation times of 40 and 39 min, respectively. Homogeneous hydrophilic pores (i.e., three glass beads) and heterogenous two glass, one Teflon pores exhibited evaporation times of 34 min. Evaporation times for heterogenous combinations trended based on the predominant wettability. Contact angles and the projected length of contact were analyzed from videos to capture pinning and depinning during evaporation. For many cases including hydrophobicity, contact angles were less than 90°, and in some configurations, water would be pinned on a Teflon bead, whereas depinning (i.e., moving) on a glass bead. Stick-slip evaporation was observed, where the evaporating droplet switched between constant contact radius and constant contact area evaporative modes to minimize droplet surface energy. The results suggest wettability alterations in agricultural settings may reduce evaporation.
more »
« less
The effect of particle wettability on the stick-slip motion of the contact line
Contact line dynamics is crucial in determining the deposition patterns of evaporating colloidal droplets. Using high-speed interferometry, we directly observe the stick-slip motion of the contact line in situ and are able to resolve the instantaneous shape of the inkjet-printed, evaporating pico-liter drops containing nanoparticles of varying wettability. Integrated with post-mortem optical profilometry of the deposition patterns, the instantaneous particle volume fraction and hence the particle deposition rate can be determined. The results show that the stick-slip motion of the contact line is a strong function of the particle wettability. While the stick-slip motion is observed for nanoparticles that are less hydrophilic ( i.e. , particle contact angle θ ≈ 74° at the water–air interface), which results in a multiring deposition, a continuous receding of the contact line is observed for more hydrophilic nanoparticles ( i.e. , θ ≈ 34°), which leaves a single-ring pattern. A model is developed to predict the number of particles required to pin the contact line based on the force balance of the hydrodynamic drag, interparticle interactions, and surface tension acting on the particles near the contact line with varying particle wettability. A three-fold increase in the number of particles required for pinning is predicted when the particle wettability increases from the wetting angle of θ ≈ 74° to θ ≈ 34°. This finding explains why particles with greater wettability form a single-ring pattern and those with lower wettability form a multi-ring pattern. In addition, the particle deposition rate is found to depend on the particle wettability and vary with time.
more »
« less
- Award ID(s):
- 1705745
- PAR ID:
- 10097282
- Date Published:
- Journal Name:
- Soft Matter
- Volume:
- 14
- Issue:
- 47
- ISSN:
- 1744-683X
- Page Range / eLocation ID:
- 9599 to 9608
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
The energetics of drop deposition are considered in the capillary-ballistic regime characterized by high Reynolds number and moderate Weber number. Experiments are performed impacting water/glycol drops onto substrates with varying wettability and contact-angle hysteresis. The impacting event is decomposed into three regimes: (i) pre-impact, (ii) inertial spreading and (iii) post contact-line (CL) pinning, conveniently framed using the theory of Dussan & Davis ( J. Fluid Mech. , vol. 173, 1986, pp. 115–130). During fast-time-scale inertial spreading, the only form of dissipation is CL dissipation ( $$\mathcal {D}_{CL}$$ ). High-speed imaging is used to resolve the stick-slip dynamics of the CL with $$\mathcal {D}_{CL}$$ measured directly from experiment using the $$\Delta \alpha$$ - $$R$$ cyclic diagram of Xia & Steen ( J. Fluid Mech. , vol. 841, 2018, pp. 767–783), representing the contact-angle deviation against the CL radius. Energy loss occurs on slip legs, and this observation is used to derive a closed-form expression for the kinetic K and interfacial $$\mathcal{A}$$ post-pinning energy $$\{K+\mathcal {A}\}_p/\mathcal {A}_o$$ independent of viscosity, only depending on the rest angle $$\alpha _p$$ , equilibrium angle $$\bar {\alpha }$$ and hysteresis $$\Delta \alpha$$ , which agrees well with experimental observation over a large range of parameters, and can be used to evaluate contact-line dissipation during inertial spreading. The post-pinning energy is found to be independent of the pre-impact energy, and it is broken into modal components with corresponding energy partitioning approximately constant for low-hysteresis surfaces with fixed pinning angle $$\alpha _p$$ . During slow-time-scale post-pinning, the liquid/gas ( $lg$ ) interface is found to vibrate with the frequencies and mode shapes predicted by Bostwick & Steen ( J. Fluid Mech. , vol. 760, 2014, pp. 5–38), irrespective of the pre-impact energy. Resonant mode decay rates are determined experimentally from fast Fourier transforms of the interface dynamics.more » « less
-
Surface wettability plays an important role in heterogeneous electrocatalysis. Here we report a facile laser ablation strategy to directly modify the wettability of the silver catalyst surface and investigate its effect on oxygen reduction reaction (ORR). A broad range tuning of 2e − /4e − ORR pathways was achieved, with hydrophilic silver surfaces (contact angle ( θ w ) 31.1° ± 0.6°) showing high activity and selectivity towards 4e − reduction of oxygen to water.more » « less
-
The behavior of permeable, elastic particles sliding along a repulsive wall is examined computationally. It is found that particles will stick or slip depending on the interplay of elastohydrodynamic and repulsive forces, and the flow in the porous particle. Particles slip when either the elastohydrodynamic lift or repulsive forces are large and create a supporting lubricating film of fluid. However, for lower values of elastohydrodynamic lift or repulsive forces, the flow within the porous particle reduces the pressure in the thin film, resulting in the particles making contact and sticking to the surface. The criteria for the slip-stick transition is presented, which can be used to design systems to promote or suppress slip for such suspensions.more » « less
-
Abstract In this work, we experimentally measured the pinch‐off of a gas bubble on a biphilic surface, which consisted of an inner circular superhydrophobic region and an outer hydrophilic region. The superhydrophobic region had a radius ofRSHvarying from 2.8 to 19.0 mm, where the largeRSHmodeled an infinitely large superhydrophobic surface. We found that during the pinch‐off, the contact line had two different behaviors: for smallRSH, the contact line was fixed at the boundary of superhydrophobic and hydrophilic regions, and the contact angle gradually increased; in contrast, for largeRSH, the contact angle was fixed, and the contact line shrank toward the bubble center. Furthermore, we found that regardless of bubble size and contact line behavior, the minimum neck radius collapsed onto a single curve after proper normalizations and followed a power–law relation where the exponent was close to that for bubble pinch‐off from a nozzle. The local surface shapes near the neck were self‐similar. Our results suggest that the surface wettability has a negligible impact on the dynamics of pinch‐off, which is primarily driven by liquid inertia. Our findings improve the fundamental understanding of bubble pinch‐off on complex surfaces.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.1039/c8sm02129e
