An official website of the United States government
We describe a new version of the Chicago Water Isotope Spectrometer (ChiWIS), designed for airborne measurements of vapor-phase water isotopologues in the dry upper troposphere and lower stratosphere (UTLS) aboard research aircraft. This version of the instrument is a tunable diode laser (TDL), off-axis integrated cavity output spectrometer (OA-ICOS). The instrument was designed to measure the HDO/H2O ratio in the 2017 Asian Summer Monsoon flight aboard the M-55 Geophysica during the StratoClim campaign, and so far has also flown aboard the WB-57F in the 2021 and 2022 ACCLIP campaigns. The spectrometer scans absorption lines of both H2O and HDO near 2.647 μm wavelength in a single current sweep, and has an effective path length of 7.5 km under optimal conditions. The instrument utilizes a novel non-axially-symmetric optical component which increases the signal-to-noise ratio by a factor of 3. Ultra-polished, 4-inch diameter cavity mirrors suppress scattering losses, maximize mirror reflectivity, and yield optical fringing significantly below typical electrical noise levels. In laboratory conditions, the instrument has demonstrated a 5-second measurement precision of 3.6 ppbv and 82 pptv in H2O and HDO, respectively.
more »
« less
Evaluation of ambient ammonia measurements from a research aircraft using a closed-path QC-TILDAS operated with active continuous passivation
Abstract. A closed-path quantum-cascade tunable infrared laserdirect absorption spectrometer (QC-TILDAS) was outfitted with an inertialinlet for filter-less separation of particles and several custom-designedcomponents including an aircraft inlet, a vibration isolation mountingplate, and a system for optionally adding active continuous passivation forgas-phase measurements of ammonia (NH3) from a research aircraft. Theinstrument was then deployed on the NSF/NCAR C-130 aircraft during researchflights and test flights associated with the Western wildfire Experiment forCloud chemistry, Aerosol absorption and Nitrogen (WE-CAN) field campaign.The instrument was configured to measure large, rapid gradients in gas-phaseNH3, over a range of altitudes, in smoke (e.g., ash and particles), inthe boundary layer (e.g., during turbulence and turns), in clouds, and in ahot aircraft cabin (e.g., average aircraft cabin temperatures expected toexceed 30 ∘C during summer deployments). Important designgoals were to minimize motion sensitivity, maintain a reasonable detectionlimit, and minimize NH3 “stickiness” on sampling surfaces to maintainfast time response in flight. The observations indicate that adding ahigh-frequency vibration to the laser objective in the QC-TILDAS andmounting the QC-TILDAS on a custom-designed vibration isolation plate weresuccessful in minimizing motion sensitivity of the instrument during flight.Allan variance analyses indicate that the in-flight precision of theinstrument is 60 ppt at 1 Hz corresponding to a 3σ detection limitof 180 ppt. Zero signals span ±200, or 400 pptv total, withcabin pressure and temperature and altitude in flight. The option for activecontinuous passivation of the sample flow path with1H,1H-perfluorooctylamine, a strong perfluorinated base, preventedadsorption of both water and basic species to instrument sampling surfaces.Characterization of the time response in flight and on the ground showedthat adding passivant to a “clean” instrument system had little impact onthe time response. In contrast, passivant addition greatly improved the timeresponse when sampling surfaces became contaminated prior to a test flight.The observations further show that passivant addition can be used tomaintain a rapid response for in situ NH3 measurements over the duration of anairborne field campaign (e.g., ∼2 months) since passivantaddition also helps to prevent future buildup of water and basic species oninstrument sampling surfaces. Therefore, we recommend the use of activecontinuous passivation with closed-path NH3 instruments when rapid(>1 Hz) collection of NH3 is important for the scientificobjective of a field campaign (e.g., sampling from aircraft or anothermobile research platform). Passivant addition can be useful for maintainingoptimum operation and data collection in NH3-rich and humid environments orwhen contamination of sampling surfaces is likely, yet frequent cleaning isnot possible. Passivant addition may not be necessary for fast operation,even in polluted environments, if sampling surfaces can be cleaned when thetime response has degraded.
more »
« less
- PAR ID:
- 10136088
- Date Published:
- Journal Name:
- Atmospheric Measurement Techniques
- Volume:
- 12
- Issue:
- 7
- ISSN:
- 1867-8548
- Page Range / eLocation ID:
- 3717 to 3742
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
This dataset is derived from DataHawk2 fixed-wind uncrewed aircraft system (UAS) flights that were conducted in the central Arctic Ocean over sea ice during the Multidisciplinary drifting Observatory for the Study of Arctic Climate (MOSAiC) expedition. The data include Coordinated Universal Time (UTC), aircraft position and attitude, atmospheric thermodynamic conditions (pressure, temperature, humidity) from various sensors, approximate brightness temperature of the surface and overlying atmosphere, and estimated horizontal winds. A flight flag is included to indicate when the aircraft is in flight. All the data have been synchronized, quality controlled, and interpolated at 10 hertz (Hz). Data at their native frequency are provided in the A1 level files, and are available in the Arctic Data Center at doi:10.18739/A22Z12Q8X. The purpose of this dataset is to provide information on the thermodynamic and kinematic states of the lower atmosphere, and provide detailed observations of turbulence between the surface and one kilometer. Two flight patterns were implemented during the campaign with the DataHawk2: an orbital profile extending from the ice surface to 1000 meter(m) or cloud base if lower, and a “racetrack” pattern where the aircraft was held at a constant altitude while sampling horizontally between two circles. The latter was used to collect data on the spatial variability of thermodynamic properties over the ice surface, particularly over inhomogeneities in the surface such as leads. Displaying latitude, longitude and altitude will help users to identify the flight pattern. Thermodynamic and kinematic measurements have been validated with radiosonde-based measurements. More information on the data and methods used for synchronization and quality control can be found in de Boer, G. R. Calmer, G. Jozef, J. Cassano, J. Hamilton, D. Lawrence, S. Borenstein, A. Doddi, C. Cox, J. Schmale, A. Preußer and B. Argrow (2021): Observing the Central Arctic Atmosphere and Surface with University of Colorado Uncrewed Aircraft Systems, Nature Scientific Data, in prep.more » « less
-
The dataset is derived from HELiX Uncrewed Aircraft System flights that were conducted in the Central Arctic Ocean over sea ice during the Multidisciplinary drifting Observatory for the Study of Arctic Climate (MOSAiC) expedition. The data include Universal Coordinated Time (UTC), downwelling and upwelling shortwave radiation measurements, and position and attitude from the Uncrewed Aircraft System (UAS). Temperature, relative humidity and pressure from two different sensors are also provided. A quality control flag is associated with each scientific measurement. A flight flag is also included to indicate the different phases of the flight - on the ground, take-off/landing phases, and in flight. All the data have been synchronized and interpolated at 10 hertz (Hz). The purpose of this dataset is to provide information on albedo over different features of the sea ice (snow, melt pond, ocean). Three flight patterns were implemented during the campaign with the HELiX, a grid pattern at constant altitude (15 meters or 7 meters above ground level), hovering flights ( 2-5 minutes hovering over identified sea ice features at low altitude ~ 3 meters above ground level), and profiles up to 400 meters above ground level. Displaying latitude, longitude and altitude will help users to identify the flight pattern. Albedo measurements have been validated with surface-based measurements and details can be found in de Boer, G. R. Calmer, G. Jozef, J. Cassano, J. Hamilton, D. Lawrence, S. Borenstein, A. Doddi, C. Cox, J. Schmale, A. Preußer and B. Argrow (2021): Observing the Central Arctic Atmosphere and Surface with University of Colorado Uncrewed Aircraft Systems, Nature Scientific Data, in prep.more » « less
-
Volatile organic compounds (VOCs) range in their reaction rates with atmospheric oxidants by several orders of magnitude. Therefore, studying their atmospheric concentrations across seasons and years requires isomer resolution to fully understand their impact on oxidant budgets and secondary organic aerosol formation. An automated gas chromatograph/flame ionization detector (GC-FID) was developed for hourly sampling and analysis of C 5 –C 15 hydrocarbons at remote locations. Samples are collected on an air-cooled multibed adsorbent trap for preconcentration of hydrocarbons in the target volatility range, specifically designed to minimize dead volume and enable rapid heating and sample flushing. Instrument control uses custom electronics designed to allow flexible autonomous operation at moderate cost, with automated data transfer and processing. The instrument has been deployed for over two years with samples collected mid-canopy from the Virginia Forest Laboratory located in the Pace research forest in central Virginia. We present here the design of the instrument itself, control electronics, and calibration and data analysis approaches to facilitate the development of similar systems by the atmospheric chemistry community. Detection limits of all species are in the range of a few to tens of ppt and the instrument is suitable for detection of a wide range of biogenic, lightly oxygenated, and anthropogenic (predominantly hydrocarbon) compounds. Data from calibrations are examined to provide understanding of instrument stability and quantify uncertainty. In this work, we present challenges and recommendations for future deployments, as well as suggested adaptions to decrease required maintenance and increase instrument up-time. The presented design is particularly suitable for long-term and remote deployment campaigns where access, maintenance, and transport of materials are difficult.more » « less
-
ABSTRACT Because unmanned aircraft systems (UAS) offer new perspectives on the atmosphere, their use in atmospheric science is expanding rapidly. In support of this growth, the International Society for Atmospheric Research Using Remotely-Piloted Aircraft (ISARRA) has been developed and has convened annual meetings and “flight weeks.” The 2018 flight week, dubbed the Lower Atmospheric Profiling Studies at Elevation–A Remotely-Piloted Aircraft Team Experiment (LAPSE-RATE), involved a 1-week deployment to Colorado’s San Luis Valley. Between 14 and 20 July 2018 over 100 students, scientists, engineers, pilots, and outreach coordinators conducted an intensive field operation using unmanned aircraft and ground-based assets to develop datasets, community, and capabilities. In addition to a coordinated “Community Day” which offered a chance for groups to share their aircraft and science with the San Luis Valley community, LAPSE-RATE participants conducted nearly 1,300 research flights totaling over 250 flight hours. The measurements collected have been used to advance capabilities (instrumentation, platforms, sampling techniques, and modeling tools), conduct a detailed system intercomparison study, develop new collaborations, and foster community support for the use of UAS in atmospheric science.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.5194/amt-12-3717-2019
